Jump to content
SAU Community

Recommended Posts

either the motor drive to shut the valve is stuffed or the valve is stuck, With mine I turned the temp up & down for about a week when it did the same, works fine now and I do it every now and then just to keep it loose.

got the same problem, i thought it might b cause i havent got a aircon in mine anymore so was going to see about getting it blocked up by my mechanic but will definatley turn it up and down first to try close the vent.

if you still got the aircon then my first guess was wrong lol, if so let me know thanks.

peace

got it in my 33 aswell, and my thermostat seems to be out. I can stop air coming through it yough if you press the button which changes the way the air comes in the cabin (the butting with the bent arrow in a car, next to the A/C button) if you have it so the light is on I found it at least stopped the air from coming in.

Turn your aircon on, set it to the coldest temp, turn it off...

The vents open/close somewhere in the middle, 22 degrees is the changeover point I think...

That should fix your problem, otherwise you have a serious malfunction...

i get that all the time hot air .... u can stop it from going hot air by pressing mode and turning the temp down and then pressing OFF it then turns off and goes back to ur feet but this time its cold air...

you guys are champs!!.... i didnt know that its was automatically air comin through.... so just recirc it.... hehehe.... i was gonna say that it turns of if you dont choose that settin but...all good...cheers guys..... how low can people get there air cons/?... coz mine only goes to 18..or is that normal??

cheers

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Ok so after much research and talking with knowledgeable people I've got my turbo conversion done and it's all running great other than 1 small issue.  Car has remained auto with the na auto and tcm, I've used a stagea ecu with. NIstune board and everything is great other than my gear selection on the dash. It illuminates park, reverse, neutral, 3rd and 2nd. But nothing drive or what gear your in when you pop it into tiptronic.  I'm sure there is may e 1 wire in the ecu plug I need to move to rectify this. Dose anyone here have any ideas?   Cheers guys
    • Sorry I haven't been following all the detail, so you may have tried this. Does it idle with the tiniest bit of throttle you can add? You've mentioned the IACV, does it have an AAC valve and have you adjusted it at all (ie, screw the idle adjust screw all the way in, then back it out a couple of turns until idle is stable)?
    • My bad, I unplugged the one underlined in red instead of yellow before. With the car started, after unplugging the IACV (the one underlined in yellow), it idled at around 400/500 for 3 seconds before stalling. Attempting to start the car without the IACV will not start the car.   It does stutter and sputter for around 5 seconds before dying. However, immediately after starting it, you can already hear some slight sputters from the exhaust.   It won't start with the AFM unplugged. If it is when the car has already started, it stalls in a few seconds.   Yesterday, I did take some logs using Nistune of 3 scenarios. Car idling till it stalls Car idling and unplugging the IACV Car idling and removing the AFM I also have some previous logs of when the Car is idling till it stalls and when driving and it cuts. I am not really knowledgeable enough to understand what to look for. After every test, car idles rougher and rougher, until I have to stop. It will be fine the day after.
    • There is no difference between a 17x8 and an 18x8. The total diameter of the tyre needs to remain +/- the same (so you don't mess up the gearing, speedo reading, and clearance when turning front wheels..... so you just need to use a lower profile tyre on th 18 than you do on the 17. /rocket surgery.
    • I thought the same to start with. But then I thought it was one of those LCAs where the end of the ARB goes through a bushing in the LCA itself, instead of having an end link.
×
×
  • Create New...