Jump to content
SAU Community

Recommended Posts

Hi Everyone,

What pods should i buy for the 34 GT-R. it is standard with the exception of a full HKS exhaust and front pipe. Currently producing a 203awkw. What difference in awkw should the right pods make with the stock tune??? Thanks in advance for your advice...

Cheers...

Link to comment
https://www.sau.com.au/forums/topic/220520-r34-gtr/
Share on other sites

There are the big names like HKS, Trust, APexi and Blitz.

But a similar thread a while back and 3A Racing pods were apparently the best with air flow over the big names...

Thanks mate, will try and find the thread... appreciate your help

Link to comment
https://www.sau.com.au/forums/topic/220520-r34-gtr/#findComment-3888708
Share on other sites

204 is a bit high for a stock car

Performance increase - zero

If your current panel filter is decent and clean

Performance descrease - highly possible

I would almost expect a decrease due to the intake of hot air rather than cold air form the airbox

Snowman here runs a stock airbox, over 360rwkw. Nuff said really

Link to comment
https://www.sau.com.au/forums/topic/220520-r34-gtr/#findComment-3888729
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Yep, the closest base tune available was for the GTT, I went with that and made all the logical changes I could find to convert it to Naturally Aspirated. It will rev fine in Neutral to redline but it will be cutting nearly 50% fuel the whole way.  If I let it tune the fuel map to start with that much less fuel it wont run right and has a hard time applying corrections.  These 50% cuts are with a fuel map already about half of what the GTT tune had.  I was having a whole lot of bogging when applying any throttle but seem to have fixed that for no load situations with very aggressive transient throttle settings. I made the corrections to my injectors with data I found for them online, FBCJC100 flowing 306cc.  I'll have to look to see if I can find the Cam section. I have the Bosch 4.9 from Haltech. My manifold pressure when watching it live is always in -5.9 psi/inHg
    • Hi My Tokico BM50 Brake master cylinder has a leak from the hole between the two outlets (M10x1) for brake pipes, I have attached a photo. Can anyone tell me what that hole is and what has failed to allow brake fluid to escape from it, I have looked on line and asked questions on UK forums but can not find the answer, if anyone can enlighten me I would be most grateful.
    • It will be a software setting. I don't believe many on here ever used AEM. And they're now a discontinued product,that's really hard to find any easy answers on. If it were Link or Haltech, someone would be able to just send you a ECU file though.
    • Yes sir am asking is there possible way from aem tuner from wiring pins 
    • Have you checked cam to crank timing and confirmed balancer marks are correct?
×
×
  • Create New...