Jump to content
SAU Community

Recommended Posts

my gtr drives very well and i have just done a major service on it,

now after doing the coolant, i have noticed that sometimes when im sitting at lights or sumthing i give it a rev and the clutch fan spins loudly like it need to cool the radiator down more...

other times ill give it a rev and just a sweet rb26 rev, no fan wooooshhhh if you know what i mean,

its about 50% on and off. im pretty sure i bled the system, properly... cranked the heater and had the water level over the top of the head in a special funnel to bleed all the air, but the nipple on the top/side of the head, when i let that out, it was sucking, not spitting water out??????

it was like it was a vauucm line undun, sucking away.... whats the go

any1??

Not sure what you are talking about

Have you tried reving the motor while your looking at the cooling fan ?

maybe the hub for the cooling fan is rooted?

check the hoses for cracks or leaks

I experience the same problem too. If i sit at a traffic light for too long and then accelerate off, all i can hear is the clutch fan over the 26. It also does it after i start it up. Takes a good few minutes of driving before the noise goes away. I Would also like to know what's causing this?

Edited by quiksta

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Yes, I know🙄 but the sequential is not in my budget... don't want to reduce power neither, so looks like I'm stuck in the rabbit hole🤣
    • You’ll be very upset when you bust that too not to mention the gearing totally sucks. Don’t do it.
    • Is the panel filter one that is oiled? Have you ever cleaned or touched the AFM?
    • So.... the K&N air box thingo was too big, ended up gifting it to a mate, well, by gifting it he actually supplied food and beer at the pub,  which was nice, as it will not sit on a shelf in the garage for the next 10 years I did trim up some of the existing stuff to neaten it all up and gave it some wrinkle paint, unfortunately it currently has a used and abused mish mash of different types of hose clamps, 4 big fat T bolt type (shit), and a few normal clamps of vairing sizes and brands, but..... only until the 6 constant tension black worm clamps that I ordered from EFI solutions turn up next week Currently the current hose clamps are triggering me hard, LOL Is this the final version, probably not, I really want just 2 silicone pieces, a straight bit of silicone from the filter to the MAF is easy and will happen as soon as I head into Just Jap tomorrow, the problematic part is a 30° silicone bend from the MAF to the TB that I can connect the engine breather from the head, I found that there are bulk head fittings for boat bilge pumps that should work, but until I can get a 30° silicone bend the alloy pipe, and the 11ty thousand hose clamps, are there for the foreseeable future 4 hose clamps are golden, 6 are grudgingly acceptable, the 8 currently holding it all together is just taking the piss    I've also ordered 60 more retaining wall blocks for the front yard, I mis-gonculated the height that was required to get above the base of the Photinia's (red robin's) that are the hedge behind the front fence, currently it is 2 blocks high, and about 1/2 a block short, so going 3 blocks high will be above the base of the red robin's, and allow some room for mulch
×
×
  • Create New...