Jump to content
SAU Community

Recommended Posts

I posted up a thread not long ago as well... no one responded...

but I've recently bought a RB25DET alternator for my RB20DET with the plug as well.. I'm planning to install it this weekend...

RB20DET / 70amps

RB25DET / 80amps

RB30ET / 60amps

Edited by johnnilicte
Link to comment
https://www.sau.com.au/forums/topic/225840-altenators/#findComment-3992026
Share on other sites

The Nissan US quest minivans (same as the oldsmobile) uses a 110amp (also get 125amp), I stuck that on for my S14RB for all the added voltage load from the dual 20a radiator fans, meth, fuel pump ectr. Cost me $160us for a full recon one shipped from the US to africa,

like so:

Link

Edited by Rezlo
Link to comment
https://www.sau.com.au/forums/topic/225840-altenators/#findComment-3992708
Share on other sites

The Nissan US quest minivans (same as the oldsmobile) uses a 110amp (also get 125amp), I stuck that on for my S14RB for all the added voltage load from the dual 20a radiator fans, meth, fuel pump ectr. Cost me $160us for a full recon one shipped from the US to africa,

like so:

Link

but then you need to fabricate a bracket for it to fit.

Link to comment
https://www.sau.com.au/forums/topic/225840-altenators/#findComment-3996473
Share on other sites

  • 4 years later...

sort of related , my volts on start up are up at 15, and the battery lights on, this could be due to changing from a gtst dash to a gtr dash but even the tuner mentioned it was a bit high,

so do i need to replace the alternator and problem solved?

Link to comment
https://www.sau.com.au/forums/topic/225840-altenators/#findComment-6755341
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Latest Posts

    • I think he was only proposing to use the wire, not the sender. Simply because it runs from the right place to the right place. Personally, I wouldn't hack up the factory wiring like that. I'd just lay in the Defi loom.
    • From memory it wasn't too hard to simply see which wire ran where when you plug that in. Unfortunately also from memory the OEM sender does not use the same configuration 99.9% of gauges run. So in other words if you connect the signal wire that was running to the OEM gauge to your DEFI gauge you might find your oil reads at 200C or some other incorrect value. I remember having the same line of thought and then running new wires/senders to match the gauges I have. The pinout is available in the R34 workshop manual.
    • Does anyone on here know which wire on the GTT triple gauge pod harness is for the oil temp gauge? my sensor works fine but I upgraded the gauges to DEFI advance. And if I can simply piggyback off the oem oil temp wire to the Defi oil temp sensor wire that would make life so much easier. 
    • Even face her a wash now that’s it worth more than my house
    • This was what I was invisioning, or Pete cutting a beer can up and hose clamping it around the catch can! Ha ha ha
×
×
  • Create New...