Jump to content
SAU Community

Recommended Posts

ok i jus got a nismo chrome gearknob installed it but doesnt go all the way down to the gearboot!

i was wondering if its suppose to go all the way down?

anyone got pics?

I have a 34 and mine doesnt go all the way down either, but i guess it can be rectified putting a spacer in between the gearboot and the knob

Yeah my boot sat down too low. What i did to fix it, was to remove the boot and you'll notice the gear stick shaft is tapered (starts off thin and gets thicker). I made some of the thin bit thicker using electrical tape. That way the rubber grommet in the boot wont go down as far, and no more gap. Easy 60second fix!

hey man! i'm good how are you?

still havent installed the bov yet haha too lazy

yer starting to not mind the gap i guess i was a bit too excited waiting for it and expected to go down all the way and was disappointed when i received it

Yeah i have one which also sits too high and i was abit regretful at one stage but now i reckon it looks better that way lol
yer starting to not mind the gap i guess i was a bit too excited waiting for it and expected to go down all the way and was disappointed when i received it

Guys it can be fixed - if ya read my post not difficult at all!

p1050537si5.jpg

  • 2 months later...
Guys it can be fixed - if ya read my post not difficult at all!

p1050537si5.jpg

yea actually I have the carbon fiber version and I have to wear my momo racing gloves cecuz its hottttt.well I like to wear em anyways more comfotable

I would recommend you to put a bit of grease on the thread before you start.

The 1st nismo knob that I had, I did it too tight (trying to get it all the way down) and when it comes time to undo it, I unseated the plastic bit in the middle and I couldn't get it off, since the plastic bit would just sping around inside the knob like a screw with stripped thread. End up destroying it and had to get a new one. Other than that, they are really nice looking, although I'd prefer them to be slightly taller.

Yup... Did the trav fix a few days after this thread was started and it worked a treat! Sits 100% flush now.

although my nismo gear knob is losing its pos cheap coating and is going white... So time to look for a new one i spose

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Yeh I think i'll message an old contact i had for ages that manages his own tyre shop now.. n tell him what i want n work with him before ordering..  Got this 17x9 +30 Driftteks on 245/45/17 PSR Drag Radials on the rear.. They fit well - for your reference in future - Rear guards  have been lipped in & minimal to non flaring of the rear Gaurds.    
    • If only it were that easy! I also needed to remove seats, shocks, brake calipers, send my car through a fence, and use measuring and ended up guessing because I didn't remove seats, shocks and brake calipers. It can be hard sometimes Can be a little more complex than 'just measure' if you want to truly measure the entire wheel through all of it's suspension travel. But if you aren't going for every last mm then yeah, you can check the space you currently have and guesstimate.
    • If you own a car, and it has wheels on it, and you know the offset of those wheels, and you have a measuring device, you have everything you need to work out if other wheels will fit.
    • Will this fit? but they are staggered set - RAYS 57DR SEMI GLOSS BLACK 18x8.5 +37 | 18x9.5 +38 5-114.3 STAGGERED SET   or If no go could just get a set 4's wheels of 18x8.5 +37 5-114.3 - would i run 8.5's 235s up front n 245's at the back if I do?   Thanks.        
    • Put a clamp on your return line. I have a feeling it's sucking air, and introducing bubbles to your fuel. With a lot of fuel, less problematic. I'd honestly be redoing all the lines in the tank and clamps on everything.   Also, you've given two different answers to the same question: Asked if being followed by the police you could get down to use the whole tank, you said yes you could, so long as you keep off boost. However, you then followed this up that free revving, it would also cause the issues. I'm doubting free revving is enough to make any noticeable boost on what is likely a decent sized turbo.   So now I have to ask, can you actually drive it lightly and use all the fuel, or does it break up even free revving? Also, have you put a fuel pressure gauge on it? Can you hear the pump change noise at all when you're having this issue?
×
×
  • Create New...