Jump to content
SAU Community

Recommended Posts

Is your rear muffler straight thru? I have two mufflers - rear one has an S bend in it to help keep down noise, but have set it up so I can take off the rear one at track for less back pressure. If both are straight thru, prolly not much power advantage removing either, (but will sound heaps good) - that is if mid one is like a hot dog, apparently, if it's really big, turbulence may be removed if you take if off and there will be more power there.

yer the rear is a straight thru, i went and got a quote today on how much it would cost to replace it with a 3'' pipe and was 100 bucks, so ill most likely go thru with it, so when i take it off Zman ill let u know, not sure how much it would be for u to install it on to an existing exhaust, probs round the same as for me replacing it with a pipe...

cheers...ben.

my old system used to have a center muffler and a rear muffler, first i took of the center one cause it wasnt loud enough, that made a difference, but not enough for passangers to even notice it...

finnally i pulled of the rear muffler and replaced it with a smalish 3 inch cannon muffler, with very little baffling material (whatever its called).

Its definatly alot louder, but the problem with skylines (moreso ones with stock turbos), is that they are impossible to make loud, i got the dude at the exhaust shop to start it up with the system off and it still wasn't all that loud...

improvment in power is very minimal, maby a couple of kws?, but more than likely, you wont notice it.

I got mine done aswell, and it cost me $40 as well...$100 is a complete rip off!!!

Mine sounds sweet, a little droney between 2200rpm and about 2500 rpm, but nothing I can't deal with!

The RB series engines sound great, so in my books the louder the better. Sounds gold on full noise whilst drifting with the BOV going off all over the place.

I had the same dilemma a while ago - I had a 3" dump, 3" cat, and two straight-through 3" mufflers. I had a shop remove my centre muffler and replace it with a flaged piece of 3" pipe. Also had them make a dropped pipe, which comes out under the passenger seat and eliminates the cat too, for drags etc.

Anyway, after removing the centre muffler, my car was certainly louder and had a deeper note, but doesn't drone and has quite a nice note. With the dropped pipe on, it's not "that" loud at idle, but you can hear the turbo spool from about 1200rpm, and it sounds like a Nascar when the revs build up around 5k :P But yeah, whether it's too loud or not will depend on the muffling qualities of your remaining muffler. Mine seems to have been perfect, yours might make it too loud or too quiet. Just try it and see. Don't expect a massive power difference though.

  • 1 month later...

Interesting... I too have the 2 mufflers. My exhaust consists of:

3" Custom front/dump pipe -> 3" Cat -> 3" Nismo exhaust with a middle and rear muffler -> 4" Nismo Tip.

I'm thinking of getting this middle muffler cut out and replaced with just a 3" straight through pipe (or possibly getting it done so that i can swap between a muffler or straight through pipe, daily driving vs track/drag).

So about $40 and 30mins and it should be done eh?

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • So either way it is gearbox out and look what is wrong?  I know about the input shaft bearing. Even before swap/new clutch the it sounded exactly like this: So is that inout shaft bearing or the other was installed backwards?  And can some please tell me the part number for that input shaft bearing? The gearbox is small box from R34 N/A and number is FS5W71C. Thank you  
    • I am yet to see anyone ever regret a quaife or helical. ...other than drifting/skidpan duties. I kind of want to upgrade my factory helical with a Quaife (but really it's not ultimately that different, and is a MASSIVE UNDERTAKING), that's how good the hype is about them, that I want to try them 'just to see'  
    • D2 and Ksport are essentially the same thing and basically just generic Taiwanese manufacture. Better than ChinaBay crap, but... not top shelf. Öhlins have got to be some of the best dampers around, so likely to be a good option. It's going to get to the point though where I suggest you buy from Oz. We have at least 2x excellent options here. If I were you though, I'd be talking to KW about doing something for the R33. There's bugger all difference between that and the 32. In GTR land, anyway.
    • KW only offers a set for the R32 GTR. Popular options are D2 racing, Ksport or Öhlins. I have a D2 Racing coilover set, though I don't know for sure which one.
    • Well, the good news is you have more than one very good option for new coilovers in and around your country. Worth the drive over to KW to talk about GTR stuff.
×
×
  • Create New...