Jump to content
SAU Community

Recommended Posts

  • Replies 54
  • Created
  • Last Reply

Top Posters In This Topic

dizzee rascal - fix up look sharp

rise against - prayer for the refugee

faithless - salva mea

space boy - initial d (for the rainy days when im driftin in my pulsar )

a sont by parkway drive...it's listed as track 16 in my itunes...but it's sick. has the acoustic picking and yeh...my foot always goes down when it's on

36 crazy fists...destroy the map.

anything by RATM

aerodynamic...daft punk

pretty much any of these are garunteed i will get it the mood.

RATM

WU TANG(mainly Bobby Digital & Genius)

this'll stuff ya... most things by Pat Benetar

SUGA FREE (right now listening to 'On Point')

FUNKDOOBIEST(mainly Son Doobie)

TOOL

Flock Of Seagulls - I ran

Australian Crawl/James Reyne -boys light up is a favourite

Mondo Rock - Come said the boy... lol

Fat Joe & Big Pun

Scarface

Bone Thugs & Harmoney - Art Of War would have to be the most played album round these parts back in the day. Thug Luv *Chk Chk Boom Boom*

B B B B Bodycounts in the house!

Whu Whu whu*helicopter noise* 19NaughtyIII

that'll do.

Lovin this. Some great songs listed. and Pat Benetar ftw lol :) Love is a Battlefield!

Its My Life - Bon Jovi

Speakers Blown - Hit the Lights

Bodybag - Hit the Lights

When In Doubt - Thousand Foot Krutch

Falls Apart - Thousand Foot Krutch

My Home - Thousand Foot Krutch

Mostly Memories - Less than Jake

Take on Me - Reel Big Fish (love the original but this is a great cover)

Punk Rawk Show - MXPX

Play It Loud - MXPX

Bouncing of the Walls - Sugarcult

Shes the Blade - Sugarcult

Faces Off Camera - Rise Against

Like the Angel - Rise Against

Anyway You Want It - Rise Against (Again love the original but its a great cover)

Welcome to the Black Parade - My Chemical Romance

Taste of Ink - The Used

Paralyzed - The Used

The Bird and the Worm - The Used

Fat Bottomed Girls - Queen

Losing My Religion - REM

King for a Day - Thompson Twins

Hold Me Now - Thompson Twins

Cross the Line - Spandau Ballet

Through The Barricades - Spandau Ballet

You'll Never Walk Alone - Gerry and the Pacemakers (Probably won't apply to alot of people but I'm a scouser lol :))

Plastic Cup Politics - Less Than Jake

Thats all for now ;) Keep em coming. I'm busy downloading all the ones I didn't have before lol

You'll Never Walk Alone is good. So if you like that, consider...

Little Nash Rambler Beep Beep...

Down Under - Men At Work (used to motivate the Australia II Team when they won the America's Cup)

I've Seen That Face Before - Grace Jones (from the film called Frantic)

Simply Irresistable - Robert Palmer (dec)

Stayin' Alive - Bee Gees (no volvos intended)

That's All 4 now.

Tez

Down Under is gold lol :) of the other ones I've only heard Simply Irresistable n Stayin Alive. Ah well some more for me to dload lol.

I've Seen That Face Before - Grace Jones, is absolutely HAUNTING for a DARK NIGHT !!!

Can you imagine your partner wanting to get closer to you - whilst there's No Moon??

I usually listened to dance/prog trance stuff which really built up before I went out drifting on the track. Whilst actually driving I'd turn it down though.

As for 'cruising' tunes, I just play the shit that I usually listen to, which could be anything from Creedence Clearwater Revival to Gang Starr to Muse to Chemical Brothers or anything inbetween :)

RADAR LOVE FTW!!!

Love driving to old rock, Led Zep, Van Morrison, Pink Floyd, Janis, 'Tour of Duty' soundtracks, etc

RATM

WU TANG(mainly Bobby Digital & Genius)

this'll stuff ya... most things by Pat Benetar

SUGA FREE (right now listening to 'On Point')

FUNKDOOBIEST(mainly Son Doobie)

TOOL

Flock Of Seagulls - I ran

Australian Crawl/James Reyne -boys light up is a favourite

Mondo Rock - Come said the boy... lol

Fat Joe & Big Pun

Scarface

Bone Thugs & Harmoney - Art Of War would have to be the most played album round these parts back in the day. Thug Luv *Chk Chk Boom Boom*

B B B B Bodycounts in the house!

Whu Whu whu*helicopter noise* 19NaughtyIII

that'll do.

Some good shit there ;)

Wu Tang - most, RZA, Inspectah Deck, GZA, no point naming them all :D

Fat Joe & Big Pun, Terror Squad

Jedi Mind Tricks, AOTP, Apathy, RA The Rugged Man

Immortal Technique

Old School Hip Hop - Tim Dog, Big Daddy Kane, EPMD, Juice Crew - Master Ace, Kool G Rap & Marley Marl, NWA, Mantronix, Ghetto Boys, Fat Boys, etc etc etc

Also love Psy Trance for long trips, Simon Posford stuff, Infected Mushroom, Raja Ram, Hallucinogen, etc. Can't go wrong with Daft Punk really loud too :P

Paper Wings - Rise Against

Born to Run - Frankie Goes to Hollywood

Burn Burn - Lost Prophets

Prayer of the Refugee - Rise Against

nice choices !!!

"Know Your Enemy" - Rage Against The Machine

:D

old school ftw eh :)

Through the Fire and Flames - Dragon Force

Has the most amazing guitar solo in it. Just incredible.

oh yeah dragonforce ftmfw!!!

36 crazy fists...destroy the map.

nice !!

Mammal (if their Clear Enough soon doesnt get you pumped then there is something wrong...go out and buy the CD!!!!)

The Butterfly Effect

The Redjumpsuit Apparatus

Tool

Bullet for my Valentine

Karnivool

36 Crazyfists

Disturbed

Clutch

Chevelle

Atreyu

lots more but that will do for the moment

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • So, that is it! It is a pretty expensive process with the ATF costing 50-100 per 5 litres, and a mechanic will probably charge plenty because they don't want to do it. Still, considering how dirty my fluid was at 120,000klm I think it would be worth doing more like every 80,000 to keep the trans happy, they are very expensive to replace. The job is not that hard if you have the specialist tools so you can save a bit of money and do it yourself!
    • OK, onto filling. So I don't really have any pics, but will describe the process as best I can. The USDM workshop manual also covers it from TM-285 onwards. First, make sure the drain plug (17mm) is snug. Not too tight yet because it is coming off again. Note it does have a copper washer that you could replace or anneal (heat up with a blow torch) to seal nicely. Remove the fill plug, which has an inhex (I think it was 6mm but didn't check). Then, screw in the fill fitting, making sure it has a suitable o-ring (mine came without but I think it is meant to be supplied). It is important that you only screw it in hand tight. I didn't get a good pic of it, but the fill plug leads to a tube about 70mm long inside the transmission. This sets the factory level for fluid in the trans (above the join line for the pan!) and will take about 3l to fill. You then need to connect your fluid pump to the fitting via a hose, and pump in whatever amount of fluid you removed (maybe 3 litres, in my case 7 litres). If you put in more than 3l, it will spill out when you remove the fitting, so do quickly and with a drain pan underneath. Once you have pumped in the required amount of clean ATF, you start the engine and run it for 3 minutes to let the fluid circulate. Don't run it longer and if possible check the fluid temp is under 40oC (Ecutek shows Auto Trans Fluid temp now, or you could use an infrared temp gun on the bottom of the pan). The manual stresses the bit about fluid temperature because it expands when hot an might result in an underfil. So from here, the factory manual says to do the "spill and fill" again, and I did. That is, put an oil pan under the drain plug and undo it with a 17mm spanner, then watch your expensive fluid fall back out again, you should get about 3 litres.  Then, put the drain plug back in, pump 3 litres back in through the fill plug with the fitting and pump, disconnect the fill fitting and replace the fill plug, start the car and run for another 3 minutes (making sure the temp is still under 40oC). The manual then asks for a 3rd "spill and fill" just like above. I also did that and so had put 13l in by now.  This time they want you to keep the engine running and run the transmission through R and D (I hope the wheels are still off the ground!) for a while, and allow the trans temp to get to 40oC, then engine off. Finally, back under the car and undo the fill plug to let the overfill drain out; it will stop running when fluid is at the top of the levelling tube. According to the factory, that is job done! Post that, I reconnected the fill fitting and pumped in an extra 0.5l. AMS says 1.5l overfill is safe, but I started with less to see how it goes, I will add another 1.0 litres later if I'm still not happy with the hot shifts.
    • OK, so regardless of whether you did Step 1 - Spill Step 2 - Trans pan removal Step 3 - TCM removal we are on to the clean and refill. First, have a good look at the oil pan. While you might see dirty oil and some carbony build up (I did), what you don't want to see is any metal particles on the magnets, or sparkles in the oil (thankfully not). Give it all a good clean, particularly the magnets, and put the new gasket on if you have one (or, just cross your fingers) Replacement of the Valve body (if you removed it) is the "reverse of assembly". Thread the electrical socket back up through the trans case, hold the valve body up and put in the bolts you removed, with the correct lengths in the correct locations Torque for the bolts in 8Nm only so I hope you have that torque wrench handy (it feels really loose). Plug the output speed sensor back in and clip the wiring into the 2 clips, replace the spring clip on the TCM socket and plug it back into the car loom. For the pan, the workshop manual states the following order: Again, the torque is 8Nm only.
    • One other thing to mention from my car before we reassemble and refill. Per that earlier diagram,   There should be 2x B length (40mm) and 6x C length (54mm). So I had incorrectly removed one extra bolt, which I assume was 40mm, but even so I have 4x B and 5x C.  Either, the factory made an assembly error (very unlikely), or someone had been in there before me. I vote for the latter because the TCM part number doesn't match my build date, I suspect the TCM was changed under warranty. This indeed led to much unbolting, rebolting, checking, measuring and swearing under the car.... In the end I left out 1x B bolt and put in a 54mm M6 bolt I already had to make sure it was all correct
    • A couple of notes about the TCM. Firstly, it is integrated into the valve body. If you need to replace the TCM for any reason you are following the procedure above The seppos say these fail all the time. I haven't seen or heard of one on here or locally, but that doesn't mean it can't happen. Finally, Ecutek are now offering tuning for the 7 speed TCM. It is basically like ECU tuning in that you have to buy a license for the computer, and then known parameters can be reset. This is all very new and at the moment they are focussing on more aggressive gear holding in sports or sports+ mode, 2 gear launches for drag racing etc. It doesn't seem to affect shift speed like you can on some transmissions. Importantly for me, by having controllable shift points you can now raise the shift point as well as the ECU rev limit, together allowing it to rev a little higher when that is useful. In manual mode, my car shifts up automatically regardless of what I do which is good (because I don't have to worry about it) but bad (because I can't choose to rev a little higher when convenient).  TCMs can only be tuned from late 2016 onwards, and mine is apparently not one of those although the car build date was August 2016 (presumably a batch of ADM cars were done together, so this will probably be the situation for most ADM cars). No idea about JDM cars, and I'm looking into importing a later model valve body I can swap in. This is the top of my TCM A couple of numbers but no part number. Amayama can't find my specific car but it does say the following for Asia-RHD (interestingly, all out of stock....): So it looks like programable TCM are probably post September 2018 for "Asia RHD". When I read my part number out from Ecutek it was 31705-75X6D which did not match Amayama for my build date (Aug-2016)
×
×
  • Create New...