Jump to content
SAU Community

Recommended Posts

Hi!

There will be snow i Norway soon, so now im going to do a oilservice before i put it away for a couple of months.

My brother works at a local benz dealer, so I`ll get 50% off castrol oils.

What do you recomend i use in the gearbox and in the reardiff?

Im going to use castrol edge 0/40 in the engine.

I have seen that redline if often recomended, but i dont have an 50% discount on redline. And if im going to use it i have to order from us og england (expensive)

Link to comment
https://www.sau.com.au/forums/topic/238914-gearbox-and-reardiff-oil/
Share on other sites

Straight out of the Castrol website using their lube selector. This is for a R32 GTR btw, I don't think the 33 GTST is listed there. Faily sure they are the right ones, but you may want to call Castrol to confirm.

Engine:

CASTROL EDGE SPORT 10W-60

Gearbox

CASTROL VMX 80

Power Steering

CASTROL PS FLUID

Diff

CASTROL EPX 80W/90

4WD Transfer

CASTROL TRANSMAX Z

Edited by __PhaseShiftDown
  • 2 years later...

syntrax for gearbox and diff. GT-T with the standard viscous LSD will be fine as viscous is a sealed unit. If you have A-LSD then you need a diff oil with friction modifiers in it.

definitely go synthetic. I had motul gear 300 in my diff and after 80,000km and a couple of texi days I dropped the oil and it was still honey coloured and smelled great.

syntrax for gearbox and diff. GT-T with the standard viscous LSD will be fine as viscous is a sealed unit. If you have A-LSD then you need a diff oil with friction modifiers in it.

definitely go synthetic. I had motul gear 300 in my diff and after 80,000km and a couple of texi days I dropped the oil and it was still honey coloured and smelled great.

ok thanks but the LSD fluid is slightly thicker would that matter

ahh and also how can i tell if i got a LSD or a viscous LSD ?

  • 1 month later...

for 32R diffs, is there a difference in oil used between front and rear diff

i see CASTROL EPX 80W/90 is recommended by Castrol however other threads also recommend Castrol SAF-XA Limited Slip Rear Axle Oil - 80W-140 (apparently due to different conditions between Jap and Aus)

Hi!

There will be snow i Norway soon, so now im going to do a oilservice before i put it away for a couple of months.

My brother works at a local benz dealer, so I`ll get 50% off castrol oils.

What do you recomend i use in the gearbox and in the reardiff?

Im going to use castrol edge 0/40 in the engine.

I have seen that redline if often recomended, but i dont have an 50% discount on redline. And if im going to use it i have to order from us og england (expensive)

can you get Motul Ow 30 or say Agip 5W 30

on the topics of gear oil, I just had my GTR gearbox rebuilt with new synchros and seals. It has a OS Giken gearset in it and I am still contemplating which gear oil to use . . .

I am deciding out of Redline Shockproof Light and Royal Purple Max Gear Oil. Any recommendations on these two??

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Manual boost controllers (where a little of the boost was bled off) were quite common back in the day, because they were cheap and easy. Generally they had a manual adjustment screw rather than being fixed like yours. Down side is they always bleed boost, not just when you want them to so an electronic boost controller that uses a solenoid will have less lag.
    • Hello , im new here and i have A31 home build  RB25det neo stock eng / turbo  aem ems 2 blue connector  aem 3.5 map aem cas disk aem wideband connected to ecu  355 lph pump 550 nismo yellow injectors side feed aftermarket regulator  and won’t start with base aem tuner basic tune eventually flipped cas 180 degree so it triggers on correct stroke not in exhaust cycle  Now it won’t start Wideband reads 10 and 11 at lowest fuel setting  and will share calibrations soon for aem tuner i think something is wrong in aem tuner    please if you have any information, am very grateful         
    • Legend. I ended up finding the facebook account of the owner of the first car i sent but sadly he deactivated the account. I think you’re right in saying it’s some sort of well done custom job. Really appreciate your help anyways.
    • Totally equivalent. Stock often goes from the comp cover because that's where the actuator is also installed and the factory needs 2" of hose to make the connection - and it comes as a pre-assembled unit. They totally have a boost reference from somewhere between the turbo and the throttle(s). Oh, jeez. Just do it in M12 then. We don't actually care that much. I would expect any such AN converter fitting to rely on an o-ring or some other seal onto a flat surface under the flange of the hex**, because bolt threads are no intended to provide a pressure seal. unlike..... pipe threads. **which also requires a suitably flat and smooth surface on the turbo's boss to provide the seal.
    • I also used NP   That’s were it’s seems to be the best place to fit it? All schematic shows also that it’s should be referenced from the turbo housing. But idk, I do see high hp cars without any connection or anything to their turbos, so I really don’t know how they connect their things
×
×
  • Create New...