Jump to content
SAU Community

Recommended Posts

If it has Tommy Kaira on the car somewhere then it's mine

Spotted a black 34 in at Cooks Hill this morning parked up and a white 33 along Parkway Ave around 8 as well

Also spotted a very nice red 31 at Warners Bay . Had black mags detailed calipers etc, very nice looking car

If it has Tommy Kaira on the car somewhere then it's mine

Spotted a black 34 in at Cooks Hill this morning parked up and a white 33 along Parkway Ave around 8 as well

Also spotted a very nice red 31 at Warners Bay . Had black mags detailed calipers etc, very nice looking car

I think I may have seen ur car before out wallsend way!! Near the storage centre!! Looked Awsome...

Haha yeah that guy is on the forum here mate, its different!

OT though, spotted a white 34 with white rims and a blondie driving it over near Lambton yesterday, Also spotted a nice silver R32 cruising along Old Punt rd here in Tomago :)

Also spotted a very nice red 31 at Warners Bay . Had black mags detailed calipers etc, very nice looking car

Thank you Just picked up my car from Streamline Automotive and was taking her home

Edited by spx25t

just saw the thread in events and as long as my daughter is not born that weekend I will attend

Awesome, I wanna see it now... Bringing a mate that loves 31's... Will be lots of spotting going on :D

ive seen that blondie too,

i waved but i wasnt in mine so i think she was just creeped out, hahaha jks jks.

i saw a white gtt smashed to F*** on the weekend in hunter street >.<!!!

i see so many skylines in newcastle and none are on here!! everyone should come to the meet :D

Haha I tried that in the work van, it fails...

I just drove past the car wash in the terrace, 2 clean (pardon the pun) 32s in there... They looked slammed and then I realised they were in the dip in the wash bays :P

I spotted a black 34 with chrome rims stopped a few klms south of Wyee Creek on the F3 this arvo

Was a black car and just got a glimpse of the tail lights as I was going northbound at the time and I'm sure it was a 34

Hope it wasn't broken down or driver taken away for being bad cause cars don't last long stopped anywhere these days

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • neither stumble or cut really seem to be an appropriate term....hard to explain its like a rev limiter but at 4k, but it violently shakes engine and entire vehicle as the rpms will not rise over 4k, even with slow acceleration. as soon as it hits 4k, it sounds like entire spark is lost entirely. plugs were 1.1 which I used as such, but later put in new plugs gapped down to .8 changed back after issue arose when I replaced the coils, still does it with either plug gap...damn and it was all running so good.
    • Oh how times have changed! I actually lean it out relative to my water/methanol injector duty cycle. The methanol adds a lot of fueling and you can then lean it out even more due to reduced knock. 
    • Yeah my thoughts are the same, a well thought out WMI setup, would be slightly ahead of just straight E85 and you're also chemically intercooling the charged air, dropping it even further. This is why you need to add so much more fuel as soon as you spray. I remember someone taking me through their set up before (Dennis, has a R33, lives around Cabramatta - no idea if he's still around on this forum). He would target AFR 10:1 on 98, then as WMI ramped on, AFR would lean back up to 11:1. Amazingly, he did this all through his PowerFC, a relay to cut power to his EBC solenoid if there was not enough line pressure on his WMI kit. And of course, if there wasn't any boost made above gate pressure, you wouldn't be accessing the load cells with heaps of timing for WMI. One downside to that rudimentary setup, once the WMI came on, the EBC would unleash the dragon, and of course all the timing. Tyres would fry lol.
    • Shimmed or shimless, still solid, no hydraulic pump up stuff.
    • They have said food will be limited. Mainly meat pies and sausage rolls from memory. But they have a coffee van!
×
×
  • Create New...