Jump to content
SAU Community

Recommended Posts

I seized my HKS GT2540. Not sure how... would the oil being dirty be one option... i just thought of it. anyways when turbo siezed my powerfc had no boost running through it- so negative value... i installed a garrett 3076r the other day and drove it but havent gotten it tuned yet till a few days booked at unigroup engineering. however the powerfc low boost levels...is that normall. i would imagine after changingin all turbo lines external gate dump intake pipe etc everything that it would be back to normal boost or read the old tune level...

do u see any abnormalities....i mite just flush out n put new oil.... why wouldnt it back it normal tune ...car obvisouyl needs a tune and im not plannin to drive it but drove it back from mechanics just to get it home lol. what may the probelm be...

Edited by rx313b
Link to comment
https://www.sau.com.au/forums/topic/242655-turbo-problems/
Share on other sites

do you mean MONITOR, 1 CHANNEL, BOOST?

if it comes up as --- then the map sensor is connected, you dont have a map sensor or its disabled

you can also verify this by looking at ETC, SENSOR SW CHECK and youll see BOST

if its 0.00 or 5.00v then its not plugged in, you dont have one or its disabled

are you sure you have a map sensor installed? if its meant to be working the sensor name will be highlighted in black in ETC, SENSOR SW CHECK

Link to comment
https://www.sau.com.au/forums/topic/242655-turbo-problems/#findComment-4231538
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Yea - I mean I've seen my fuel pump which is decades old and uh, while I'm not saying this with real knowledge... but I sure get the ick at using anything in the fuel system that produced the state of that pump. Many years ago I went through multiple pumps (and strainers) before I dropped the tank to clean it out with extreme violence. I'm talking the car would do maybe 50km before coming to a halt, which resulted in me cleaning out the filter with some brake cleaner and going on my way. None of my stuff ever looked like what came out of your fuel tank. I don't think I'd be happy with it unless every single component was replaced (or at least checked/cleaned/confirmed to be clean here).
    • I'm not going to recommend an EBC pad. I don't like them. Just about anything else would suit me better. I've been using Intima pads for a while now.
    • Agreed, and in particular the earth strap that should go from the subframe to the chassis but it often broken or left off. There is a section in the R32 workshop manual you can follow for troubleshooting if you don't see anything suspicious, and depending where you are (there is no location on your user profile) you should be able to get your hands on a second hand replacement unit still if needed
    • Yeah they mention as a R34 for 2.5 Turbo...but then again thos "small" were also for R34 by that different site. But i look into it and that 310mm EBC is for R34 GTT. And by those you linked the specs are the same 🙂    EDIT: I found these on one site here: DBA 4000 series T3 DBA42304S They are 310mm...and it says are for R34GTT...are there good? EDIT2: ok they have pads too.  What "color" should i get for street use? I dont want/need some noisy ones...(and if they are not that dusty that is good too)
    • Yeah, shame. Maybe  driver's carpet is available 🙏. I am waiting for both amayama and nangun to confirm.
×
×
  • Create New...