Jump to content
SAU Community

Recommended Posts

My r33 overheated yesterday. The temp gauge didn't indicate it was overheating (usually sits halfway and it had moved just a fraction above halfway). Only knew because I parked my car and heard the freaking coolant boiling from the overflow bottle. It was so hot there was smoke from the plastic! Checked the radiator and it was bone dry... got it serviced about 700km's ago and they said my coolant doesn't need replacing... so as far as I am aware it was full not too long ago. I haven't noticed any leaks, no stains on the floor where I normally park it at home and work. Going to take it to a radiator place next week, just poured in 4L of coolant as I'm gonna limp it there. Didn't see it leaking out anywhere when pouring it in/running the engine. Going to check tomorrow if the coolant level has dropped.

I did notice though the small black fan infront of the radiator wasn't spinning... this should be spinning shouldn't it? The huge white fan behind the radiator is spinning around like a champ, just the small black one that isn't turning.

The coolant is a nice rusty brown colour btw... was like that the last time i got the coolant flushed and the radiator place said "there doesn't seem to be any rust,.the old coolant was just dirty"... safe to say I'm not taking it back there again! I seem to have a knack for owning cars that need to have something fixed every other month :D

Edited by big col
Link to comment
https://www.sau.com.au/forums/topic/242799-love-the-sound-of-boiling-coolant/
Share on other sites

this happen to my mates car, check for a small hairline leak in the pipes, it only leak under pressure hence it was hard to find what the prob was.

fill it up, run it warm and listen to where its coming out of, should be a heater or radiator pipe near the clamps.

Could be it... high boost has been real shit for the past month (think the ecu is cutting it out). runs normal on low boost.

But yeah, that black fan should be spinning right?

Black fan?

Do you mean the one at the front of the car just in front of the grill? It turns on at 60 degrees (I think), if your car set it wasn't hot and the coolant boiled, maybe the thermostat should be checked.

Very easy if you have an aftermarket ECU :)

Common causes are also, radiator slightly blocked, water pump dying/corroded, clutch fan not working correctly (small difference apparently).

And does your radiator have the stock shroud?

i thought the black electric fan come on with the air con . i had exactly the same prob last summer turns out the raditior was 70% blocked had it cleaned out and been great since

what sort of head gasket have you got in?

if none of these others are correct, the head gasket could be letting coolant bleed into the cylinders, with the engine then tries to combust... badly. this might also account for the level dropping without any leaks on the outside.

Thanks for the replies. The coolant level had gone down again this morning and there was a little puddle of fresh coolant under the car this morning so hopefully it isn't something as serious as the head gasket. I'll post the outcome after getting it checked out this week.

Easiest way to find a hairline leak is to take the car to a mechanic and get them to put there pressure tester on there.

I did it on my van when it was randomly over heating. I think they pumped about 14psi into it, soon see where the leak is.

i thought the black electric fan come on with the air con .

I can't remember if it comes on with the air con, but it does come on above 60 degrees without air con, at least on the R33's, I'm sure its very similar on other models.

Got it pressure tested today and they couldn't find any leaks. The thermostat was stuffed though (wasn't opening) so got that replaced as well as new coolant as the old stuff was shit. The car has been running 'lumpy' for quite a while now (guessing this is it trying to combust coolant) so everything is pointing to the head gasket :) Yeah i did get steam coming out of the overflow bottle. Time to dig into the lackluster cash cow! Tried checking the oil for any white stuff (water) but couldn't find any, haven't noticed any smoke coming out the exhaust either.

Whats the ballpark figure these days for a new head gasket + labour? And is there anything else I should get checked in the engine at the same time for all the labour i'll be paying?

Edited by big col

maybe a cylinder leak down test would be a better start, before you go wasting money on head gaskets and stuff, just to confirm the fault.

is the radiator cap ok? if it's not holding pressure, the coolant will pump into the expansion resevoir and boil away.

headgasket job would be close to 1k with all genuine gaskets, maching, labour etc.

Yeah naturally I'd intend to get some more tests done first to confirm it's the head gasket before diving straight in to get it replaced. The radiator cap is holding pressure, I got them to check that as the last place I went to before put a new cap on. I was expecting to hear around 2k-2.5k for a head gasket job so it will be good if it is less than that!

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • You just need to remove the compressor housing, not the entire turbo. I would not be drilling and tapping anything with the housing still on anyways. 
    • So, I put my boat on a boat. First of all, I'm going to come out and say it. Why is Tasmania not considered a holy goal, an apex that all road-legal modified cars go to, to experience? This place is an absolute wonderland of titanic proportions. If people are already getting club runs for once in a lifetime 30 person cruises to Tassy then I've never seemed to see it. It is like someone replaced the entire place with an idyllic wonderland for cars, and all of the people living there with paid actors who are kind, humble, and friendly. Dear god. After doing a lap of almost all of the place I've found that it's a great way to find out all of the little things that the car isn't doing quite right and a great way to figure it all out. All in all, I drove for 4 hours a day for a week and nothing broke. I didn't even need to open the engine bay. This is by all means a great success, but it has left me with a list of things to potentially address. I also now have a 3D printed wheel fitment tool which annoyingly hasn't got any threads in it to actually assemble it. I might be able to tape it together to check the sizing I actually want to use, but it'll likely involving pulling the shocks out to properly measure travel at least at the front, and probably raise the car while I'm at it, at least in the rear. I scraped on quite a few things and I'm not sure how else to go about it. I was taking anything with a bump at what felt like 89 degree angles. And address those 10 other tasks. And wash the car. God damn it is dirty. And somehow, the weather was perfect the entire time - And because I was on the top of Mt Wellington it turns out it was very much about to freeze up there. I did something I typically never do and took some photos up there in what must have been -10 and the foggy felt like suspended ice, rather than mere fog. If you own a car in Australia, you owe it to yourself to do it.
    • Damn that was hilarious, and a bit embarrassing for skylines in general 😂 vintage car life ey. That R33 really stomped. Pretty entertaining stuff
    • Hi, I have a r32 gtr transmission. Does any of you guys have an idea how much power it will hold with the billet center plate and stock gearset? At what power level and use did yours brake with or without billet plate? Thanks, Oystein Lovik
    • Saw this replica police car based on a Mitsubishi Starion XX parked next to a 'police box' (it's literally a box) in Hirohata, Himeji City in Hyogo prefecture the other day. It's owned by Morii-san who is a local Mitsubishi Starion enthusiast. According to a local radio station blog post, he always wanted to make a police car himself based on ones he saw in his favourite Manga comics.  As it's illegal to modify a car to look like a police car and drive on the road, Morii-san tried many times to get permission from Aboshi police station headquarters nearby. They refused initially by after they got tired of that they granted him permission. However, the car can only be displayed on private property and obviously can't be registered as long as the police livery is present. The car was completed at a cost of 1.5 million yen (US$ 10,000) in addition to the car cost. A location was chosen outside Hirohata Police box where the car can easily been seen from the street. Morii-san has two other Starion road cars, both widebody GSR-VRs.
×
×
  • Create New...