Jump to content
SAU Community

Recommended Posts

post-58479-1230356683_thumb.jpgpost-58479-1230356683_thumb.jpgFor sale is an R32 GTR 1990 model.

Specs are as follows:

Engine has been rebuilt about 1500km ago using excellent quality components.

Forged pistons 20 over

Argo rods

ACL race bearings

Nitrated crank

block was chemically cleaned and crack tested

new welsh plugs

bored and honed

cylinder head was cleaned up, surface ground, pressure tested, 24 valve seat adjustment.

cams are standard

all gaskets are new.

Have all reciepts to prove!!!!

Turbos are N1 spec garrett items

Twin 2.5in exhaust to the cat then 3in right through

Everything in the engine bay is polished, looks great.

final comp 9.1:1

Vehicle has been dyno'd at 235kw on 18psi with a final tune still to be had.

Injectors are nismo 660cc items

Fuel pump is in tank walbro 255lpm 500hp

ECU is Apexi

Interior is in very cood condition. No holes in seats etc.

Wheels are 17 in tyres are about 80% all round.

Suspension is all standard GTR.

Price is $16000

Rego till oct 2009

If you need more info call on 0414 444 522

post-58479-1230357068_thumb.jpg

post-58479-1230357214_thumb.jpg

post-58479-1230357330_thumb.jpg

post-58479-1230357484_thumb.jpg

post-58479-1230357609_thumb.jpg

post-58479-1230357726_thumb.jpg

post-58479-1230357992_thumb.jpg

post-58479-1230358100_thumb.jpg

Link to comment
https://www.sau.com.au/forums/topic/250256-r32-gtr-gunmetal-grey/
Share on other sites

so oil restrictors in the head? any oil return mods?

what brand pistons?

metal headgasket?

hows the body/paint?

any interior pics?

apexi comp asin power fc with handset?

wat boost controller?

Edited by shy_s6

Pretty sure the oil system is still standard and standard return system, i'll have to check with dominator. I think the only alteration was a slightly higher return valve spring.

Supertech forged pistons and argo rods

Head gasket is race series composite all supplied by dominator

Body is in good condition, slight ding in passengers rear quarter at the lower half near the sill panel.

Paintwork is still good.

The apexi power fc has hand controller

Boost controller is just a duel stage turbosmart item

Will post up interior pics.

Cheers

  • 2 weeks later...

Hi,Have you done any mod to the oil pump shroud? GTR32 has this weak point.Coming up to Sydney Next Monday to Thursday, would like to inspect the car.I have got 3 GRT34( 99 V-spec, 02 V-spec II. 02 V-specII NUR, and 6 GTR33 ) would like to line up a GTR32 and working on importing A GTR35 )

Would you be interested in swapping? 2000 S2 Stagea, 99 RX7 S8 , 94 Supra or even some Hiace turbo 2WD and 4WD

Alex and Tim Melb. 0439818008

Hi,Have you done any mod to the oil pump shroud? GTR32 has this weak point.Coming up to Sydney Next Monday to Thursday, would like to inspect the car.I have got 3 GRT34( 99 V-spec, 02 V-spec II. 02 V-specII NUR, and 6 GTR33 ) would like to line up a GTR32 and working on importing A GTR35 )

Would you be interested in swapping? 2000 S2 Stagea, 99 RX7 S8 , 94 Supra or even some Hiace turbo 2WD and 4WD

Alex and Tim Melb. 0439818008

:) :) :(:banana:

Hi,Have you done any mod to the oil pump shroud? GTR32 has this weak point.Coming up to Sydney Next Monday to Thursday, would like to inspect the car.I have got 3 GRT34( 99 V-spec, 02 V-spec II. 02 V-specII NUR, and 6 GTR33 ) would like to line up a GTR32 and working on importing A GTR35 )

Would you be interested in swapping? 2000 S2 Stagea, 99 RX7 S8 , 94 Supra or even some Hiace turbo 2WD and 4WD

Alex and Tim Melb. 0439818008

wat a champ start a thread and post up these bad boys

Hi,Have you done any mod to the oil pump shroud? GTR32 has this weak point.Coming up to Sydney Next Monday to Thursday, would like to inspect the car.I have got 3 GRT34( 99 V-spec, 02 V-spec II. 02 V-specII NUR, and 6 GTR33 ) would like to line up a GTR32 and working on importing A GTR35 )

Would you be interested in swapping? 2000 S2 Stagea, 99 RX7 S8 , 94 Supra or even some Hiace turbo 2WD and 4WD

Alex and Tim Melb. 0439818008

Wow!!

You a car dealership?

All the oil pump system is standard as far as i know. Pretty sure the only alteration was a slightly higher rate return valve spring.

Don't really want to swap, just need to sell the car, but thanks anyway.

You can contact me on 0414 444 522 to arrange a time.

Cheers

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • sold listed as a Tomei LSD 1.5 Way For 1998+ Nissan Skyline ER34 25GT RB25DE w/Open R200 https://www.ebay.com/itm/174006114594?campid=5338967980&mkevt=1&mkcid=1&toolid=10050&customid=&mkrid=711-53200-19255-0&loc_physical_ms=108689&loc_interest_ms=&campid=5338967980&mkevt=1&mkcid=1&toolid=10050&customid=71883f2ccc571356e0a757bc7adfdde2&mkrid=710-53481-19255-0&loc_physical_ms=108689&loc_interest_ms= it went in like butter all gears, alignment, back lash etc, rotation and clearances correct, and if rolling all rotates smooth and free when coasting down road , clutch in or out over 10 mph smooth... its the binding, clunking and jerking from a stop that is most concerning, also seems like its going to tear the tires off in 10 miles of normal road driving. 
    • What 1.5 way? There's no such thing really as a 1.5 way, just different ways of explaining 2 ways with different ramp rates. HOWEVER. In any driving in a straight line your 1.5 or 2 or 1.7 way should have no clunking at all. With the clutch fully depressed the diff should be silent (unless it's welded but I'm assuming it's not). Something aint right here.
    • Clutch is a spec brand, new clutch system,( PP, flywheel, friction disc, etc. pull type) installed 100 miles ago, with no problems.
    • looking for some help and maybe some insight on others experience with a new LSD. R34 GT ran and drove beautifully, but always alot of grip loss due to the open R200 rear end, so I just installed a new 1.5 LSD way into the stock open R200 for a ER34. Simple. Everything seemed right. I test drove for the first time this weekend. as I started to back out the garage the first time slowly with tires straight it sounded and felt like I had a loose or half disconnected drive shaft...that was clucking around loose and shaking entire vehicle, and making it feel like the trans clutch was spontaneously slipping then grabbing very roughly while just letting out pedal slowly. I backed it out went to pull forward with the same noise, shake and slip grab feeling with hesitation, I turned the tires to back out more and then pulled ahead some same thing but worst because of added wheel resistance (which that I expected) puzzled … pulling it back in checking everything over and finding nothing wrong, I tried it the next day. same thing, couldn’t believe how it shook everything again making a terrible noise and making it feel like the trans clutch was slipping and grabbing, but I got it out of garage into the driveway, got it straight, drove forward and then reveres a few times in a straight line everything shaking , causing what felt like clutch slip and grab every time, sounded like right behind front driver tire and I could feel it in the floor board with my feet,... worst right when beginning to let clutch pedal out to engage slightly, shuttering and sounding terrible along the way…I managed to slowly get down the road, babying it the whole way, once I was rolling (out of 1st) seemed to be better and between shifts, then clutch felt closer to normal…not slip/ grab etc., but back down to any stop, straight road or turning, same thing. Made no difference if all tires were straight or if I was turning. All other gauge read out correct. with in 2 miles as planned I reached the empty parking lot and performed the break in procedure that came with lsd, essentially to drive in a figure 8 a bunch.  Did this, binding chattering, and shaking the car the whole way. I drove it back home seemed somewhat normal once I was in straight line and past 10 mph or so, and I know it will “bind” on corners and cause some tires squeal when turning especially from a stop, but when I begin to move it still causes what feels like the trans clutch to slip and jerk badly as well as shaking the entire car, and sounds terrible, that I didn’t expect. I used the fluid they supplied with LSD kit and did the breaking, planning to change fluid as they suggest after breaking, but wondering will it get smoother or less aggressive with use? maybe a 1.5 is just too aggressive for normal road driving?   I have a LSD that I put in my 71 cuda when I restored it, with amazing smooth , quite yet effective results. Different style LSD but that ones a joy to drive. maybe expecting too much from this R200?
    • Join SAU NSW for a flame-grilled feed & flame-spitting cruise! Sunday 17th August 2025 3:30PM Meeting Archies Flame Grille Sylvania Waters 4:45PM Cruise Departure 5:15PM Arrival at Cape Solander Kurnell Meet Location: Archies Flame Grille Final Destination: Cape Solander Kurnell *Disclaimer* There will be a lead and follow car so no one should get lost. If you would like to attend or bring others along please put your name down and a +1 as numbers will be needed prior! This is NOT a race and we will all be adhering to all road rules. If this is what you want please come to one of our many track days. This is an official SAU:NSW event and will be run under a CAMS permit. One of the things that really sets our club apart is our commitment to being true enthusiasts. When on normal roads we strive to maintain good relations with the authorities as well as the public in general. When attending one of Skylines Australia NSW events please try to: • Be aware of surrounding environment and act accordingly. • Drive courteously on the state’s roads as a true enthusiast should. • Understand how important it is to maintain the good name of SAU NSW and thus, treat others accordingly. • Any misbehavior will not be tolerated and you will be asked to leave.
×
×
  • Create New...