Jump to content
SAU Community

Recommended Posts

Very keen on attending..

Left my license book at home :( (2000kms away, since I made it in QLD would it still be recognised in NSW), might have to shoot of some emails .. How much effort (+cost) would it take to organise a license for a friend?

Appreciate any helpful advice.

Tomek

Edited by Tomek

Hey Thomas,

CAMS license should be ok in any state.

I lost mine recently and organised a reprint to me sent in a few days. Free of charge, just give CAMS a call, and tell them you need it ASAP for an event.

Hey Thomas,

CAMS license should be ok in any state.

I lost mine recently and organised a reprint to me sent in a few days. Free of charge, just give CAMS a call, and tell them you need it ASAP for an event.

Hey Bobby, thanks for the heads up. Sent them an email this morning, will call them first thing in the morning tomorrow.

As Bobby mentioned, they're usually good like that. Tomek which day are you looking at?

Im looking at the 18th, late as possible.. Mate picked up his GTR some 2-3 weeks ago, so should be great experience for him that he should share with me (his car that is :()

Edited by Tomek
Are you looking a chance buddy?

Not sure, ill call the guys and post up :)

If not, ill be at the next one on a Sunday. Ill be pulling a couple of all nighters to get it run in the same day i get it back, then off to a dyno tune the next day

Hey Bobby, thanks for the heads up. Sent them an email this morning, will call them first thing in the morning tomorrow.

Im looking at the 18th, late as possible.. Mate picked up his GTR some 2-3 weeks ago, so should be great experience for him that he should share with me (his car that is :()

lol, what else are mates for?!

Not sure, ill call the guys and post up :)

If not, ill be at the next one on a Sunday. Ill be pulling a couple of all nighters to get it run in the same day i get it back, then off to a dyno tune the next day

lol, what else are mates for?!

Cool, I'm 15mins from there. If i'm free will come down. Wanna see the beast.

I'll bring the CAMS license as well just in case i get the itch :-)

Sunday 18th weather - Syd Max 20 degrees. Cloudy :(



  • Similar Content

  • Latest Posts

    • There's restrictor pills in the stock boost control hoses. That's how they set the amount that was bled off and hence the "high" boost setting. The usual mod in the day was to remove it and send the "high" boost setting up to about 14 psi.
    • Thanks Duncan, that's the best info I've read. Furthermore after learning about the PCM programming side controlling the factory boost solenoid, the purpose of the solenoid is to "bleed" boost when pin 25 is earthed, thus allowing spring pressure in the wastegate actuator to overcome diaphragm boost pressure, thus closing or reducing the position of the wastegate flap creating more boost as the turbo is able to spin faster. It's pretty cool to see a designated Pill to do exactly this, would have liked to have seen it with a tiny filter over the end for those moments in vacuum.  The constant bleed pill has now been removed completely from the system and solenoid boost control has been restored once again.   Case closed 😂
    • The wideband reading is meaningless if it's not running. Why are you using shitty old sidefeeds on any engine, let alone a Neo? What manifold and fuel rail are you using to achieve that? Beyond that, can't help you with AEM stuff as I've never been their ECU/CAS combo.
    • Manual boost controllers (where a little of the boost was bled off) were quite common back in the day, because they were cheap and easy. Generally they had a manual adjustment screw rather than being fixed like yours. Down side is they always bleed boost, not just when you want them to so an electronic boost controller that uses a solenoid will have less lag.
    • Hello , im new here and i have A31 home build  RB25det neo stock eng / turbo  aem ems 2 blue connector  aem 3.5 map aem cas disk aem wideband connected to ecu  355 lph pump 550 nismo yellow injectors side feed aftermarket regulator  and won’t start with base aem tuner basic tune eventually flipped cas 180 degree so it triggers on correct stroke not in exhaust cycle  Now it won’t start Wideband reads 10 and 11 at lowest fuel setting  and will share calibrations soon for aem tuner i think something is wrong in aem tuner    please if you have any information, am very grateful         
×
×
  • Create New...