Jump to content
SAU Community

Recommended Posts

took mine out on sunday, cut my hand on various screws and stuff like 6 times.

In my r32, i unscrewed the fuel line bracket just forward of the filter, then got the filter to an easily accessible place, then pulled like a MF, just came off...

try getting pliers, clench just at the end of the nozzle ( on a soft spot in the line) and lever the pliers against the fuel filter... worth a shot... : )

i just changed my fuel filter on the last service its a bitch...

put hose clamps on either side of it so u don't spray fuel everywhere (also makes the car start much sooner after you have changed the filter) then remove the engine side first (pull damn hard (don't yank it from the engine, hold the hose and the filter and pull them appart) then pull really really hard to get it off from the fuel tank side. thats the hardest....*

My advice is to not do up the hose clamps too tightly when you put the new one in, because I reckon this is what makes the hoses harder to get off next time. Just tight enough to not come loose should be enough.

when i did mine i rememberd getting one end off but the other was tight asss....so i just cut it off...haha. im very paranoid so after i put everything back together i went over the hose again with a wet rag to neutralise any petrol that leaked in case it ate into the hose or caught on fire from the engine heat. as i said im paranoid...lol the car was so responsive after that. any idea on how often the filter should be changed??

Guest RedLineGTR

depends how u run your car also...if u run it to empty then alot of the shit in the tank is more likely to get sucked up...if u leave like 1/4 or abit more in the tank before u fill up, dont chnage it too often...but its a simple thing to do, makes sure your engine gets all the fuel it needs and wants.

Originally posted by RedLineGTR

depends how u run your car also...if u run it to empty then alot of the shit in the tank is more likely to get sucked up...

No one has yet properly explained to me why this is the case. I don't buy into it personally.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • The trouble with phone apps is that they really do not know the sensitivity of the mic on each specific phone, whether there is some sort of cover or skin that can change that, etc etc. So the readings off them are not calibrated. You certainly couldn't be sure that you were even within 3 dB. I have the same app on two (actually more than that) different phones/tablets and the readings in the same room at the same time are never the same. I don't mind the apps - they are as useful as a dyno - if you're testing for delta from thing1 to thing2. But not to try to generate some sort of absolute value.
    • I'm gonna use the "Sound Meter" app from the Google Play Store and as close as I can bother to these procedures: 4. TEST METHOD FOR ALL VEHICLES EXCEPT PRE ADR83 IN-SERVICE GOODS VEHICLES AND OMNIBUSES 4.1 Microphone position 4.1.1 The microphone shall be directed towards the orifice of the exhaust outlet and shall be supported by a tripod or similar device not providing excessive acoustic reflection. The general requirements for positioning microphones are shown in the Appendix. 4.1.2 The nominal axis of maximum sensitivity of the microphone shall be substantially parallel to the test site surface and shall make an angle of 45 degrees ±10 degrees with the principal direction of gas flow from the exhaust. 4.1.3 In selecting the 45 degree alignment from the outlet of a motor vehicle fitted with two or more outlets, only the angle resulting in the microphone being farthest from any other outlet must be used. National Stationary Exhaust Noise Test Procedures for In-Service Motor Vehicles Page 3 4.1.4 The height of the microphone above the test site surface shall be equal to that of the orifice of the exhaust outlet ±25mm but shall not be less than 200mm above the test site surface. 4.1.5 The distance of the microphone from the exhaust outlet orifice shall be 500mm±25mm. 4.1.6 [Relates to vertical exhaust outlets] 4.1.7 For vehicles fitted with one exhaust outlet the microphone shall be placed so that the greatest possible distance is achieved between it and the vehicle. 4.1.8 [Relates to multi exhaust outlets] 4.1.9 [Relates to multi exhaust outlets] TLDR: 200mm off ground 45 degree angle relative to exhaust flow 500mm from tailpipe exit. (I probably won't use a tripod) Here's a photo, cause I read the instructions wrong myself.
    • No ABS, no TCS, no airbags, no cruise control, no lane departure assist, no emergency brake assist, no orange lights in the mirrors (continuously annoying me in multi-lane traffic), no stupid rear view camera. I am the one responsible for where my car goes and how it does it.
    • Cheapest Jaycar one is only $65.
    • Probably best way would be using a proper dB / SPL meter lol Buy one and ship it from state to state to have a consistent test device lololol  
×
×
  • Create New...