Jump to content
SAU Community

Recommended Posts

Well i have spent ages trying to work out why my gear box keeps spilling fluid out through the breather in the gear box. No seals are leaking, its just coming out of the breather. It didn't happen with the previous fluid that was in there only once i put the shock proof stuff in.

Once i changed it, i poured almost the full bottle in, 3.6L roughly. Since then it just has been leaking, so i ran an rubber hose to the top of the engine bay, so most of the time this is enough to stop it. It hasn't and now i'm considering changing to another type of gear box fluid as it sh*ts me to tears.

anyone had simular problems? cause its meant to be good stuff.

Anyone got/had simular problems?

Thanks in advance

Link to comment
https://www.sau.com.au/forums/topic/254077-redline-shock-proof-problem/
Share on other sites

did you fill it correctly through the filler hole and not through the shifter and guess the amount of fluid?

if it is filled correctly, i.e. correct level, running out of filler hole with the car level, then change to another fluid.

redline is over rated in my books anyway.

did you fill it correctly through the filler hole and not through the shifter and guess the amount of fluid?

if it is filled correctly, i.e. correct level, running out of filler hole with the car level, then change to another fluid.

redline is over rated in my books anyway.

Nar mate it was filled via the shifter from the cabin, but i unscrewed the bolt on the side of the gear box (filler?) and the fluid level seems ok.

I have always run smurf blood in my R33 with no issues.

I would suggest that there is too much oil in the box. Park the car on a level site and remove the filler plug on the side of the box to drain out any excess oil.

Is this a GTR or GTS-T?

The shifter goes into the transfer case on a GTR, so if you filled the transfer case youve mixed ATF and synthetic, and are running your gearbox dry.

And... I think the GTS-T's are supposed to use Redline ultra-lite weight, not the light weight. Its more like an ATF oil that is used in the R34 getrags as wel.

Is this a GTR or GTS-T?

The shifter goes into the transfer case on a GTR, so if you filled the transfer case youve mixed ATF and synthetic, and are running your gearbox dry.

And... I think the GTS-T's are supposed to use Redline ultra-lite weight, not the light weight. Its more like an ATF oil that is used in the R34 getrags as wel.

Its just a single turbo! and i done my research and everyone said its fine, plus mechanics, redline and search engine

But thanks anyways!!!

I just realised that i'm gonna try a rachet so i can adjust the angle and on the way home pick up a water pipe for extra leverage :blush:

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Mixing things up - installed some leather recaros to match the leather seat covered rear seats. Interior looks pretty schmick now except for some slight wear on the steering wheel which I will monitor and address if it becomes worse or actually noticeable!  
    • Didnt realise RB's had more then 1 head.
    • I'm normally copping my own abuse from neglecting my daily drivers. "Those suspension bushes will last a bit more", "Don't worry about the oil leak, just keep topping it up". The project cars I'm always doing things slowly on them as I'm wanting them to be done better, and neater, and nicer. Luckily I don't have to deal with 18 year old Matt's "Learning to wire" stuff in the project cars. And there's only one piece of wiring I'm displeased about in the Landcruiser, and it's about to be cut out... However, the box loads of parts that have been going through this place lately for the Landcruiser... Brake pads Brake Rotors Full handbrake overhaul Wheel Bearings Seals Swivel hubs Steering Boxes Half the suspension joints Shocks Air bags (Ones to go in the rear springs for towing) Water pump Timing kit Lower timing case Harmonic Balancer Radiator Lots of other little seals and shits Gas struts for the bonnet New power window switches And god knows what else I've forgotten... Ha ha ha I have my fingers crossed the pinion seals don't start leaking on the diffs, that the transfer case doesn't leak, and the gearbox input shaft doesn't leak, nor the rear main seal. As they're about the only seals I haven't replaced in the driveline! I'm seriously eyeing off buying new caliper rebuild kits front and rear brake calipers... I'll probably recheck all the valve clearances soon too, and hopefully, it should be all good and sweet to haul some long distance trips again!
    • Every time I pull my 3x gauges out of the console and see the crack-addict way that I did the wiring, and I just can't bring myself to tear it all apart and "make it nice", because it is currently working. In fact, the last time I was in there I probably made it worse.
    • The best part is when you own the car long enough that you look back and find your OWN ham fisted amateur shit!
×
×
  • Create New...