Jump to content
SAU Community

Recommended Posts

Fu(k these comparisons are stupid.

A fair one would be to get a v8supercar and a stock v8 SS current model. See the difference in lap times there. Then a stock GTR and a race prepped one, then see the difference.

The one with the smaller gap would clearly be the better road version of a race car.

  • Replies 52
  • Created
  • Last Reply

Top Posters In This Topic

:) ???

Well my friend they were comparing v8 super car times with gtr times, the super cars use slicks and weigh less and have 600hp or so, the gtr has less hp more weight and road tyres so if you put the v8 super cars on road tyres and had similar power I doubt they'd be 18 seconds a lap faster!

Well my friend they were comparing v8 super car times with gtr times, the super cars use slicks and weigh less and have 600hp or so, the gtr has less hp more weight and road tyres so if you put the v8 super cars on road tyres and had similar power I doubt they'd be 18 seconds a lap faster!

Here's an interesting video which compares a VYSS Commodore, A9X and V8Supercar around bathurst.

It looks like the VYSS did a 2:51 (driven by a V8SC driver) so that might give some comparison with resect to how much quicker the R35 is vs an actual commodore road car - stock for stock. About 25 seconds.

I know the comparison is a bit silly, but did anyone stop to think that this was probably the most readily available data that they had...............

True, i suppose it makes for an entertaining read anyway.

Has anyone been keeping track of the bathurst production car race this weekend? Perhas those times are better for comparison sakes. Whilst they are "production" cars they generally have a good setup, dedicated for the track. A standard R35 would easily be in front, let alone one with rubber, brakes, cage (interior gone), seats, tune, etc etc.

18 seconds is an eternity on a race track.

In that article they list the pole times for all the bathurt's races, and you'll see that even cars from the 1970's were faster than the GTR.

Keeping in mind of course that the track was slighty different back in the 70's as the chase didn't exist until the second half of the 80's.

^^^touche

the GTR still fails as a race car in standard trim, and there aren't many cars out there that are ready from the factory for racing, so i still think it's pretty impressive.

What's not impressive is the weight of it, and it is unexcusable for it to weigh that much.

  • 2 weeks later...
It's because it's so much more expensive than anything else that Nissan sells, but when compared to it's competition (which it beats), it's a bargain

No its much more expensive than anything else Nissan sells IN AUSTRALIA. Pretty sure the R34 GTR wasn't too far off that figure at one stage...

Most aussies when they think of nissan, think of the Tiida, pulsar, and maxima, and maybe a handful of 4wd's, so you can hardly blame them for associating nissan with relatively cheap cars for the average consumer. But what they dont see is the performance car heritage Nissan has - which is well known in Japan, but not many other places.

As for the comparison, the GTR is a factory road car, not a race car. I thought it came pretty damn close in cornering speed on most corners, and was even faster on one of the corners (was that correct?).

I think a race-spec GTR would find the extra 18seconds and then some, pretty easily.

The V8 supercars are pretty much just a shell, and completely custom - almost nothing about them has any resemblance to the road cars. So with this in mind a race-spec GTR would be much lighter, more powerful, and have better brakes and suspension setups. Its not difficult to imagine record-breaking times from a race-spec GTR.

However, I doubt we'll see the day...maybe an unofficial lap time perhaps, but not an official race one.

Those who complain about the weight - why? Its a road car - its already extremely quick...why sacrifice anything that it has when all you'd gain is more speed/handling? - and it performs brilliant in these categories already.

I reckon if the weight isn't hurting it, then its fine. Its a road car primarily. Any race versions would undoubtedly be much lighter...

Some of you guys should get out on a racetrack, or get out at Bathurst on a no speed limit event. A 2:25 is honking around there, for a STOCK road car.

The fastest Carerra Cup cars were running 2:20s at the Drive Bathurst event, and the quickest time that won the Supersprint was a 2:26 on the final day which was a R33 running in 2WD. None of those cars were even remotely close to standard.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Even more fun, leave all the ADAS stuff plugged in, but in different locations, hopefully avoid any codes!   And honestly, all these new cars with their weird electronics. Pull all the electronics out Duncan, and just shove an aftermarket ECU and if needed a trans controller in, along with a PDM. Make it run basic but race car styled!
    • To follow up a question from earlier too since I had the front bar off again (fking!) This is what is between the bumper and the drivers side wheel And this is the navigator side, only one thing but its a biggy! So basically....no putting coolers in the wheel arches without a lot of moving other stuff. Assuming I move to properly race prepping this car I'll take that job on and see how the computers respond to removing a whole bunch of ADAS modules
    • So I prepped the car for another track day on Wednesday (will be interesting to see coolant temps post flushing out and the larger reservoir, with a forecast of 3-14 being 20o cooler than last time I took it out). Couple of things to mention; since I am just driving the car and not taking a support vehicle, I took the rear seats out and just loaded the back up Team Trackday style. Look at all that space! To cover off removing the rear seat....it is weird (note the hybrid is probably different because it wouldn't have folding rear seats) Basically, you remove the lower seat base, very similar to a r series but it is a clip that pulls forward to release the base rather than it being bolted down. Easy Then, you need to remove the side section of the rear seat on each side. There is a 14mm head nut at the bottom of the side piece, the it slides upwards off a hook at the top to release; you also need to unhook the seatbelt from the loop at the top. Then the centre piece is weird. You need to release/fold the seats forward with the tab in the boot on each side From there, there are 2,x12mm headed bolts holding the rear of each seat to the folding bracket, under the trim between the rear seat and the boot (4x christmas tree clips there, they suck). The seat is out but you can see where the bolts attach to the bracket
    • As discussed in the previous post, the bushes in the 110 needed replacing. I took this opportunity to replace the castor bushes, the front lower control arm, lower the car and get the alignment dialled in with new tyres. I took it down to Alignment Motorsports on the GC to get this work done and also get more out of the Shockworks as I felt like I wasn't getting the full use out of them.  To cut a very long story short, it ended up being the case the passenger side castor arm wouldn't accept the brand new bush as the sleeve had worn badly enough to the point you could push the new bush in by hand and completely through. Trying a pair of TRD bushes didn't fix the issue either (I had originally gone with Hardrace bushes). We needed to urgently source another castor arm, and thankfully this was sourced and the guys at the shop worked on my car until 7pm on a Saturday to get everything done. The car rides a lot nicer now with the suspension dialled in properly. Lowered the car a little as well to suit the lower profile front tyres, and just bring the car down generally. Eternally thankful for the guys down at the shop to get the car sorted, we both pulled big favours from our contacts to get it done on the Saturday.  Also plugged in the new Stedi foglights into the S15, and even from a quick test in the garage I'm keen to see how they look out on the road. I had some concerns about the length of the LED body and whether it'd fit in the foglight housing but it's fine.  I've got a small window coming up next month where I'll likely get a little paint work done on the 110 to remove the rear wing, add a boot wing and roof wing, get the side skirt fixed up and colour match the little panel on the tail lights so that I can install some badges that I've kept in storage. I'm also tempted to put in a new pair of headlights on the 110.  Until then, here's some more pictures from Easter this year. 
    • I would put a fuel pressure gauge between the filter and the fuel rail, see if it's maintaining good fuel pressure at idle going up to the point when it stalls. Do you see any strange behavior in commanded fuel leading up to the point when it stalls? You might have to start going through the service manual and doing a long list of sensor tests if it's not the fuel system for whatever reason.
×
×
  • Create New...