Jump to content
SAU Community

Recommended Posts

Got some more parts for sale as I now have a series 2 stag and don't need some of the parts from my old S1.

Full set of carbon fibre dash trims (carbon fibre look)

which include-

-instrument cluster with 118xxxkms

-center dash vent surround

-radio surround

-front cup holders

-ashtray

-console piece

-gear shifter lever

-all door switches

post-34938-1239102128_thumb.jpg

Asking $500 for whole set as are very hard to come by.

Second for sale is half of my old exhaust, basically cat back but comes with cat.

In good condition, good note, not too droney.

post-34938-1239102401_thumb.jpg

$400

Also have two full sets of tail lights, series 1 and 2

Series 1 set $200

Series 2 set $300

Both in good condition.

can supply photo's but I'm sure you all know what they look like.

Any questions feel free to askand can post upmore pics on request.

All parts located north of Adelaide near Gawler.

Cheers, Jarrad.

Link to comment
https://www.sau.com.au/forums/topic/264612-more-goodies-for-sale/
Share on other sites

  • 2 weeks later...

more parts for sale.

Full set of bilstein struts and nismo springs.

Used condition, unkown km's as was on car when imported.

Sat at nice low height and good firm ride, guard level with top of tyre.

post-34938-1240218337_thumb.jpg

$400 for set.

Also more pics of carbon fibre parts.

Door switches.

post-34938-1240218613_thumb.jpg

would like to sell carbon fibre parts as full set but may seperate.

here's a pic of when the suspension was in the car.

post-34938-1241008536_thumb.jpg

At which point are you geting 100mm from?

Will fit series 1 and 2, as it came out of series 2 and i put my series 1 suspension in it.

100ml is legal limit in vic ..

looks nice man, if there still here next week, i doubt it, i'll send through a pm

No probs mate.

It should sit within the heights but it sat too low with the front bar i have on so i swapped the suspension.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Put a fuel pressure gauge on it. Replace the turbos. Probably completely separate issues.
    • What copper washer do you guys use on the bleeder bolts? The existing one I have I had no idea where to find it in a local store, I did buy some online but that are only 1mm thick whereas my old one is 2mm+ thick and when I put the new washer out and squeeze the top radiator hose I can hear a bit of air but not with the old one. Does this matter? The new one doesn't leak, but the inner diameter is a bit loose whereas the old one threads on the bolt.
    • Howdy all, after being out a few weeks ago on a spirited drive in my GTR I have 2 issues that oddly have appeared at the same time. Whilst accelerating quickly through the gears all of a sudden i’ve lost power at the top of third gear (below redline around 6000rpm) for no obvious reason.    From that point onwards the car has been running rich on idle, won’t really rev under load without a ton of black smoke and the odd backfire, and dying as a pull up to a set of lights unless I keep the revs up around 1500rpm. In addition when shutting down the car that same night (I was 10 minutes from home) I noticed one of the turbos was significantly noisy on wind down when shutting off the engine. After letting the car cool down overnight it starts up fine, although once it gets to temp the revs start to creep up and down, the exhaust is darker than it should be and it also sounds like it’s running rich (fat note) I’ve put a new set of plugs in it - no change, the old plugs all seemed OK with two of them being somewhat richer/fueled up than the other 3 with 1 being borderline. I’ve smoked tested the intake system via the front of the Turbos, found a split vacuum hose going to the factory boost gauge sender, which I have since replaced.  Also found another leak on the gasket coming off the rear turbo outlet, have also replaced this. After fixing both of these leaks - still have the running rich issue. I’ve also tried another pair of AFM’s - no change here After pulling off the front turbo intake pipes, there is obvious shaft play in the front turbo, which now hisses loudly on light revvs although I can’t see why this would make the car run funny even under idle. I’m curious to know why it’s running rich before I potentially replace/rebuild turbos. The car is completely stock <50,000kms  other than an exhaust. Oil and coolant are all clear. I haven’t bothered with coil packs as it looks like they won’t be the issue due to condition of the plugs. Any help appreciated as I cry myself to sleep!
    • No probs at all. I used to love trying to dig up obscure info for those in need where possible going back 20+ years on SAU.  I did have another look and couldn't come up with any closer match. I'm leaning towards those skirts in your first pic are custom fitments, cut down/extended or from another car entirely and modded to fit an R34 sedan. I would've thought someone in Japan had them and taken a photo at some stage over the last 2 decades but there's nothing. Someone out there must know surely.
×
×
  • Create New...