Jump to content
SAU Community

Recommended Posts

  • Replies 184
  • Created
  • Last Reply

Top Posters In This Topic

OoooO Friday! might be able to come down if im feeling better (bit sick atm) i was just thinking the other dday that place would be a good place to have a meet cause i park around there sometimes for tafe,

see you guys there hopefully

Haha awesome Ant, i'll see how things pan out..thanks for the offer

:P

Hey guyz just wanted to know is this a members only event? Or can a non member also come?

As this is a non official event, everyone is more than welcome to attend :cool:

hamish dont be a baby and come lol

yeah i wish... so what if the chef from this place you are gong to took the friday night off...

its a shit shit shit shit shit industry :banana:

yeah i wish... so what if the chef from this place you are gong to took the friday night off...

its a shit shit shit shit shit industry :happy:

how many more motorbikes have been hit by cars coming outta that deadly side street its next to? :P

ah well. im sure you'll be bale to make the next one :)

should post on south east imports forum/ nissan silvia/ beastclub n whatever else =]

make it a big one

:P

Not sure about NS... but feel free to put it on SEI for sure. There's no wankers on there :happy:

the only place im going to post SAU cruises planned are on SAU. if people are on the forums and interested they may attend. i don't plan for anyone to be doing any bad behavoiur on the night :P

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • The final part arrived today to un-clampify and simplify the intake Who would have though a 1/2" hose stainless bulkhead fitting designed for below waterline bilge pumps would be what I needed Test fit on a 3" offcut I had laying around to see if it would work, and it worked a treat All going well the intake will be on its "final version" tomorrow 
    • Good luck on the weekend mate
    • Must have been an absolute nightmare to drive when the power steer was out, the rack ratio/wheel size/caster is all set up for power assistance
    • Welcome to SAU, what are you looking at buying?
    • I checked the injectors again (1 and 2, since they’re easiest to access) to make sure they weren’t clogged. Even though the entire fuel system had been cleaned, I wanted to be certain. Everything looked clean, so I reinstalled and connected everything. When I started the car to confirm everything was okay, it immediately revved up high, so I shut it off straight away. I checked to see if I’d missed a vacuum hose or something, but everything was connected. On the second attempt, the car ran without the high idle, but I noticed a distinct “compressed air” sound coming from the engine bay. Tracing the sound, I pushed injector #6 forward slightly and the noise stopped — it turned out it wasn’t seated properly, despite the fuel rail being bolted down. While holding it in place, the car idled steadily without stalling and ran for over 5 minutes. At this point, I pulled all six injectors out just in case I hadn’t seated them correctly or dirt had gotten onto the O-rings. Unfortunately, I discovered that I had damaged 3 out of 6 injectors (the OEM 270cc ones) during installation. So yes, this was my fault. Since only the pintle caps were damaged, I’ve ordered a Fuel Injector Service Kit from NZEFI to refurbish them. In the meantime, I reinstalled my new injectors – the car now idles fine for over 15 minutes without stalling. I have not attempted to drive it so far. It’s not perfect yet, as it hesitates when the throttle is pressed, but it’s a big improvement. Unplugging the IACV with the new injectors idles at around 800rpm, even with the IACV screw tightened fully. But this is probably due to tune.
×
×
  • Create New...