Jump to content
SAU Community

Recommended Posts

Hey Everyone,

this is my first post and its not the best one

i was driving home at 2am in da morning and i turned a 90degree corner at 60kph downhill in the wet. my car lost control and i hit the gutter at bout 55kph, my front left wheel is bent ( / - like that)

and my rear left is ( - like that) and im not exagerating

im suprised my 4 wheel drive didnt save the accident.

newayz ive gotta get it fixed , ive sent it to the mechanic n he said its the wishbone, sway bars ????????

has neone eva done this before, either the same accident or can give me an idea on what the damage is ???? plz plz plz

ive spent the last 2days crying and it was my bday yesterday (some bday present) ill be grateful for any advice u'z can gimme.

thankyou

Link to comment
https://www.sau.com.au/forums/topic/26940-1997-r33-gts4-crash/
Share on other sites

Advice?

Like slow down? Like that 4-wheel drive won't prevent you losing traction? It's good but not the duck's nuts. It sounds like you need to get some more experience learning the car before you go out and imitate Skaifey. Harsh but the truth.

Try an advanced driver's course or skid-pan day. Invaluable knowledge will be gained by you...

As for repairs, you could be up for a coupla grand (at absolute most, incl towing fees) to correct it all. Swaybar is cheap but to fix a wishbone you'll need to dismantle a fair bit in the front end. Losta labour there bubba. You might also need to get a chassis engineer to check you haven't bent/twisted the chassis. If you did, you could be looking at a write-off...

Looks like you've lost a control arm or something, probably bent a tie rod.

If you are lucky on the damage, and source parts yourself, may be looking at a repair bill under $1000. Suspension, steering stuff always looks really bad as you can't drive the car, but often it can be repaired with not too much difficulty as long as there is no major structural damage. So have hope!

p.s. do some controlled sliding, its invaluable in learning how to control a car when it happens when you *don't* expect it.

i dont think he really needs the "slow down advice" i think he knows that now. Is bad to crash but does add to experience. A lot of people that HAVENT crashed in the wet dont actually realise how little traction there is, (like myself when i wrote off my first car in the wet) so its expensive but a great lesson to learn earlier on rather than later.

happened to a mate, but not a gts4, gtst. parts were around 1500, not including replacing the rims!. As said its the labour that will sting. Mate was able to do all the labour himself, apart from some lower sill damage which required panel beating. Your lucky the body's ok!

I also think your up for at least $1500 + Body repairs? + Rims if needed?

No flaming from me, I learnt my lesson the hard way in the wet, and now respect the car allot more for it.

I'm sure you wont make the same leadfooted mistake again.

Being a GTS4 it may be harder to find parts?

If your having problems finding parts try http://www.partslocator.com.au/

Originally posted by Johnny

Hey Everyone,  

this is my first post and its not the best one

i was driving home at 2am in da morning and i turned a 90degree corner at 60kph downhill in the wet. my car lost control and i hit the gutter at bout 55kph, my front left wheel is bent ( / - like that)

and my rear left is (  - like that) and im not exagerating

im suprised my 4 wheel drive didnt save the accident.

newayz ive gotta get it fixed , ive sent it to the mechanic n he said its the wishbone, sway bars ????????  

has neone eva done this before, either the same accident or can give me an idea on what the damage is ???? plz plz plz

ive spent the last 2days crying and it was my bday yesterday (some bday present) ill be grateful for any advice u'z can gimme.  

thankyou

well its hard to tell whats wrong without seeing it, but defenitly the lower control arm would be gone. if you need someone to fix it for you (panel beating, mechanical etc.) give me a call on 0401677698. I'm in Melbourne

Ahmed

Dude i dont know about the rear, but i did a very similar thing a few weaks ago, if u can get ur car on a hoist, do it urself, shouldnt cost more then 300 bucks for parts for the front end, and its not a very hard job. I fixed mine myself along with a mates car who did the same thing also a line. Takes a few hours but nothing really dificult.

thats so much money man, if u could do some ur self i would suggest it, i needed new mags, still do, but my total was still under 600 bucks, including a new side skirt. But i got my crash on video, drifting in the vecinity (spelling*) of gutters = BAD.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • New CAS just turned up from NZ Wiring. Looks like a nice bit of gear.  So, yeah. Triggered, bro. Realised I may as well do the cam belt while mucking about with it so will order one of them.
    • Even more fun, leave all the ADAS stuff plugged in, but in different locations, hopefully avoid any codes!   And honestly, all these new cars with their weird electronics. Pull all the electronics out Duncan, and just shove an aftermarket ECU and if needed a trans controller in, along with a PDM. Make it run basic but race car styled!
    • To follow up a question from earlier too since I had the front bar off again (fking!) This is what is between the bumper and the drivers side wheel And this is the navigator side, only one thing but its a biggy! So basically....no putting coolers in the wheel arches without a lot of moving other stuff. Assuming I move to properly race prepping this car I'll take that job on and see how the computers respond to removing a whole bunch of ADAS modules
    • So I prepped the car for another track day on Wednesday (will be interesting to see coolant temps post flushing out and the larger reservoir, with a forecast of 3-14 being 20o cooler than last time I took it out). Couple of things to mention; since I am just driving the car and not taking a support vehicle, I took the rear seats out and just loaded the back up Team Trackday style. Look at all that space! To cover off removing the rear seat....it is weird (note the hybrid is probably different because it wouldn't have folding rear seats) Basically, you remove the lower seat base, very similar to a r series but it is a clip that pulls forward to release the base rather than it being bolted down. Easy Then, you need to remove the side section of the rear seat on each side. There is a 14mm head nut at the bottom of the side piece, the it slides upwards off a hook at the top to release; you also need to unhook the seatbelt from the loop at the top. Then the centre piece is weird. You need to release/fold the seats forward with the tab in the boot on each side From there, there are 2,x12mm headed bolts holding the rear of each seat to the folding bracket, under the trim between the rear seat and the boot (4x christmas tree clips there, they suck). The seat is out but you can see where the bolts attach to the bracket
    • As discussed in the previous post, the bushes in the 110 needed replacing. I took this opportunity to replace the castor bushes, the front lower control arm, lower the car and get the alignment dialled in with new tyres. I took it down to Alignment Motorsports on the GC to get this work done and also get more out of the Shockworks as I felt like I wasn't getting the full use out of them.  To cut a very long story short, it ended up being the case the passenger side castor arm wouldn't accept the brand new bush as the sleeve had worn badly enough to the point you could push the new bush in by hand and completely through. Trying a pair of TRD bushes didn't fix the issue either (I had originally gone with Hardrace bushes). We needed to urgently source another castor arm, and thankfully this was sourced and the guys at the shop worked on my car until 7pm on a Saturday to get everything done. The car rides a lot nicer now with the suspension dialled in properly. Lowered the car a little as well to suit the lower profile front tyres, and just bring the car down generally. Eternally thankful for the guys down at the shop to get the car sorted, we both pulled big favours from our contacts to get it done on the Saturday.  Also plugged in the new Stedi foglights into the S15, and even from a quick test in the garage I'm keen to see how they look out on the road. I had some concerns about the length of the LED body and whether it'd fit in the foglight housing but it's fine.  I've got a small window coming up next month where I'll likely get a little paint work done on the 110 to remove the rear wing, add a boot wing and roof wing, get the side skirt fixed up and colour match the little panel on the tail lights so that I can install some badges that I've kept in storage. I'm also tempted to put in a new pair of headlights on the 110.  Until then, here's some more pictures from Easter this year. 
×
×
  • Create New...