Jump to content
SAU Community

Recommended Posts

Hey all ............

i need a little help my R33 Gts-t auto

after i gave it a little bit of a hard time on wednesday night

it has started slipping

1st gear dont slip nor does 2nd that i can noitice

and i dont think 3rd does either

but once in 4th-O/D is slips like nothen else

Could really use some help becasue its only started slipping afteri over headed it down the 1/4

thanks in advance

Andrew

Link to comment
https://www.sau.com.au/forums/topic/276659-auto-gearbox-is-slipping/
Share on other sites

what im worried about seen its done this ..... how long does it how until it shits it self ........ becasue im looking at upping the boost this week

You're not going to have a catastrophic failure, she'll just slip like mad until the band gives way completely then you be missing that gear.

If I were you, I'd leave the boost as is and baby her until you sort the issue.

Either drop the manual in or replace the box with a second hand one for now, depending on your financial situation.

My clutch pack fried too, and I found a secondhand auto box for $350, pulled the old one out, chucked the replacement one in, and turfed the old box.

Awesome thing about everyone converting to manual is that complete boxes are cheap as chips.

picked up a 2nd hand auto box for 150 end of last year after i killed my old one. much cheaper to just buy another box and swap it rather than pay for rebuilds etc

also look into a shift kit and trans cooler, or you'll just kill the next one

Edited by stenve

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • I'm with you here. It's either loom has an issue, OR, injectors are not functioning properly. It could even be they're just constantly dribbling, hence the wet, but not firing.
    • Depending on how long the car sat it is very possible for injectors to be stuck open or closed, I'd get them cleaned and flow tested. Other than that, obviously when the loom changes and the car doesn't start any more....the loom is suspect so some tracing / comparing may be required
    • Harness is for a s1 Rb25det, and it is engine and lower harness.  the old harness had broken off plugs and was in very rough condition/exposed wires and splices etc. it is not able to be put back on the car, I could visually inspect to see if they had rewired any pins on the ecu plug. The fuel pump definitly isn’t turning off it’s an external pump and very loud you can hear it. Will look at the other harness tonight, am also going to pull the fuel rail and watch the injectors spray, will update here with what I find. Pretty sure at this point it has to be something to do with injectors because car will fire up on starting fluid and cas is clicking the Injectors. Fuel pressure is steady 43psi 
    • Check the injectors flow evenly, and are actually flowing what you and the ECU think they should be flowing. If it's starting up on starter fluid, you have a fuel issue. Is it possible under cranking your fuel pump is turning off?   The harness you replaced, is that the whole engine harness? Do yourself a test, and drop the old harness on and plug it into the Z32 ECU. It's possible they've wired things different. From memory S1 to S2 is different in RB25 and you may have a wrong loom
×
×
  • Create New...