Jump to content
SAU Community

Recommended Posts

Hi there,

I am importing a "Customs Cage" Roll Cage from the UK and require some one locally to weld

this into the Rally Car I am build at present. (I am based in the North of Tasmania)

Any recommendations availible in Tasmania ? ..... maybe in the North ?

Thanks again.

Regards.

Link to comment
https://www.sau.com.au/forums/topic/280028-roll-cage-welding-in-tasmania/
Share on other sites

i considered a custom cages cage for the rx7, but whitey ended up doing mine... i wonder if their fitment would be as nice and tight as his work? (importand in an rx7 cause there's hardly any room as it is!)

post-5400-1248394499_thumb.jpg

darren elphingstone near burnie is another option to weld up a kit for you, he did the cage in my evo and was very reasonable on price for the whole thing.

JW does nice work, and has improved out of site since maybe his E7. Custom Cages MIG in the factory, even though their joints are precision cut on a cnc machine.

Make sure you use correct wire if you have got the T45 option.

We did our own... but for customer car would use one or three guys to weld - JW being one of them.

TT984

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Hopefully it ends up being something manageable, like a hone, rather than a full bore—it would be a huge relief if it’s not as bad as it looks. Hang in there; these setbacks are annoying, but it sounds like you’re handling it as smartly as possible.
    • At the end of the day, it’s all about understanding the odds and being comfortable with the potential cost, whether it’s horsepower on a build or chips on a roulette table. And I have to say, the Laine example made me laugh—some people really do embrace that carefree, “roll and see” attitude!
    • Thanks MBS206, i got that PDF but got abit overhelm with all the connections and tracing of wires. I wasn't expecting to plug the dash harness anywhere. i was just going to use my electronics jumper wires to plug into the right pins like ECU power, ecu ground, ignition trigger etc... I do have a few ratchet straps locking it down tight. Fire extinguisher ready and only a small amount of fuel at a time, enough to submerge the pump.
    • Thanks GTSBoy, i will do abit more digging. I am missing a blue relay near the ECU connector... so i will chase that up in the next few days as well  
    • https://yariksteel.ru/manual/R33/Skyline_R33_elektroprovodka.pdf   Page 18 should be what you want for the Dash Cluster wiring. Though, you don't need the dash plugged in to get the motor running. What you want is power as how GTSBoy said. You need to power the ECU. Find in the above link the ECU pin outs (Verify them before just connecting them up from things written on the internet). Find anything needing power, give it power, find anything needing ground, give it ground. Then give the starter motor power through a big cable, and bridge the solenoid on the starter straight to power too.  ECU will be on, and when you give the starter power, it'll spin the starter motor, and it should start. I also hope you have a proper stand, and not just the engine sitting on some wood. You will want it bolted down properly.
×
×
  • Create New...