Jump to content
SAU Community

Recommended Posts

nismogirl,

maybe you have the new PFC version?? Does your alsd light even come on when you put it on ignition? if it doesnt, then it is likely that your light has been taken out, which is why u dont ever see the light come on?

if all is still ok, then you are just lucky!

Moanie,

no probs ;)

  • Replies 158
  • Created
  • Last Reply

Top Posters In This Topic

ah yes i know! everyone i know loves the car, the problem is i need to start up my business, as i dont work for anyone anymore (i like it that way too!), so i will be needing the funds to get things started. i will get another skyline again though, i just need the funds for other things right now.

..also...i think ive seen you and your car in a cruise or two in the past ;)

you don't neeeddd to sell it though!!! you can just leave it in the garage! start the engine once in awhile.. make sure shes all cool! and get a loan to get things started!!! selling the 'line is toooo much of a sacrifice!!!! ;)

hahha... really? which cruise? and which car was yours!? lol!!! sorry if we've met and i don't remember it! :)

  • 2 months later...

Hi y'all - I B A Noob to this forum so be gentle!

Has anyone driven the standard LSD and the Active LSD? Is it worth hunting around for a car with the Active Diff ? (Currently scouring Melbourne for the "right" R33 GTS-T).

It sounds VERY much like a Power-FC problem to me. Do you have the manual for it? perhaps you could phone a couple of jap-tuning specialists and ask the hard questions. Computers in cars tend to get narky when they're not fed the signal they're expecting, and it doesn't take much to upset the apple cart ! ! :looney:

I think it was pretty much summed up on page 1

"The active LSD on some GTSs uses a signal from the ECU like the GTRs do and i don't think PFCs have this function but as of now the Wolf plugin dose.

A clever electronics person could modify the TPS signal to send the inverted signal to the ADCU."

if steve is correct and he probably is if wolf now do it , you need to send a modified tps signal to active lsd . the power fc wont feature this , just as it wont send signals required to the auto transmission computer in auto skylines .

i dont know why nismogirls alsd works with the powerfc , but it could be

a. her latest powerfc does support this

b. whoever installed the powerfc has sent the tps signal also

  • 2 weeks later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • So for the wide band is a Bosch 4.9 correct for the Link G4+ along with a Can bus? Just get the Link gear or is generic ok too? Eg here: LINK LINK DIGITAL WIDEBAND CAN MODULE WITH BOSCH 4.9 SENSOR : KYP Performance House  
    • Bit difficult to follow. Have a look below and see what the standard R32 layout was like. Note there was a restrictor in place immediately before "turbocharged pressure control solenoid" that, if removed, magically got you 1 bar boost.
    • I might be way off the mark here.. there must be a T junction under the manifold. That takes manifold pressure through a check valve prior to the T, one side splits out to this bleed off orifice, the other straight to the wastegate actuators. 
    • Carrying out some engine due diligence before my first drive in a 260RS that has been in storage for 10+ years, and found two lines that are susposed to be plumbed into the boost control solenoid. One of the lines (the wastegate boost supply line) to actuate the gates, had a bolt in one end blocking it. The other line (main boost signal line) from the very rear of the intake manifold (RB26DETT) and runs up to the boost controller had this pill in the end of it as seen in photos. Other than the obvious (T28 Ceramic turbos might well be cooked)  Can anyone shed any light on if there is any validity at all with this mod, bleeding a constant fixed rate of manifold boost pressure off through this 3mm hole?  Is it deliberate?  Was this a 90s Jap mod done to RB26's? Or has someone just fitted this without any idea of what happens to ceramic T28s if they are not gate controlled?    
×
×
  • Create New...