Jump to content
SAU Community

What Switches Fit This Location

kidafa

By kidafa,
in Four Door Family & Wagoneers

 Share

Recommended Posts

kidafa Veteran

kidafa

Posted
Posted

Hi all,

Im going through the process of stealthing some things in my stag atm.... Pigglets from glove box to under seats, ebc tucked away ect ect....

Im going to make a hi/low switch set up for my profec b II. I want to know what aftermarket switches fit the location of the switch in the photo in nigels thread as i have no switches here on my car just the blanks.

http://www.skylinesaustralia.com/forums/St...l&hl=switch

Link to comment
https://www.sau.com.au/forums/topic/285186-what-switches-fit-this-location/
Share on other sites
QWK32 Veteran

QWK32

Posted
Posted (edited)
reading threads properly works well on forums :P

ooops, lol sorry, that will teach me to skim over posts. best thing to do would be to pull the blank off and head down to Jaycar, RS Components, Dicksmith (if you know of one that still sells electrical bits) and find one that would fit. if you can be bothered mounting one in the blank you have, you can get small rocker switches that would fit in the blank, but cutting a rectangle hole to fit the switch in can be tricky. if you got one in black it wouldn't draw any unwanted attention either.

Edited by QWK32

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • Predator1
      Tomei gasket

      By Predator1 · Posted

      Didnt realise RB's had more then 1 head.
    • MBS206
      Unpeeling the Orange

      By MBS206 · Posted

      I'm normally copping my own abuse from neglecting my daily drivers. "Those suspension bushes will last a bit more", "Don't worry about the oil leak, just keep topping it up". The project cars I'm always doing things slowly on them as I'm wanting them to be done better, and neater, and nicer. Luckily I don't have to deal with 18 year old Matt's "Learning to wire" stuff in the project cars. And there's only one piece of wiring I'm displeased about in the Landcruiser, and it's about to be cut out... However, the box loads of parts that have been going through this place lately for the Landcruiser... Brake pads Brake Rotors Full handbrake overhaul Wheel Bearings Seals Swivel hubs Steering Boxes Half the suspension joints Shocks Air bags (Ones to go in the rear springs for towing) Water pump Timing kit Lower timing case Harmonic Balancer Radiator Lots of other little seals and shits Gas struts for the bonnet New power window switches And god knows what else I've forgotten... Ha ha ha I have my fingers crossed the pinion seals don't start leaking on the diffs, that the transfer case doesn't leak, and the gearbox input shaft doesn't leak, nor the rear main seal. As they're about the only seals I haven't replaced in the driveline! I'm seriously eyeing off buying new caliper rebuild kits front and rear brake calipers... I'll probably recheck all the valve clearances soon too, and hopefully, it should be all good and sweet to haul some long distance trips again!
    • GTSBoy
      Unpeeling the Orange

      By GTSBoy · Posted

      Every time I pull my 3x gauges out of the console and see the crack-addict way that I did the wiring, and I just can't bring myself to tear it all apart and "make it nice", because it is currently working. In fact, the last time I was in there I probably made it worse.
    • Kinkstaah
      Unpeeling the Orange

      By Kinkstaah · Posted

      The best part is when you own the car long enough that you look back and find your OWN ham fisted amateur shit!
    • MBS206
      Unpeeling the Orange

      By MBS206 · Posted

      The annoying part about neglect, is when you start to replace one thing, and find ten more broken things. Ham fisted monkey repairs you normally only find out about when trying to do something unrelated! Ha ha   Neglect you can kind of anticipate the huge costs to fix it all. Ham fistedness is normally a shock the first time your work on a new old car, as everything "looked" good before.
×
×
  • Create New...