Jump to content
SAU Community

Recommended Posts

i had a fellow sau member put on a bosch (032 or 040 or somethig) internal fuell pump and the installlation went well....drove it for 30 mins around and it was running well....as i was going home and then i had a a quick lose of power and the engine would slowly die.Tried starting the car and it wont start at all...

i could hear the fuel pump switching on but it wont start..It would just be cranking on the ignition...

Called him up and he told me to check my fmic piping and afm (there could be a leakage not getting enuff air) and check the fuel pump wirings ( a wire would of came off). I checked em all but it still wont start...

can someone help me out as please....it seems it wanna start but something is stopping it....

cheers

Link to comment
https://www.sau.com.au/forums/topic/289415-plz-help-car-wont-start/
Share on other sites

Take the fuel hose off the end of the reg...

See if fuel is coming out.

Sounds like a botched install of the fuel pump - is it a genuine BOSCH? Plenty of fakes on the market - usually easy to pick as they are just too cheap.

yeah he does, and yeah if no fuel then maybe the stock wire just isnt big enough to power the 040, im guessing the 040 is similar to 044, when i got mine done u run another wire that follows the stock on thats a thicker core, otherwise it'l melt like it did on my mates vl after he got a respectable well known dyno'r in sa to put it on...

car feels like ders no fuel going thru the engine....fuel reg might be faulty..what do i do now??

Have you pulled the fuel line off that goes to the reg and turned the key to on? Does the fuel pump out?

If not the pump pickup may have fallen off.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Not really, but the heater box is pretty simple mechanically....if the door is one way the air bypasses the heater core and if it is the other way it goes through it for warm air.  If you are sure the actuator you moved manually is for the heater mix (there would also be one for output air direction) then I'd take the heater box out and see what is happening (you'll have to regass and re-coolant the systems afterwards) BTW pp724 onwards from the GTR workshop manual cover the system in good detail, it is probably worth checking. I think the IAT sensor might be a problem electrically for getting cold (if you got 24 error code not -24 it thinks the incoming air is -50c) and it covers how to test the sensor (although most likely it is either not plugged in or a wire is damaged)
    • Use the GKTech subframe bush and bring your subframe 10mm closer to the chassis. You'll need to fix an exhaust hanger to suit. One of the best mods I've done.
    • You'd really have to pull it apart further to know, it least you can be confident that the one heading to the back is not connected any more. There was once a ground on the shifter seal mount too, your head unit issue could be that simple
    • Perfect, I'll get to it this winter then at the same time as I weld on my anti squat kit. 
    • Alright so my 32 only has one temperature no matter what degree you set it to. I’ve tried disconnecting the servo motor arm and moving it either direction and got no change. I’ve fixed the leak in my AC and re charged it and with it on and clutch engaged it still blows hot even though the low pressure pipe going to the firewall is ice cold. Both heater core hoses are hot while running as well. Diagnostic code showed 24 for intake air temperature sensor. Anybody got any ideas?
×
×
  • Create New...