Jump to content
SAU Community

Recommended Posts

Spotted a nice blue R32 GTS-t with bronze wheels (standard) and a silver R34 sedan this arvo in Church Street, Parra, pretty much right outside Sherriff's Mini Cars. This was around 5.45pm...

At the lights near Red Rooster?

I saw you again last night near Crystal Carwash - i was going to Bob Janes just opposite

At the lights near Red Rooster?

I saw you again last night near Crystal Carwash - i was going to Bob Janes just opposite

Steve-O, did you spot me in the Stagea, or one of the Skylines?

my postie????on a CT110? :(

its gun metal grey :)

very standard :)

I got kicked off my postie, I can wheel satnd it for over 100 meters and one handed, they said you cant ride the postie anymore something about dangerous riding, huh whatever....lol

If you get the chance stop your postie and say that you know Ben...hahah

If ya see me wave, or throw something heavy or just swear, gunmetal grey 32gtr with 18inch white rims, always goin through old road and going to hornsby.

Ben,

hahah we have a postie at work (asquith golf club) I can just get the front wheel off the ground, but I can do helli's in the soil/gravel road in it hahahah

I think I saw you a few weeks back - fri or sat night. on somerville road round midnight.

Ill keep an eye out!

Chris

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • There are black hose clamps as well if you care. Plazmaman for example sells some: https://plazmaman.com/product/black-hose-clamps-premium-quality-stainless-breeze/
    • After using a protractor for an actually accurate assessment of what is required,  and by NOT using my uncalibrated eyeball I worked out I need a 25° silicone bend from the TB ro the MAF, but, my choice was either a 30° or a 23° (23° is a weird spec), so I grabbed the 23° one from Raceworks I also grabbed 1mtr of 3" straight from Just Jap, I needed 350mm, but they only had 300mm, or 1mtr lengths....meh Also ordered a 1/2" hose bulkhead fitting from fleabay, this has a smoothish mushroom looking head (they are designed for below the water line of boats) that will fit inside the bend, the hose bit and threaded bit looks to long, but nothing that a hacksaw cannot fix if required, the hose will then just get jamed on the threaded bit up to the retaining nut Fingers crossed and the unsightly amount of hose clamps will be reduced down to 4 once all the parts arrive 
    • Oil change does not trigger code 21. Code 21 is for coilpacks primary side connection. You can try to clear the code with a battery disconnect, hold down the brake pedal to drain capacitors through the brake lights with the ignition on for 10-15 seconds before you reconnect the battery. I have seen R35 coil conversion permanently cause this code with no ill effects so it might be the resistance it wants to see isn't quite right on one or more coilpacks. Could be inside the ECU, could be the harness, could be a coil. You can test it all if you want or just ignore until the car actually starts misfiring.
    • I forgot you have a Nistune ECU. Use Nistune to do all the tests I mentioned instead of faffing with 30+ year old electrical connectors. You can read MAF volts off that too, there are reference values in the service manual to tell you roughly what it should be in different conditions.
×
×
  • Create New...