Jump to content
SAU Community

Recommended Posts

98RON would be the best thing you can put in it. I used Shell V-Power for a year, then switched to BP Ultimate when I had the conversion and dyno tune done. Both are good in my experience, never had any issues.

shouldnt be any differences.

some people mention that one is better than the other, put either or in your car, as long as your not getting any pinging, then i wouldnt worry about which brand of fuel you get, just as long as it's 98ron at a minimum

Edited by BstewyR33

Is the tune stock ?

If so the 95 from any will be fine (it is cleaner and has less shit in it than 91)

If the car has been tuned to run 98 (no cars run a standard 98 tune other than after 2003) then you need to stick with 98, or the thing will ping like shit (detonation) and end up hurting the engine.

In my book 98 is the cleanest, best option - even if the car hasn't been specifically tuned to run on it the engine management will make good use of it after a while.

Prior to entering the turbo scene i ran a modified LS1 (making 360kw RW) in a VY 1 tonner as an everyday work and play.

It had all the frills and was given a birthday (with the upgrades) at around 80,000klms - and up to that point had run on 91. When the heads came off the engine was that full of crap (carbon) and the injection system/inlet manifold was full of pasty, nasty shit that would amaze most.

After the rebuild (with dart heads, 10.8 to one comp and stout camshaft) with a new engine management system the ute ran only 98 and was pulled down at 260,000 klms for a tidy up pre-sale. The heads, injection and manifold were as clean as - and the thing had seen a lot of shitty conditions running between Brissy and the Bowen Basin around the coalfields in NQ.

fuels aint fuels! - you get what you pay for!

Edited by Outrun

I've always used 98RON predominantly BP but with BP servo's diminishing I'm now having to switch over the Mobil's Synergy 8000 or Freedom's E10 Hi Octane 98 as both servo's are on my commute to work.

Just got 645K's out of my first tank of 8000. Was getting roughly 620-630 with Ultimate.

Am interested to see how Freedom's fuel goes.

I've always used 98RON predominantly BP but with BP servo's diminishing I'm now having to switch over the Mobil's Synergy 8000 or Freedom's E10 Hi Octane 98 as both servo's are on my commute to work.

Just got 645K's out of my first tank of 8000. Was getting roughly 620-630 with Ultimate.

Am interested to see how Freedom's fuel goes.

645k per tank is awesome! im running BP ultimate and im getting bout 250-275 kms per tank...WTF?! :(

When i first got my line i thought yea it will use 91 as every other car normally does. My car ran like absolute shit. would ping its head off had no power and misfired like crazy. so straight back to the servo to fil up with 98 and has beenn runing like a dream ever since.

For a non-turbo R34 (I'd imagine for all other non-turbo R31, 32, 33 would be the same).

You only need 93 RON (shown in the original owners manual and written on the fuel cap) - so 95 should be ok if you are on a budget or if 98 is not available.

However...

I did notice with 95 I still got pinging, some power flat spots in the lower rev range and the car tended to drink more. I've soley used 98 with no problems. You will still get very slight pinging every now and then on long uphills.

I recommend spending the few extra dollars on fuel as opposed to thousands of dollars and inconvenience of engine damage.

I wouldn't dare use 91 inless you are really stuck and have no other fuel available - Only use it for "limping" home/next servo that has premium.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Depending on how long the car sat it is very possible for injectors to be stuck open or closed, I'd get them cleaned and flow tested. Other than that, obviously when the loom changes and the car doesn't start any more....the loom is suspect so some tracing / comparing may be required
    • Harness is for a s1 Rb25det, and it is engine and lower harness.  the old harness had broken off plugs and was in very rough condition/exposed wires and splices etc. it is not able to be put back on the car, I could visually inspect to see if they had rewired any pins on the ecu plug. The fuel pump definitly isn’t turning off it’s an external pump and very loud you can hear it. Will look at the other harness tonight, am also going to pull the fuel rail and watch the injectors spray, will update here with what I find. Pretty sure at this point it has to be something to do with injectors because car will fire up on starting fluid and cas is clicking the Injectors. Fuel pressure is steady 43psi 
    • Check the injectors flow evenly, and are actually flowing what you and the ECU think they should be flowing. If it's starting up on starter fluid, you have a fuel issue. Is it possible under cranking your fuel pump is turning off?   The harness you replaced, is that the whole engine harness? Do yourself a test, and drop the old harness on and plug it into the Z32 ECU. It's possible they've wired things different. From memory S1 to S2 is different in RB25 and you may have a wrong loom
    • I haven’t pulled the injectors to watch them spray yet but they are clicking from the cas and all of the spark plugs are wet with fuel. I’ve thought the cylinders were being flooded from the beginning and was hoping fuel pressure would fix it. Tonight I am going to pull the rail and watch the injectors spray. Don’t know how to test/diagnose if the plugs are firing in correct sequence but that should be a timing thing and as far as timing goes my car still has the half moon for the cas can only install it 1 way. And my mechanical timing is 100% correct I posted photos above. Confirmed with the balancer on and off. 
×
×
  • Create New...