Jump to content
SAU Community

Recommended Posts

4WD light on dash cluster is on all the time. Has been since i bought the car. Didnt think anything of it until lately.

Was wondering if it was normal or if it might be indicating a transmission fault. Car seems to drive fine.

Any help much appreciated.

Link to comment
https://www.sau.com.au/forums/topic/294910-m35-stagea-4wd-light-on/
Share on other sites

check the attesa fluid in the boot, its behind the hidey-hole on the drivers side. i bet you the fluid is low.

+1, this was my first thought. That little cubby was a bugger to get out in mine, thought I was going to bust it, then it finally popped free.

ahh good, thanks for letting me know that. ive never taken mine off, i should because i get the 4WD light sometimes (must be fluid, only happens on inclines)

the book lists the g-force sensor as a potential fault, fluid, make sure the 'S' light appears next to the 4WD light on the dash if you move the switch.

also check the plugs to the attesa ecu which is next to the fluid bottle

where abouts is the bottle? lol i had a quick look but couldnt see anything

It is in the boot. On the right side is a small hatch on the side wall (similar to the one on the left). To get to the attesa bottle you need to remove the front cover and the whole side compartment (black plastic inset). To remove this it is easiest done with a small (thin) screwdriver or similar. There are latches in the top corners of this inset box. By pressing down on the top of them you will be able to pull the box out. You will the see the Attesa bottle.

Good luck

Andy

After 6 months ours started displaying the 4WD warning too. It is never on just after start-up but will display anytime within the first minute. Usually if it doesn't come on within a minute it won't come on at all.

So I bled and replaced with Matic D in the Attesa system and replaced oils in transfer case and both diffs. Problem remained.

Sometimes I can sense that the warning light is about to display. When driving away the car will bind up slightly and want to straighten up - like as if the centre diff is locked and the fronts what to rotate at the same speed as the rears. The warning light will come on, the steering will relax, and I guess it then is a rear-drive only?

Also, if the car has been allowed to fully cool then the warning light won't display but is very likely if the car was recently switched off.

My next attempt will involve reading those fault codes.

  • 4 weeks later...
  • 4 weeks later...
put the car on our scanner at work and it displayed a 4wd motor fault. im guessing this is the pump motor in the boot. Can anybody confirm this.

Yeh pretty sure it's under the back on the RHS .....right behind the rear wheel.

P.S. Any chance I can get on that scanner......I think I may have the same problem :D

Edited by Jetwreck

sure, no problems, just give me a call. 0425 349 923

Yeh pretty sure it's under the back on the RHS .....right behind the rear wheel.

P.S. Any chance I can get on that scanner......I think I may have the same problem :(

  • 3 months later...

post-52624-1272337620_thumb.jpgpost-52624-1272337752_thumb.jpg

I have recently had the same problem on my NM35.

My 4WD light was coming on after a few minutes of driving. This then turned into every time i started the car the 4WD light would be on.

While the 4WD light is on the ATESSA is not active so it will be running in RWD.

The problem end up being (after a long time troubleshooting) a relay located under the air filter. This relay controls the ATTESA pump. Without the pump no 4WD.

This relay in not available threw Nissan anymore so i had to addapt a generic 40A relay.

This has fixed the problem completly and 4WD light has not come on again and ATTESA is working perfectly.

I have attached some schematics that helped me out.

I hope this helps someone out as i spent ages figuring this out.

Cheers

post-52624-1272337816_thumb.jpg

  • 5 years later...

attachicon.gifSDIa0728J.jpgattachicon.gifSDIa0727J.jpg

I have recently had the same problem on my NM35.

My 4WD light was coming on after a few minutes of driving. This then turned into every time i started the car the 4WD light would be on.

While the 4WD light is on the ATESSA is not active so it will be running in RWD.

The problem end up being (after a long time troubleshooting) a relay located under the air filter. This relay controls the ATTESA pump. Without the pump no 4WD.

This relay in not available threw Nissan anymore so i had to addapt a generic 40A relay.

This has fixed the problem completly and 4WD light has not come on again and ATTESA is working perfectly.

I have attached some schematics that helped me out.

I hope this helps someone out as i spent ages figuring this out.

Cheers

Thanx sooo much for posting this. It fixed my car. I bought my car from a Sydney Importer & the 4WD light came on 2 weeks after I got it. His Mechanics looked at it once then they told me to go somewhere else the next time. I found this and took the car to my mechanic, who checked through the whole system then the relay and it was dead. He wired in a 40A generic and BOOM attesa pump fired up and no light.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • The rain is the best time to push to the edge of the grip limit. Water lubrication reduces the consumption of rubber without reducing the fun. I take pleasure in driving around the outside of numpties in Audis, WRXs, BRZs, etc, because they get all worried in the wet. They warm up faster than the engine oil does.
    • When they're dead cold, and in the wet, they're not very fun. RE003 are alright, they do harden very quickly and turn into literally $50 Pace tyres.
    • Yeah, I thought that Reedy's video was quite good because he compared old and new (as in, well used and quite new) AD09s, with what is generally considered to be the fast Yokohama in this category (ie, sporty road/track tyres) and a tyre that people might be able to use to extend the comparo out into the space of more expensive European tyres, being the Cup 2. No-one would ever agree that the Cup 2 is a poor tyre - many would suggest that it is close to the very top of the category. And, for them all to come out so close to each other, and for the cheaper tyre in the test to do so well against the others, in some cases being even faster, shows that (good, non-linglong) tyres are reaching a plateau in terms of how good they can get, and they're all sitting on that same plateau. Anyway, on the AD08R, AD09, RS4 that I've had on the car in recent years, I've never had a problem in the cold and wet. SA gets down to 0-10°C in winter. Not so often, but it was only 4°C when I got in the car this morning. Once the tyres are warm (ie, after about 2km), you can start to lay into them. I've never aquaplaned or suffered serious off-corner understeer or anything like that in the wet, that I would not have expected to happen with a more normal tyre. I had some RE003s, and they were shit in the dry, shit in the wet, shit everywhere. I would rate the RS4 and AD0x as being more trustworthy in the wet, once the rubber is warm. Bridgestone should be ashamed of the RE003.
    • This is why I gave the disclaimer about how I drive in the wet which I feel is pretty important. I have heard people think RS4's are horrible in the rain, but I have this feeling they must be driving (or attempting to drive) anywhere close to the grip limit. I legitimately drive at the speed limit/below speed the limit 100% of the time in the rain. More than happy to just commute along at 50kmh behind a train of cars in 5th gear etc. I do agree with you with regards to the temp and the 'quality' of the tyre Dose. Most UHP tyres aren't even up to temperature on the road anyway, even when going mad initial D canyon carving. It would be interesting to see a not-up-to-temp UHP tyre compared against a mere... normal...HP tyre at these temperatures. I don't think you're (or me in this case) is actually picking up grip with an RS4/AD09 on the road relative to something like a RE003 because the RS4/AD09 is not up to temp and the RE003 is closer to it's optimal operating window.
    • Either the bearing has been installed backwards OR the gearbox input shaft bearing is loosey goosey.   When in doubt, just put in a Samsonas in.
×
×
  • Create New...