Jump to content
SAU Community

Recommended Posts

Hi guys,

Bought some 18" rims for my r32 a while ago, 8.5 front and 9.5 rear. The rears stick out a bit which I like the look of but the tyre shop has got me second guessing whether to put them on. I didn't realise that it's unroadworthy for wheels to stick out. So wondering what sort of attention if any, you guys get. Everything else is stock and I don't hoon or drive crazy, just to work and stuff.

Am I just being vein by putting them on and risking it?

Thanks

Kye

what tyres u running? sticking out will get you attention and if you have stretched tyres be warned it wont end well! its the tyre shops job to tell you its not roadworthy.

having said that ive got 18x10 sticks out a fair bit they were far more worried about stretched tyre, perhaps roll your guards? how much is it sticking out, post pics 9.5" should be too bad really.

aslong as the top of the tyre is inside the guard, they dont really hassle you.. their problem is that if you run over or hit someone and they roll down the side and hit the top of the tyre they can be sucked/pushed under the car.. so whether its alot of neg camber, stretched tyres, or flared/pumped guards.. you shouldnt need to worry much.. just dont be caught doing anything silly eh?

if you see the big 4wds with their chunky as tyres sticking 3 inches out of the guards you can understand why... if you rolled down the guard off the bonnet the tyre would catch you and drag you down instead of bouncing off and hitting the road..

i usually run 235's on a 9.5 inch rim and this is within the tyre size range for this size wheel.. only just though.. so i just figured there wasnt really anything that they could do and ran with that.

dont be fooled into thinking that its highly illegal and a death trap... this just isnt the case.. soo many people on here run stretched tyres and most sit out of the guards a little, and i never heard any of them complaining of being dead.

if you see the big 4wds with their chunky as tyres sticking 3 inches out of the guards you can understand why... if you rolled down the guard off the bonnet the tyre would catch you and drag you down instead of bouncing off and hitting the road..

There's that... and also the problem of picking up road debris (stones etc) and projecting them forward from the top of the tyre into oncoming traffic.

The rears only stick out about 2cm and should fit nicely under the guards with 245/40 tyres. (Wheels came with 275/40 and b-u-l-g-e)

From what I've researched the 245/40's are a good size. I do actually want some performance and am not just putting them on to be fully sik.

I might try a different shop and get them to put the new tyres on but I'll put the wheels on the car myself. Last tyre shop made me feel stupid and asked me if I had even tried them on the car. Meh, maybe I'm just being too sensitive.

Thanks for the input

Bought some 18" rims for my r32 a while ago, 8.5 front and 9.5 rear. The rears stick out a bit which I like the look of but the tyre shop has got me second guessing whether to put them on.

Got any pics? How far out are they sticking? If they're flush you'll generally get away with it, unless the cop is having a bad day or knows that there's more to the wheel modification restrictions than diameter.

I didn't realise that it's unroadworthy for wheels to stick out.

Did you realise that it is also unroadworthy to have the wheels 1" wider than the widest stock wheel without an engineering certificate? Or offsets 13mm lower than the stock wheels? Some of the more clued-in cops check these numbers too.

what tyres u running? sticking out will get you attention and if you have stretched tyres be warned it wont end well! its the tyre shops job to tell you its not roadworthy.

Yeah, but most of them are idiots. I've seen plenty of tyre shops recommend illegal wheels to people.

The legality for an aftermarket tyre is based on the size of the OEM one, not the wheel you're fitting it to.

Tyre manufacturers have recommendations for what sized wheels you should fit certain width tyres onto, but these vary from tyre to tyre.

The legality for an aftermarket tyre is based on the size of the OEM one, not the wheel you're fitting it to.

Tyre manufacturers have recommendations for what sized wheels you should fit certain width tyres onto, but these vary from tyre to tyre.

yes but my question was what is the recommended tyre for a 10" rim not whether a 10" rim was legal for my car or not.

i just want to know is a 255 within recommendations or is it 265s etc. :blink:

yes but my question was what is the recommended tyre for a 10" rim not whether a 10" rim was legal for my car or not.

i just want to know is a 255 within recommendations or is it 265s etc. :blink:

235/45 on my 9", but the rims protector doesn't quite protect it due to angle, not a stretched fitment by any means.

so 25mm wider rim, 25mm tyre? = 260mm, I would probably go the 265, 255 would end up starting to look stretched IMO, but that is a guess and there would be better people to comment.

In the tyres I use I wouldn't have a choice, KU36 on a 17x10 I would have a 255, as these are the choices:(from kumho website) 18x10 they would have a 265 not a 255

245/40 R17

255/40 R17

275/40 R17

245/35 R18 XL

265/35 R18 XL

275/35 R18 XL

So you might want to check what sizes are available if you are set on a specific tyre.

yes but my question was what is the recommended tyre for a 10" rim not whether a 10" rim was legal for my car or not.

i just want to know is a 255 within recommendations or is it 265s etc. :blink:

your 235/40R18 is 645mmOD

10" options

255/40R18 is 661mmOD

255/35R18 is 636mmOD

265/35R18 is 643mmOD

yes but my question was what is the recommended tyre for a 10" rim not whether a 10" rim was legal for my car or not.

ORLY?

wheeldeal can u tell me where u get ur wheel guidlines? i need to know for 10" rim what tyre is legal.

Care to try again?

I never said that you were asking whether a 10" rim was legal or not. Your question was about what kind of tyre is legal for your car. My response was that the legality of the tyre you choose is primarily dependent on the stock tyre, not the wheel its going on.

ORLY?

Care to try again?

I never said that you were asking whether a 10" rim was legal or not. Your question was about what kind of tyre is legal for your car. My response was that the legality of the tyre you choose is primarily dependent on the stock tyre, not the wheel its going on.

perhaps comprehension is not a strength of yours.

my question purely related to a 10" rim and what is the suitable tyre for this i didnt ask about the legality of the rim on the car. regardless of the car the tyre must be within the guidlines for that size rim unless im wrong?

k thanks bye.

Rbryan & wheeldeal thanks for your help

post-61036-1259991744_thumb.jpgpost-61036-1259991757_thumb.jpg

post-61036-1259991768_thumb.jpgpost-61036-1259991711_thumb.jpg

The rears have 275/40s on in the photos but will be changing to 245/40s. Better fit under the guards and better handling I think?

Edited by kyekye

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Yeh I think i'll message an old contact i had for ages that manages his own tyre shop now.. n tell him what i want n work with him before ordering..  Got this 17x9 +30 Driftteks on 245/45/17 PSR Drag Radials on the rear.. They fit well - for your reference in future - Rear guards  have been lipped in & minimal to non flaring of the rear Gaurds.    
    • If only it were that easy! I also needed to remove seats, shocks, brake calipers, send my car through a fence, and use measuring and ended up guessing because I didn't remove seats, shocks and brake calipers. It can be hard sometimes Can be a little more complex than 'just measure' if you want to truly measure the entire wheel through all of it's suspension travel. But if you aren't going for every last mm then yeah, you can check the space you currently have and guesstimate.
    • If you own a car, and it has wheels on it, and you know the offset of those wheels, and you have a measuring device, you have everything you need to work out if other wheels will fit.
    • Will this fit? but they are staggered set - RAYS 57DR SEMI GLOSS BLACK 18x8.5 +37 | 18x9.5 +38 5-114.3 STAGGERED SET   or If no go could just get a set 4's wheels of 18x8.5 +37 5-114.3 - would i run 8.5's 235s up front n 245's at the back if I do?   Thanks.        
    • Put a clamp on your return line. I have a feeling it's sucking air, and introducing bubbles to your fuel. With a lot of fuel, less problematic. I'd honestly be redoing all the lines in the tank and clamps on everything.   Also, you've given two different answers to the same question: Asked if being followed by the police you could get down to use the whole tank, you said yes you could, so long as you keep off boost. However, you then followed this up that free revving, it would also cause the issues. I'm doubting free revving is enough to make any noticeable boost on what is likely a decent sized turbo.   So now I have to ask, can you actually drive it lightly and use all the fuel, or does it break up even free revving? Also, have you put a fuel pressure gauge on it? Can you hear the pump change noise at all when you're having this issue?
×
×
  • Create New...