Jump to content
SAU Community

Recommended Posts

I have for sale the following items:

1. R33 GTSt brake calipers, rotors and pads $500 (If sold seperatly $350 for the Fronts and $150 for the Rears)

2. R33/34 GTR JJR intercooler hard piping kit powdercoated black by Craved Coatings, including silicon hoses $350 (Missing hose clamps)

3. R33 car jacks $30 each

4. R33 push type slave cylinder with line $60

5. RB26 cam cover $60 (will require respray)

6. Exhaust cam bracket $20

7. Stock R33 GTSt BOV with pipe $50

8. R33 GTSt crankshaft and crankshaft girdle $100

9. RB26 badges Large $30 Small $10 each

10. RB20/RB25/RB26 Gates timing belt $80

11. Stock R33 handbrake shoes $50

12. Stock RB25 conrods $60

13. R33 GTSt thermo fan $60

14. R33 GTR front and rear rotors Make an offer

15. Various plugs for radio/headunit $10 each

16. RB26 push in cam cover fitiings -10 size $30

17. N1 oil pump gears $300

18. R33 GTSt manual, series 1 speedo cluster $60

19. Apexi power FC hand controller 415-N001 $350

I am located in Sydney, happy to post interstate at buyers expense

Edited by Smoky
Link to comment
https://www.sau.com.au/forums/topic/302659-rb25-rb26-parts/
Share on other sites

  • Replies 40
  • Created
  • Last Reply

Top Posters In This Topic

5. RB26 cam cover $60 (will require respray)

i'll take this if its the pair of cam covers (like the actual camshaft covers...)

16. RB26 push in cam cover fitiings -10 size $30

and if these fit the RB25 cam covers i'll take them too

Link to comment
https://www.sau.com.au/forums/topic/302659-rb25-rb26-parts/#findComment-5018200
Share on other sites

5. RB26 cam cover $60 (will require respray)

i'll take this if its the pair of cam covers (like the actual camshaft covers...)

16. RB26 push in cam cover fitiings -10 size $30

and if these fit the RB25 cam covers i'll take them too

Sorry, I should have put it as RB26 timing belt cover, no cam covers for sale

To my knowledge they will only fit an RB26

Hi mate, interested in the Apexi Power FC, i still have the stock ecu, is this a plug in piggy back system? or does it replace the whole ecu? thanks, i live in perth btw. oh and it works good?

No Power FC for sale here, just the Hand Controller

Link to comment
https://www.sau.com.au/forums/topic/302659-rb25-rb26-parts/#findComment-5018283
Share on other sites

  • 2 weeks later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Put a fuel pressure gauge on it. Replace the turbos. Probably completely separate issues.
    • What copper washer do you guys use on the bleeder bolts? The existing one I have I had no idea where to find it in a local store, I did buy some online but that are only 1mm thick whereas my old one is 2mm+ thick and when I put the new washer out and squeeze the top radiator hose I can hear a bit of air but not with the old one. Does this matter? The new one doesn't leak, but the inner diameter is a bit loose whereas the old one threads on the bolt.
    • Howdy all, after being out a few weeks ago on a spirited drive in my GTR I have 2 issues that oddly have appeared at the same time. Whilst accelerating quickly through the gears all of a sudden i’ve lost power at the top of third gear (below redline around 6000rpm) for no obvious reason.    From that point onwards the car has been running rich on idle, won’t really rev under load without a ton of black smoke and the odd backfire, and dying as a pull up to a set of lights unless I keep the revs up around 1500rpm. In addition when shutting down the car that same night (I was 10 minutes from home) I noticed one of the turbos was significantly noisy on wind down when shutting off the engine. After letting the car cool down overnight it starts up fine, although once it gets to temp the revs start to creep up and down, the exhaust is darker than it should be and it also sounds like it’s running rich (fat note) I’ve put a new set of plugs in it - no change, the old plugs all seemed OK with two of them being somewhat richer/fueled up than the other 3 with 1 being borderline. I’ve smoked tested the intake system via the front of the Turbos, found a split vacuum hose going to the factory boost gauge sender, which I have since replaced.  Also found another leak on the gasket coming off the rear turbo outlet, have also replaced this. After fixing both of these leaks - still have the running rich issue. I’ve also tried another pair of AFM’s - no change here After pulling off the front turbo intake pipes, there is obvious shaft play in the front turbo, which now hisses loudly on light revvs although I can’t see why this would make the car run funny even under idle. I’m curious to know why it’s running rich before I potentially replace/rebuild turbos. The car is completely stock <50,000kms  other than an exhaust. Oil and coolant are all clear. I haven’t bothered with coil packs as it looks like they won’t be the issue due to condition of the plugs. Any help appreciated as I cry myself to sleep!
    • No probs at all. I used to love trying to dig up obscure info for those in need where possible going back 20+ years on SAU.  I did have another look and couldn't come up with any closer match. I'm leaning towards those skirts in your first pic are custom fitments, cut down/extended or from another car entirely and modded to fit an R34 sedan. I would've thought someone in Japan had them and taken a photo at some stage over the last 2 decades but there's nothing. Someone out there must know surely.
×
×
  • Create New...