Jump to content
SAU Community

Recommended Posts

Hey again everyone, I was hoping somebody might be able to help me sort out an issue that I'm experiencing after fitting a new HKS EVC-S boost controller on my S2 Stagea RS4S.

When the controller is off the boost comes on at wastegate spring pressure (which on my Stagea is around 5-6PSI) so without the dual-stage in place it sits on the lowest possible pressure, thats not the issue however when I turn the boost controller unit on and dial in enough boost pressure for around 9PSI I can hear something (which I presume) like the HKS solenoid clicking quite a fair bit. There is no clicking when the unit is off however.

The boost is stable all the way to 9PSI with no overshooting or surging and no hesitation from the engine. So its defiantly something along the lines of the boost controller unit when its on.

Could anybody throw some suggestions at why this might be the case? Have I got the unit set up incorrectly in someway? After searching google a bit I've found theres plenty of info on clicking solenoids but they seem isolated to Greddy and Blitz units, and even then its not conclusive.

I was maybe thinking the boost setting I've got may be asking to much from the solenoid too early? Full boost at 9PSI comes on around 3500RPM.

Hi I had the same problem with my greddy unit. The solution is very simple and i presume it will be the same for yours. You need to put a rubber grommet between the solenoid and the car. The solenoid will still click the rubber just stops the noise traveling through the car. I hope this helps.

Thanks for the suggestion never thought it might be something as simple as dampening the vibration of the unit itself so fingers crossed that might be the cause. I'll hunt down a rubber washer today and report back if the clicking gets softer.

  • 3 weeks later...

i just installed my hks evc-s got the same issue with clicking... at first it wouldn't do it but eventually i heard it like 2 days later... very very odd...

i also have a rubber washer between the unit and my chassis, but clicking is still loud as fk lol

so i think if the problem lies within the over boost function i may just tune it using the over boost a bit more (currently its set to 0 whilst using the offset to control the psi)

its not a problem, the solenoid will click when its 'adjusting' the amount of air passing. your factory ones do the same thing, they are just quieter, and probably slower (i cant remember the frequency, 10Hz?) but aftermarket ones are generally faster and make more noise, but they do a better job. like a bigger exhaust, noisy, but more power :P

isn't it open until 4500 then it starts pulsing?

open = wastegate spring pressure

pulsing = higher boost levels

my rs4s runs 7 psi with the solenoid off and 10 with it permanently grounded

if it was closed below 4500, it'd be freeboosting. it just pulses at different rate after 4500.

WRONG . the line to the solenoid is teed into the reference line to the waste gate . closed = waste gate pressure. open it bleeds off as much air as the factory restrictor will allow.

why do you think bypassing the solenoid is the same as having it permenantly earthed

thats right, factory solenoids work in parallel to the turbo, aftermarket ones generally are in series with the wastegate actuator line.

why? because if it fails, it will most likely lock in a closed position and the car wont overboost and die

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • I have been being VERY quiet about what you're alluding to, as it is something that ticks me off... The number of cars from factory that run coil overs is HUGE! Most of them these days do... The other part that annoys me, is people saying "Well all the incabin adjustable suspension is illegal by blah blah blah"... If that's the case, then why can I buy a car brand new that can do it if, FULL STOP in cabin adjustable suspension is illegal...   Also, I could just chuck some aftermarket shocks in my car, throw the stock springs on, after my blue slip, dump my super low springs back in. Same shock and spring style setup... Hell, they could also be the same colour springs etc.     I'm voting, BlueSlipper didn't want to touch the above car for some reason. Whether it be some sort of bias against the car, the owner, them maybe having previously done dodgy shit and now they're being super careful in case they get slapped in the face by the Gumbyment again... Find a new blueslip place.   And can confirm as you had said, yes there are holy bibles of vehicle heights, and all sorts of other suspension stuff. Heck your run of the mill mechanic, and tyre shop has access to all of that stuff. It's how they do wheel alignments...
    • Funny story Heading to Sydney this morning on the HWY there was some slow traffic, so I gave it the beans and midway through my overtaking "power run" I lost all power It seems that I missed a hose clamp,  and the MAF and filter went WiFi To make this more problematic, the little tool kit that lives in the boot, is sitting in the sun room at Goulburn......LOL Luckily for me I found a bit of steel on the side of the road that could be used like a rusty and bent flat head screw driver to tighten it up enough that it got me into Sydney, it is now all tight like a tiger with the aid of a 8mm socket Note to self: Use my brain and double check stuff, and always keep that little tool kit in the car for when I have a brain fart
    • Oh, and as for everyone with their fuel economy changes, I switch between E10 and 98 in the company car. Even do when I had personal cars that could run on E10. You know what changed my fuel economy in any noticeable way? How I drove, and where I drove. Otherwise, say on full tanks of just back and forth from work only (So same trips, same sort of traffic), couldn't notice a difference that I can correlate to the type of fuel in use. In the current vehicle, that's over 42L of USABLE fuel. While 98 is all "more energy dense", it also has higher knock resistance as it takes more energy to get it to ignite too. The longer hydrocarbons, typically more tightly bound. So running the same ignition map, can also produce less power, if there isn't enough time to get it all burnt through properly, as yep, the flame propagation speed is different from lower octane fuel to higher (Higher has a lower flame propagation, due to the more tightly bound and harder to self ignite funs. This is also typically where, a vehicle that is designed purely to run on 91 (Whether it be E10 or normal 91) usually sees absolutely no real world difference in fuel economy for the normal man, woman, or dog.
    • We've got some servos around me that have 91 with E10, 91 (no E10), 95, and 98. At those stations the change from 91 E10 to 91, is typically around 8c/L.   But lets not get started on the price of fuel in Oz. It's ridiculous. All the service stations around me, bar one, the price of fuel has been over the $2 mark per litre for the cheapest, 98 being around $2.45. That one service station is a CostCo, fuel from it comes from the same refineries, and makes no pitstops, it runs great, including the 98. In fact, I've had no issues on CostCo fuel, but plenty of issues at other stations!. The CostCo fuel, was $1.65 roughly this week for 94 with E10. $1.88 for 98. Servos directly across from it, $2.10 for 91 E10, and $2.48 for 98. The part I had to laugh at? If I drive multiple HOURS away from Brisbane, say out near Nanango, or Kingaroy, or even out to Goondiwindi, the price of their fuel, is the same as what it is at the CostCo... Oh, and that BP servo at Goondiwindi is HUGE and goes through epic turnover of fuel, so it's not sitting there for weeks going to shit. And what blows me away, my mate is one of the people who drives the Fuel Tanker all around QLD, delivering to all those places. At the same company his previous role was doing the "local haul" deliveries... Same truck, same driver, same pickup point it all comes from. So you tell me, how the hell it is 60c/L CHEAPER for fuel, when nearly all else is equal, except they require a B-Double to drive half a day out of Brisbane, and half a day back, every second day, compared to the delivery that can be under 30 minutes drive from the fuel pickup point... Not to mention, go five blocks down the road, and Ampol to Ampol will vary 30c/L... And I've had this conversation with my mate... The way it's priced, is just typical, pure and utter rubbish... He also does runs from Brisbane, to all over QLD, down to Newcastle, Sydney, Nowra, Melbourne, Geelong, and even out to parts of the NT depending on the companies needs. His main stuff is all the longer distance away from home for a few days at a time, then when he's back, he loves to just pickup extra shifts wherever he can in whichever truck, hence all the weird different places.   Oh, as for getting E10 into all the fuels in Australia... It was very quickly highlighted, that we don't have enough biomass available to use to make E10 sustainably like they require, and it would dramatically cut into our, and the worlds food chain supply...   I vote we all just start running on liquid methane gas... Plenty of that just getting tapped off at tips from underground decay... (Note, this is pure just stupid commenting. I could very easily highlight the reasons its not a good idea especially on scale...)
    • Am I correct in assuming that the R35's are getting the classic skyline haircut off the odometer?  Quick search on carsales, there are 33 08 and 09 GTR's for sale, only 2 of them have more then 100,000km's on them (116,075 and 110,000 respectively).  And somehow there are about 25 for sale with around 60,000kms? Looks like the classic skyline haircut to me =/
×
×
  • Create New...