Jump to content
SAU Community

Recommended Posts

  • Replies 80
  • Created
  • Last Reply

Top Posters In This Topic

Brett - I'm out mate - Sorry :(

Was looking forward to this, but I've still got that boost drop off issue. Damn it....

Missed the drift day today too - damn it.

I'm sure it will get sorted - just a matter of 'when ?'

http://www.pbase.com/image/25387634   maybe it got stuck here as well.  :D

I meant that it got stuck open so you ended up taking 500 photos of your car :):D

I took some too :)

Brett did a PB (personal best!).

I will leave it to him to wave the RB25 flag and give the figure himself :D

There was a late challenger... a certain red R31/RB26/T51R coupe but it didn't come near Brett.

All in all a pleasant but long day finishing somewhere past 7pm.

T.

Thanks to Buster for orginising and letting me stay inside to get some good pics.

Great day had by all and that NSX was awsome even though it was stock it pulls a lot of credit.

Here is the photo gallery i put up for everyone to check out.

http://members.optushome.com.au/matthewrob...n2004/index.htm

To be dead honest, it was a special tune and different fuel that we're preparing the car with to be ready for Drag Combat, I don't normally and will never make that power on the street, with normal fuel and tune its only for the drags

Brett




  • Similar Content

  • Latest Posts

    • Thank you, 100% the intent. New coils were due and the 17" sixers look/feel loads better than the stock wheels. The aero options are so spot on.   Thanks for the warm welcome, all!
    • 98 r34 gtt Been rocking my latest setup and car running like never before. Have put a good 200 miles on it since all the latest changes and additions. everything is dialed in and have been driving it a bunch.   However, all a sudden last weekend as soon as I pushed throttle passed 4k and the engine stumbles, (slow or fast acceleration) hesitates and doesn’t go above 4100 or so, like a misfire. Everything else seems fine. I had a “good” set of coil packs that I removed from car when I first got it when I changed them over to new coils. I swapped out current ones for those, but no change. I also changed the plugs, no change. Seems to rev over 4 when out of gear with no load just fine no “misfire”, but as soon as its in gear with a load of any kind, it “misfires” as soon as rpm drop back below 4 k it runs perfectly, smooth, starts, restarts and drives fine as long as I keep it below 4 k while in gear. All readings look fine, no CEL   Any idea as to what could all a sudden cause an issue when pushing rpms passed 4 k?
    • When you say your cams are 272/262 is that 272in and 262ex?
    • We're arguing semantics. I am saying 45 accel and a 55 deccel ramp are "2 ways". Even a 45 degree ramp and an 89 degree ramp is "2 ways", because it is literally... two ways. The cusco 55/30 ramp is a 2 way. It's two ways. I get it though - in normal nomenclature a "2 way" would be 45/45 or 55/55 or 60/60 i.e the same locking in both directions. And something like 45/65 would be considered "1.5 way". I would then say if we're getting into the nitty gritty then every locking diff is a "2 way" diff and we should not speak in 1.5, or 2 ways but ramp angles instead. Which ofc if one of those ramp angles is 90deg, that side is not doing any locking. :p So Nismo don't obviously sell 3 things. The fact of the matter that they only sell two items really goes to show that there's a 2 way and a "1,5 way" which is really a 1 way. I believe the actual lockup for the 'adjustability' of the GT pro is really just setting preload for when the ramps actually start locking up. It's not changing how much 'wayness' there is. It is (somehow) horribly explained. People just buy whatever diff and go "locks up good bruh" and that's what ends up on socials forever.  
×
×
  • Create New...