Jump to content
SAU Community

Recommended Posts

Hey was just wondering what people think of this package?

http://www.tweakit.net/shop/product_info.p...roducts_id=5090

I'll be running about 280rwkw on my rb25det

I broke my fpr when i was getting my half cut :D

So yeah decided to just grab an aftermarket one and this one popped up, any opinions?

Link to comment
https://www.sau.com.au/forums/topic/305522-fuel-system-for-my-25det/
Share on other sites

Just buy Nismo 555cc injectors, use the stock FPR.

1. Factory rail, fine

2. Factory fuel reg, fine

You only need injectors, which are around $750 delivered.

There is no need to go aftermarket anything other than the injectors, so leave it that way and buy a replacement OEM FPR.

Trade Nissan should be about the same, if not cheaper.

If i can get an entire RB26 loom for under $700, there is no way a FPR is going to cost anymore than $100-$150.

You'd be up for around $100 to get a Nismo item here so i don't see a difference enough to get excited about

cant remember exactly but nissan wanted well over 200 for a reg. it was cheaper to get a tomei with the rail adaptop and hoses etc. only reason i wanted a new one is because i busted 3 2nd hand ones in less than 5000km's, each time i didnt know they were broken until it was under full load and leaning out to around 15:1. so i got sick of 15yo shit

I agree changing stuff that doesnt need to be changed is a waste of time, effort and money. I say also stick with stock rail and a stock reg. but I'd go the 740's. HEAPS of head room for basically the same money.

just my 2c!

cheers

+1 for nismo 740s, i have heard from a reliable source they are better to tune than most.

also +1 for stock rail and stock FPR, get trade from nissan it shouldnt be too much. buying an aftermarket has zero advantage other than more useless bling bits you need to worry about at this level.

if your going to run twin external pumps or some BS then by all means go for gold on an aftermarket

If you don't need bigger - don't get them.

Only get 740's if you plan for over ~330rwkw later on.

Otherwise the 555's will do the job just as good.

you can never have enough headroom, that is until they become harder to tune.. then its useless.

in this case i have heard that the red nismo 740s are better to tune than the 555s. that being the SR RB specific red nismo items, not 740s in general.

yet yes, 555s will be enough ;) but for the same price i know i wouldnt think twice.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • After using a protractor for an actually accurate assessment of what is required,  and by NOT using my uncalibrated eyeball I worked out I need a 25° silicone bend from the TB ro the MAF, but, my choice was either a 30° or a 23° (23° is a weird spec), so I grabbed the 23° one from Raceworks I also grabbed 1mtr of 3" straight from Just Jap, I needed 350mm, but they only had 300mm, or 1mtr lengths....meh Also ordered a 1/2" hose bulkhead fitting from fleabay, this has a smoothish mushroom looking head (they are designed for below the water line of boats) that will fit inside the bend, the hose bit and threaded bit looks to long, but nothing that a hacksaw cannot fix if required, the hose will then just get jamed on the threaded bit up to the retaining nut Fingers crossed and the unsightly amount of hose clamps will be reduced down to 4 once all the parts arrive 
    • Oil change does not trigger code 21. Code 21 is for coilpacks primary side connection. You can try to clear the code with a battery disconnect, hold down the brake pedal to drain capacitors through the brake lights with the ignition on for 10-15 seconds before you reconnect the battery. I have seen R35 coil conversion permanently cause this code with no ill effects so it might be the resistance it wants to see isn't quite right on one or more coilpacks. Could be inside the ECU, could be the harness, could be a coil. You can test it all if you want or just ignore until the car actually starts misfiring.
    • I forgot you have a Nistune ECU. Use Nistune to do all the tests I mentioned instead of faffing with 30+ year old electrical connectors. You can read MAF volts off that too, there are reference values in the service manual to tell you roughly what it should be in different conditions.
    • No. I think it might be the AFM. Hence the use of the terms "swaptronics", which implies the use of swapping out electronics for the purpose of diagnosis. It's about the only way to prove that a small/niggling/whatever problem with an AFM or a CAS or similar is actually caused by that AFM/CAS/whatever. A known good item swapped in that still gives the same problem is likely to be caused somewhere else. They're all the same. Spraying AFMs with cleaner is an each way bet between cleaning it and f**king it.
    • Oh wow! This might actually work amazingly. Do you know the ratio of the diff? I was told the only thing you need to make sure of is if the front & rear diff ratios are the same. Ours is a 4.083 Thanks!
×
×
  • Create New...