Jump to content
SAU Community

Recommended Posts

Hi

Just wondering if i need to add some more oil since im running a HKS R Type oil cooler. I know std rb25 is 5.5L with filter but i am now running a s15 filter (its smaller) and the extra lines for the cooler

thanks

5.5L :P Pretty sure it is like 4.5L - 5.0L depending how you drain it (warm, cold, vacuum drain, gravity drain etc).

I just fill my cooler up seperately, since I take it off to drain it for an oil change (highly suggest this too, it's really not that hard if it's in an easy to get to place). Then put the usual 4.5 litres or so then run the car, let it cool down and then check the dipstick.

  • 1 year later...

sorry to dig up a new thread, im flushing my engine oil. wondering how much to re-fill

the oil in there has only done 30 dyno runs as it was used to just flush and clean the engine.

i found the norm is 4.5l for the engine, say 500ml for cooler +some for lines.

now im taking it to the track monday. so i was told to overfill.

how much would i put in? 5.5L? 6L?

stock sump btw

my 25 with hks type s cooler takes 6L abouts, I know its more than a single 5L oil container

oh yeah thats mounted in passenger side as well...

Edited by 75coupe

fill it to the hump on the dipstick, start it and let it run for a bit, then check the level again

no one can give you an amount in litres as it varies, mostly on how much oil was drained, ie is the cooler completely empty?

  • 3 weeks later...

Hi guys,

everyone is saying to put in extra oil then start the car and let it run, do i assume let it run all the way to operating temp as the HKS oil cooler has a thermostat built in meaning it will not fill the cooler until the thermostat opens.... this would mean your overfull until this opens correct?

Also wondering how the oil would drain from the cooler knowing that it is lower than the lines running to the oil filter and by means of gravity the oil would remain in the cooler?

sorry if these are noob questions my logic could be way off, i am looking at putting a cooler on very soon and have never had one to know the answers.

It doesn't unless you remove the oil cooler and pour it out.

Also most oil thermostats don't completely block of The oil cooler so it should start to fill as soon as you crank the engine.

When fitting new oil cooler kits I always disconnect the ignitor and fuel pump fuse and crank the engine for a while to pre fill the lines and cooler so the engine sees oil sooner rather than later when u fire it up properly

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • I got back to Japan in January and was keen to get back on track as quickly as possible. Europe is god-awful for track accessibility (by comparison), so I picked up a first-gen GT86 in December just to have something I could jump into right away. The Skyline came over in a container this time and landed in early January. It was a bit battered after Europe, though—I refused to do anything beyond essential upkeep while it was over there. The clutch master cylinder gave out, and so did the power steering. I didn’t even bother changing the oil; it was the same stuff that went in just before I left Japan the first time. Naughty. Power steering parts would’ve cost double with shipping and taxes, so knowing I’d be heading back to Japan, I just postponed it and powered through the arm workout. It took a solid three months to get the car back on the road. Registration was a nightmare this time around. There were a bunch of BS fees to navigate, and sourcing parts was a headache. I needed stock seats for shaken, mistakenly blew 34k JPY on some ENR34 seats—which, of course, didn’t fit—then ended up having the car’s technical sheet amended to register it as a two-seater with the Brides. Then there’s the GT86. Amazing car. Does everything I want it to do. Parts are cheap, easy to find, and I don’t care what anyone says—it’s super rewarding to drive. I’ve done a few basic mods: diff ratio, coilovers, discs, pads, seat, etc. It already had a new exhaust manifold and the 180kph limiter removed, so I assume it’s running some kind of map. I’ve just been thrashing it at the track non-stop—mostly Fuji Speedway now, since I need something with higher speed after all that autobahn time. The wheels on the R34 always pissed me off—too big, and it was a nightmare getting tires to fit properly under the arches. So I threw in the towel and bought something that fits better. Looks way cleaner too (at least to me)—less hotboy, less attention-seeking. Still an R34, though. Now for future plans. There are a few things still outstanding with the car. First up, the rear subframe needs an overhaul—that’s priority one. Next, I need to figure out an engine rebuild plan. No timeline yet, but I want to keep it economical—not cutting corners, just not throwing tens of thousands at a mechanic I can barely communicate with. And finally, paint. Plus a bit of tidying up here and there.  
    • Nope, needed to clearance under the bar a little with a heat gun, a 1/2" extension as the "clearancer", and big hammer, I was aware of this from the onset, they fit a 2.0 with this intake no problems, but, the 2.5 is around 15mm taller than a 2.0, so "clearancing" was required  It "just" touched when test fitting, now, I have about 10mm of clearance  You cannot see where it was done, and so far, there's no contact when giving it the beans Happy days
    • It's been a while since I've updated this thread. The last year (and some) has been very hectic. In the second-half of 2024 I took the R34 on a trip through Germany, Italy, France and Switzerland - it was f*cking great. I got a little annoyed with the attention the car was getting around Europe and really didn't drive it that much. I could barely work on the car since I was living in an inner-city apartment (with underground parking). During the trip, the car lost power steering in France - split hose - and I ended up driving around 4,000kms with no power steering.  There were a few Nurburgring trips here and there, but in total the R34 amassed just shy of 7,000kms on European roads. Long story short, I broke up with the reason I was transferred to Europe for and requested to be moved back to Japan. The E90, loved it. It was a sunk cost of around EUR 10,000 and I sold it to a friend for EUR 1,500 just to get rid of it quickly. Trust me, moving countries f*cking sucks and I could not be bothered to be as methodical as I was the first time around.
    • I assume clearances were all a-okay?
    • Shock tower brace is in +5Kw....LOL  
×
×
  • Create New...