Jump to content
SAU Community

Recommended Posts

Hey guys,

Recently at a car show my car lost power whilst going down the quatermile so I turned it off and rolled to the end... Turned the car over and it seemed to run ( only going 10kph) but felt like it was missing... Looked back and the car is pissing out black smoke. So i did a compression test and got 120-120-120-100-110-100 So not good..Also poured a small amount of oil in each after and all my readings went up around 150 indcaiting a large loss of compression probably my rings. So a rebuild is on the cards which is no problem but when i took it around the block afterwards to see if she'd run as soon as it got around 3000rpm it stalled ... then started back up and around the same rev range it stalled again... I can put my foot down and the engine almost seems to run normal then 3000ish and it just dies.

Is this normal?

Also im runnning a power fc and profec B.

All injectors,turbos,fuel pump,afms,coilpacks have less than 800k's on them.

Cheers.

Link to comment
https://www.sau.com.au/forums/topic/307794-32gtr-rings-turbo-or-more/
Share on other sites

yeah i'd start with checking the cooler piping, etc. sounds very much like a leak somewhere. black smoke is usually caused by major overfueling, which is what happens when a cooler pipe pops off, etc.

also check your afm readings on the pfc. may be that 1 of them has died, or the plug is faulty

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


×
×
  • Create New...