Jump to content
SAU Community

Recommended Posts

hey guys, was changing my plugs and i noticed that my plenum seems to have lifted by 2-3mm

is it something that i should just tighten and forget? does it need a new gasket? what could have caused the issue?

the car still makes and holds 18psi with no excess noise...

you can also see all the filth around the gasket

it is however probably 3-500rpm laggier... at first i thought i was just imagining it...

med_gallery_36777_3194_287857.jpg

med_gallery_36777_3194_304934.jpg

?

Link to comment
https://www.sau.com.au/forums/topic/308329-plenum-gasket-lifted-by-a-few-mm/
Share on other sites

shit.... just had a thought...

car was riching out and fouling plugs, so we retuned it from the ground up about 3 months ago...

is there any chance that air was escaping through the gasket and thus making the car rich?

because that means if i fix it then i'll be leaning the car out... :)

quick retune perhaps?

41jQywGYTmL._SL500_AA280_.jpgAlso, for this type of job and for almost any job, one of these bad boys are the ultimate. the whole case is around 60-70mm long and they fit in the tighest of tight places, yes where the sun does not shine.

Tough as nails, I regularly slug mine with a 4 pound hammer. Only goes up to 13mm But you can by extra sockets (any brand) if you need them bigger. this & a set of ratchet spanners is very handy indeed.

made by Teng tools.

Interesting, mine has the exact same thing going on hamish, and I also have the car runningly stupidly rich and fouling plugs all the time. It dosen't look like it would be a massive job to take it off, apart from the bolts lol, I'm used to having to pull my cooler piping and associated hosing all the time to get to the spark plugs anyway.

ratchet spanners are a must on a Skyline IMO, too fkn hard and complicated to do a lot of things otherwise.

tweak the outer ones and with the car idling spray aero start or brake / carb cleaner around the gap. If the idle lifts (or any perceptible change) you have a leak.

Remember the gasket is rubber and around 3mm thick so it should not look flush, but the oil around it is a bit sus :)

Mind you when we were chasing your leak on the dyno i remmember spraying cleaner around there and it was fine @ idle. (but it was not oily then) then we found the split cooler elbow.

Yeah what is with all that oily residue on the outside of the plenum :)

I think if the tune was thrown out by that the leak would have to be pretty substantial and you would notice is very easily. I wouldn't worry about the tune side of things, just fix it up and if you are worried chuck it back on Trents dyno.

Edited by PM-R33

REMEMBER.

There are 2 types of gaskets on the R33 skyline. One is completly all rubber and the other is rubber with metal bracing on the insides to keep its shape.

100% of the time i have seen the the complete rubber ones have leaked and caused ALL kinds of issue.

Do not start this job untill you get the gasket that has metal inside to keep its shape.

If you can bend the gasket """" IT IS THE WRONG ONE """"

And to rest your mind about the leaking issue (tuning).. when they leak from there the plenum will SCREAM "EEEEEEEEEEEEEEEEEEEEEEEEEEEEEEEEEEEEEEEEEEEEEEEEEE" very high pitched sound. (personal experience - hence the 2 types of gasket comment)

thanx ant :thumbsup: i'll make sure to check first!

i would have thought there would have been a noise if it was leaking too.... but the thing that gets me is the residue all around the gasket...

that engine bay copped 3 cans of degreaser only 6 months ago...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Back again. I returned to Japan in Jul/Aug to spend time with the car on my birthday and remind myself what all the sacrifice and compromise is for. It happened to line up with the monthly morning meet in Okutama, which I have been wanting to go to for a long time. It's a unique event at a unique spot with really rare, interesting, and quirky cars. It's where all the oldheads and OGs gather. The nighttime scene at DKF certainly has its place and should be experienced if you're into cars, but there's too much bad attention and negativity around it now. IMO the better time is Sunday morning at DKF or Okutama; it's more chill and relaxed. I'm glad I was finally able to go, but not sure it's worth the drive from all the way from Nagoya immediately the day before, unless I was already staying in Tokyo for the days right before the meet, because you have to wake up quite early to make it in time. Funnily enough though I didn't drive the car all that much this trip because it was just too damn hot. While there were zero issues and running temps were nominal and the A/C was strong, RBs already run crazy hot as it is. Sure, it took it all like a champ but something about driving these cars in the ridiculous heat/humidity bothers me and makes me feel like I'm asking too much of it. I'm just me being weird and treating the car like a living thing with feelings; I'm mechanically sympathetic to a fault. Instead I was mainly driving something else around - a KX4(silver) 2001 X-Trail GT, that I acquired in May. There's a few different flavors to choose from with Xs, but visually it's the Nissan version of the Honda CR-V. Mechanically it's a whole different story as this, being the top-trim GT, has an SR20VET mated to a four-speed auto and full-time AWD! It was a very affordable buy in exceptional condition inside and out, with very low mileage...only 48k kms. Most likely it was owned by an older person who kept it garaged and well-maintained, so I'm really happy with how it all worked out. It literally needs zero attention at the moment, albeit except for some minor visual touch-ups. I wanted something quirky, interesting, and practical and for sure it handily delivers on all three of those aspects. I was immediately able to utilize the cargo and passenger capacity to its full extent. It's a lot of fun to drive and is quite punchy through 1st and 2nd. It's very unassuming -in the twisty bits it's a lot more composed than one would think at a glance- and it'll be even better once I get better tires on it(yes, it's an SUV but still a little boat-y for my liking). So...now I have two golden-era Nissans in silver. One sports car and one that does everything else; the perfect two-car solution I think👍 The rest of the trip...I was able to turn my stressed brain off and enjoy it, although I didn't quite get to do as much as I thought. I did some interesting things, met some interesting people, and happened into some interesting situations however, that's all for another post though only if people really want to know. Project-wise, I went back to Mine's again to discuss more plans and am hoping to wrap that up real soon; keep watching this space if that interests you. Additionally, while working in the tormenting sweatbox that is the warehouse, I was able to organize most of the myriad of parts that my friend is storing for me along with the cars, and the 34 has a nice little spot carved out for it: And since it can get so stupid hot in there, that made it all the more easy -after I was standing there looking at the car and said 'f**k it'- to finally remove all the damn gauges that have mostly been an eyesore all this time. Huzzah. The heat basically makes the adhesive backing on the gauge mounts more pliable to work with, so it was far less stressful getting this done. I didn't fully clean it up or chase the wiring though; that will happen once I have the car in closer possession. Another major reason to remove all that stuff is to give people less reasons to get in my car and steal s**t while it's being exported/imported when/if the time comes, which leads us to my next point... ...and that is even though it's time in Japan is technically almost up since it's a November car and the X would be coming in March, I'm still not entirely sure where my life and career is headed; I don't really know what the future looks like and where I'm going to end up. I feel there's a great deal of uncertainty with me and as a result of that, it feels like I'm at a crossroads moreso now than any point in my life thus far and there are some choices I need to make. Yes, I've had some years to consider things and prepare myself, however too much has happened in that time to maintain confidence and everything feels so up in the air; tenuous one might say. Simply put, there's just too much nonsense going on right now from multiple vectors. Admittedly, I'm struggling to stay in the game and keep my eyes on the prize. So much so in fact, that very recently I came the closest I ever have before to calling it quits outright; selling everything and moving on and not looking back. The astute among you will pick up on key subtext within this paragraph. In the meantime I've still managed to slowly acquire some final bits for the car, but it feels nice knowing there's not much left to get and I'm almost across that finish line; I have almost everything I'll ever want for my interpretation and expression on what it is I think an R34 should be. 'til later.
    • Thanks for that, hadn’t used my brain enough to think about that. 
    • Also playing with fire if they start to flow more air down low than what the stock twins can. It's not even up top you need to worry, it can be at 3000rpm and part throttle and it's getting way more flow than it should.
    • Any G40/1000 or G40/1250 results out there?  
    • You still want a proper tune on the stock ECU though. Stock tune + stock ECU with GT-SS/-9s is probably playing with fire if you're running more than stock airflow/power.
×
×
  • Create New...