Jump to content
SAU Community

Recommended Posts

Same with all if the above... rebuilding the motor, and my engine builder recommended the ati over the Ross, however he did say the STD item would be fine for my application (again I didn't have a standard one and would prefer to purchase a new item over 2nd hand item).

  • 2 weeks later...

nice

I put down three large this week for the following:

* ati balancer

* hks pistons 87mm

* Attkd h-beam rods

* hks step-2 camshaft springs

* greddy cam gear cover

* hks oil pump

* apexi multichecker

* acl race bearings

* grex street special N1 camshafts

thought that was an awesome deal

however I wont be going 25/30 or 26/30, selling my built rb25 and building up a rb26

for auto awd stagea.

just need tomei head gasket kit, hks HD timing belt, tensioner kit, and N1 water pump.

then will port the head,

build the bottom end

?

?

underpants

?

profit

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • @GTSBoy Ok so that was the shops problem...they showed R33 rotors on R34 page and i did not know 296 do not fit(and are for R33) Yes i bought "kit" with rotors and pads. Pads are ok(i have GTT calipers front and rear). They have some 324mm but no 310mm. So i dont know if they would fit. I have 17inch LMGT4s So another question. Can i fit those in the rear or they are just "too" big for that?
    • I started removing the tank a while back with the intent to give it a proper clean. Got to a bolt that I couldn't undo completely due to a diff being in the way, so just said f**k it and siphoned the gluggy old fuel out and called it a day. Looking it the tank it looks less corroded than the one in the pics for that billet hanger from Frenchy's anyway. Isn't it the fuel filters job to worry about this stuff? I scraped off most the crusty shit of the hanger but will give it another go before reinstall coz maybe the fuel and return pipes are also full of gunk  
    • Pretty sure it is a common fault. I believe this is the only part you need, but don't quote me as I don't have a V36.  I also believe it is a bit of a pain to change and the device needs to be encoded to the car once it is replaced, so may need someone with the right tools. Buy Genuine Nissan 48700JF00D (48700-JF00D) Lock Set-Steering. Prices, fast shipping, photos, weight - Amayama
    • Pads for R32 GTS-t, R32 GT-R non V-Spec (Sumitomo), R33 GTS-t and R34 GT-t are all interchangeable. R34 GT uses a 2x piston caliper, hence it didn't fit.
    • Checked with amayama and nope, the full S2 manual set is not available anymore. Unsurprising, but still disappointing as the ? on availability gave a glimmer of hope.
×
×
  • Create New...