Jump to content
SAU Community

Recommended Posts

Interested to hear from those who have tried it locally (prefer sydney).

I know martin has had success but would like to hear from "end users" too.

If so, how did you found the practical realities; any tune compromises (cold start, driveability, whatever). What injectiors/fuel pumps you went with, sourcing fuel in Sydney (still only one location?) and is it believed that the quality and supply of the fuel is good/consistent?

How would you manage swapping fuels or do you run e85 full time?

thoughts?

Link to comment
https://www.sau.com.au/forums/topic/317603-e85-for-r35/
Share on other sites

I cant speak for R35's but i've done this to my R32.

Sourcing fuel isnt that big of a deal, go and get a big drum of it for your first fill (this can be delivered full, or ive got an empty one here you can have for free, just come take it), then a heap of jerry cans. Whenever the drum is getting a bit low just take a quick trip to Rozelle (open 24/7) and fill them all up, then come back home and use a fuel jiggler to move the fuel to the drum then seal the drum up, your hands wont even get dirty. Or you could leave the fuel in jerry cans until its needed but ive done this and the jerry cans expanded big time (i left them in the car overnight and it was lunchtime the next day in the sun when i remembered). Even in my commodore (which is smaller than your holden) its easy to fit 6 or 7 jerry cans without using the boot, i prefer them jammed in tight incase there's a sharp corner etc. Using the boot, well, then you'd be able to bring back more than enough. Ive seen one guy at the servo with a red holden SS ute, he had a 44gal drum installed somehow (probably just a braket and some welding) into the tray, he was standing in the tray just filling up the drum - it took ages but i dont think he cares.

Your place is very close to the way i go to rozelle (on the eastern distributor, always get dinner in the city in the same trip), so im happy to help out if you like?!

From the tuner's comments, there's just SO much more to get out of this fuel, i had an exhaust restriction so we stopped, but other than that there was no pinging and with every dyno run it was making more and more power/torque.

I used Injector Dynamics 2000cc injectors, and 2 bosch 044's mounted in a surge tank. I had rochester 1000's in there on pump 98 which maxed out at around 400rwkw on the very first dyno run. The 2000's actually have better idle, better low rpm control and of course more flow. Interestingly, the fuel consumption isnt as bad as the 1000's and its making more power now. Goes to show how good the ID's really are.

The car will be back there as soon as the new exhaust is made.

Link to comment
https://www.sau.com.au/forums/topic/317603-e85-for-r35/#findComment-5191946
Share on other sites

Also, i had an idea to get a few of these brackets and get them mounted in the car where the backseat usually goes;

FRUN2012.jpg

I figured, that gives a super long range, and while it looks a bit crappy in a nice GTR, once im at the track, just take them out along with all the other crap inside the car then leave the jerry's in the garage/pits. The downside is that then the brackets are in there for good. I personally dont care about that as they'd weight so little, but still havnt taken the plunge yet

Link to comment
https://www.sau.com.au/forums/topic/317603-e85-for-r35/#findComment-5192007
Share on other sites

950cc's for E85?

That doesnt sound right, maybe its an R35 specific thing, but my 1000's maxed out as i said around 400rwkw which is close enough to what you guys have standard

What duty cycle are those 950's running at?

Link to comment
https://www.sau.com.au/forums/topic/317603-e85-for-r35/#findComment-5192012
Share on other sites

Duncan, check schedule G before you move to E85. It is not legal in production cars because it does not meet the requirements for "pump fuel":

2.1 Pump Fuel: A commercial fuel (as defined above) available for sale on demand from a roadside retail bowser

outlet at each of at least five separate service stations in each of at least three Australian States. A mixture of

Pump Fuels with the same hydrocarbon profile is permitted (eg, brands of ULP may be mixed; ethanol-blended

fuels, ULP or diesel may not be mixed).

It may however meet the requirements for "commercial fuel" if that is what your supersprint regs specify:

2. Commercial Fuel: Petrol, automotive diesel, liquefied petroleum gas (LPG) or ethanol blended fuel, eg, “E85”

(as defined below) produced by an oil company and available for commercial sale in all States and mainland

Territories of Australia.

Not sure if it is actually "available" in all states, or what "available" actually even means. On the bright side it specifically mentions E85 so it may be OK.

Link to comment
https://www.sau.com.au/forums/topic/317603-e85-for-r35/#findComment-5199297
Share on other sites

btw its not on topic....but it shits me deeply.....

vp102 at about $4 a litre meets the requirements for pump fuel but E85 at $1/l does not. CAMS are almost as bad as ANDRA who ban it outright (the ANDRA fuel committee is run by the WA distributor of VP race fuels....)

Link to comment
https://www.sau.com.au/forums/topic/317603-e85-for-r35/#findComment-5199306
Share on other sites

  • 3 months later...

I have Id1000s and will try E85 at track tomorrow. But on 98 noticest problems with long cold starts and hot starts . Also momentary loss of power at different areas on the rpm curve mostly under light acceleration loads but it also happens at 3500 and 4500 rpm at 50-75% thottle. This doesn't seem reproducable on the dyno.

It may actually be the clutch pulling in for a split second.

anyone have any ideas, or similar experience with large injectors running on 98?

Link to comment
https://www.sau.com.au/forums/topic/317603-e85-for-r35/#findComment-5382444
Share on other sites

btw its not on topic....but it shits me deeply.....

vp102 at about $4 a litre meets the requirements for pump fuel but E85 at $1/l does not. CAMS are almost as bad as ANDRA who ban it outright (the ANDRA fuel committee is run by the WA distributor of VP race fuels....)

not much of a 'conflict of interest' there? noooooo....

Link to comment
https://www.sau.com.au/forums/topic/317603-e85-for-r35/#findComment-5382500
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • A 1.5 way is a 2 way. It is just a 2 way with a less aggressive ramp on overrun.
    • The ABS and/or TCS being missing/broken will not cause the engine to misbehave. It just casues CEL to come on and annoy you. The CEL is useless if it is always on, so you have to do the things you have to do to get rid of it, so it can be useful. Being a Stag ECU, then yes, it will not expect TCS to be present. But it will expect ABS to be present and working. You will need to either make the ABS CU talk to the ECU (don't ask me what that will take on an NA R34), and make sure the hardware is working....or, you just need to blank it out in Nistune. Do not persist with the stock ECU. You will just have problems. Gte it Nistuned. Start from there. DO YOU HAVE A BOOST SENSOR? The ECU's boost sensor that it. It is connected to the loom at the rear of the coil cover. Usually rides on the firewall on an R34, but is usually bolted down to a bracket along with all the other crap at the back of the coil cover when a Neo is dropped into another car. If you do not have it, the ECU will shit the bed. So, do you have one?
    • So sadly the fuel pump etc was not it. The pump and filter is new and it is still cutting around 4000 rpm. A read something about ABS/TCS (engine is from stagea and ECU too so no TCS) and i dont know for 100% that my car has ABS. It has ABS "cube" in engine bay but i dont think it works(or at least from my braking experience). Can be something like that?  I will be driving the car next week to Nistune tuner to properly see what is wrong...  
    • the Tomei LSD fluid with lsd kit. frustrated that it was shaking the car to crap and affecting everything else negatively, I pulled the diff last night, and removed the lsd carrier, could not find anything wrong, however it seem to be 100 locked up acceleration, and deacceleration, wondering if they sent me a 2 way not a 1.5??  either way I installed the stock open carrier back in place. test drove everything smooth as butter again. no shake, shutter, random, what felt like clutch slip and grab or drive shaft play, etc. something differently wrong in side the lsd. I might bother taking it apart (if possible) to figure out what's going on inside this carrier, as bought too long ago to return.  only draw back is its back to a one wheel wonder.
×
×
  • Create New...