Jump to content
SAU Community

Recommended Posts

a lot of missinformation in that thread.

the compression ratio is the same between the neo and older rb25's.

turbo is different. head has solid lifters and different cams. intake manifold is a better design.

rods are suppose to be GTR rods.. but ive never yet had that confirmed. pistons are the same as is the block.

one has 206 kw . one has 184 . nuff said .

what exactly do you want to know ?

lots of random stuff

neo head has bigger exhaust valves than gtr, combustion chamber is a lot smaller , top feed injectors , new cas . no coil bracket . coils bolt straight to head . takes gay lil oil filter . has bigger exhaust housing on turbo .

RB25DET NEO runs hot burn technology, basically the gases burn at a higher temp which causes less emissions-not sure how that works but it does-closer to EU standards

Which is why the Neos seem to have an 80-82deg thermostat as opposed to the earlier 76.5deg ones.

one has 206 kw . one has 184 . nuff said .

You do realize that the above information is irrelevant dont you? That 22kw would be like pissing in the wind for the R33 motor to make with the most minor of changes to the ecu.

As per OP, major differences with the neo is the head and intake. The neo head has a smaller dome in the and will not work with such things as RB26 pistons etc. The intake manifold is said to be more efficient and uses top feed injectors which are cheaper to outsource.

End result of similarly modified motors is relatively similar :cool:

a lot of missinformation in that thread.

the compression ratio is the same between the neo and older rb25's.

turbo is different. head has solid lifters and different cams. intake manifold is a better design.

rods are suppose to be GTR rods.. but ive never yet had that confirmed. pistons are the same as is the block.

Pistons are definately N1 so they are not the same. Oil pump is a N1 with a small crank collar.... can't remember rods.

bit off topic. but i didnt realise the r33 and r34 gear boxes were a bit different. i got this from a nissan review of thr r34

quote.

Shot peening is applied to the first, second, third and fifth gears of the manual transmission for improved strength and durability to accommodate the higher engine torque. A double cone synchronizer is also provided in the first gear position, in addition to those previously used in the second and third gear positions, for smoother, easier shifting. Moreover, a pull-type clutch for easier operation has been adopted in the manual transmission on turbocharged models.

I don't know the full history of my engine, it has about 120 000kms on it. It had a genuine head gasket, bearings and timming belt in it So it doesn't look like the engine has been pulled apart.

I realise the difference between the pistons, my pistons have the thinker top ringland. (should of said N1 type pistons)

Also is "n" with a single dot above it are the markings for N1?Because my oil pump also has this marking.

I could be wrong.... would be keen to hear from someone who has actually pulled a Neo apart.

I'll be able to throw up a few pictures on here in a week.....

Edited by aleks

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Well, I can recommend the partial AV system translation CD I ordered from Car Audio Workshop in NZ. Whilst it didn't address the date issue, it has conveniently translated on-screen menu items into English, and now allows the GPS-received time to be offset in hours rather than minutes, so I can display Eastern Australian time accurately ( and bump it by another hour when daylight savings starts ).
    • Yuh, if it's 45°C outside, my car is driving in it.
    • I'd be curious to hear more. Otherwise, have you driven a modern x-trail? I wonder how it compares. Here in Australia they are/were popular for rentals and fleet vehicles. I have been in some and my impression was they are bad. But, this may have been very different in the 2000s at a good trim level. Twenty years is plenty of time to make the model worse. I do very much agree with the 2 silver cars in the garage approach. But, not driving because it's too hot would not leave a lot of time in the year for many Australians. I don't think you need to worry too much unless the car has actual issues with overheating. 
    • Back again. I returned to Japan in Jul/Aug to spend time with the car on my birthday and remind myself what all the sacrifice and compromise is for. It happened to line up with the monthly morning meet in Okutama, which I have been wanting to go to for a long time. It's a unique event at a unique spot with really rare, interesting, and quirky cars. It's where all the oldheads and OGs gather. The nighttime scene at DKF certainly has its place and should be experienced if you're into cars, but there's too much bad attention and negativity around it now. IMO the better time is Sunday morning at DKF or Okutama; it's more chill and relaxed. I'm glad I was finally able to go, but not sure it's worth the drive from all the way from Nagoya immediately the day before, unless I was already staying in Tokyo for the days right before the meet, because you have to wake up quite early to make it in time. Funnily enough though I didn't drive the car all that much this trip because it was just too damn hot. While there were zero issues and running temps were nominal and the A/C was strong, RBs already run crazy hot as it is. Sure, it took it all like a champ but something about driving these cars in the ridiculous heat/humidity bothers me and makes me feel like I'm asking too much of it. I'm just me being weird and treating the car like a living thing with feelings; I'm mechanically sympathetic to a fault. Instead I was mainly driving something else around - a KX4(silver) 2001 X-Trail GT, that I acquired in May. There's a few different flavors to choose from with Xs, but visually it's the Nissan version of the Honda CR-V. Mechanically it's a whole different story as this, being the top-trim GT, has an SR20VET mated to a four-speed auto and full-time AWD! It was a very affordable buy in exceptional condition inside and out, with very low mileage...only 48k kms. Most likely it was owned by an older person who kept it garaged and well-maintained, so I'm really happy with how it all worked out. It literally needs zero attention at the moment, albeit except for some minor visual touch-ups. I wanted something quirky, interesting, and practical and for sure it handily delivers on all three of those aspects. I was immediately able to utilize the cargo and passenger capacity to its full extent. It's a lot of fun to drive and is quite punchy through 1st and 2nd. It's very unassuming -in the twisty bits it's a lot more composed than one would think at a glance- and it'll be even better once I get better tires on it(yes, it's an SUV but still a little boat-y for my liking). So...now I have two golden-era Nissans in silver. One sports car and one that does everything else; the perfect two-car solution I think👍 The rest of the trip...I was able to turn my stressed brain off and enjoy it, although I didn't quite get to do as much as I thought. I did some interesting things, met some interesting people, and happened into some interesting situations however, that's all for another post though only if people really want to know. Project-wise, I went back to Mine's again to discuss more plans and am hoping to wrap that up real soon; keep watching this space if that interests you. Additionally, while working in the tormenting sweatbox that is the warehouse, I was able to organize most of the myriad of parts that my friend is storing for me along with the cars, and the 34 has a nice little spot carved out for it: And since it can get so stupid hot in there, that made it all the more easy -after I was standing there looking at the car and said 'f**k it'- to finally remove all the damn gauges that have mostly been an eyesore all this time. Huzzah. The heat basically makes the adhesive backing on the gauge mounts more pliable to work with, so it was far less stressful getting this done. I didn't fully clean it up or chase the wiring though; that will happen once I have the car in closer possession. Another major reason to remove all that stuff is to give people less reasons to get in my car and steal s**t while it's being exported/imported when/if the time comes, which leads us to my next point... ...and that is even though it's time in Japan is technically almost up since it's a November car and the X would be coming in March, I'm still not entirely sure where my life and career is headed; I don't really know what the future looks like and where I'm going to end up. I feel there's a great deal of uncertainty with me and as a result of that, it feels like I'm at a crossroads moreso now than any point in my life thus far and there are some choices I need to make. Yes, I've had some years to consider things and prepare myself, however too much has happened in that time to maintain confidence and everything feels so up in the air; tenuous one might say. Simply put, there's just too much nonsense going on right now from multiple vectors. Admittedly, I'm struggling to stay in the game and keep my eyes on the prize. So much so in fact, that very recently I came the closest I ever have before to calling it quits outright; selling everything and moving on and not looking back. The astute among you will pick up on key subtext within this paragraph. In the meantime I've still managed to slowly acquire some final bits for the car, but it feels nice knowing there's not much left to get and I'm almost across that finish line; I have almost everything I'll ever want for my interpretation and expression on what it is I think an R34 should be. 'til later.
    • Thanks for that, hadn’t used my brain enough to think about that. 
×
×
  • Create New...