Jump to content
SAU Community

Recommended Posts

  • Replies 42
  • Created
  • Last Reply

Top Posters In This Topic

1996 R33 GTS-T Series 2

19 inch Volk Racing Wheels 275/30/19 and 240/35/19

HKS Twin plate clutch

Blitz exhaust with HKS dump pipe

HKS Turbo timer

HKS Electronic Valve Controller

HKS Air filter

Blitz Boost gauge

Adjustable GAB suspension

Side skirts

Strut Brace

5 speed

Immaculate not a mark on it

48,000 km

$25,500 or

$23,000 without wheels

ph 0418 201 478

I'm not quite sure what sort the are. They're 5 spoke with allen keys around the outside and they're 9.5 rear and 8.5 front. I'm not going to sell the wheels unless the person who buys the car doesn't want them with it.

  • 3 weeks later...
Guest INASNT
what type of wheels are they? TE-37 ?  

if so.. please pm me.. i have an offer to buy them off you~ and ill give you a set of 17inch AVS rims to feel in for the wheels

same deal but i got 17inch oz racing rims to trade.

Just post the pics up on this thread. Use photoshop to reduce the size so they can be uploaded.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • There are black hose clamps as well if you care. Plazmaman for example sells some: https://plazmaman.com/product/black-hose-clamps-premium-quality-stainless-breeze/
    • After using a protractor for an actually accurate assessment of what is required,  and by NOT using my uncalibrated eyeball I worked out I need a 25° silicone bend from the TB ro the MAF, but, my choice was either a 30° or a 23° (23° is a weird spec), so I grabbed the 23° one from Raceworks I also grabbed 1mtr of 3" straight from Just Jap, I needed 350mm, but they only had 300mm, or 1mtr lengths....meh Also ordered a 1/2" hose bulkhead fitting from fleabay, this has a smoothish mushroom looking head (they are designed for below the water line of boats) that will fit inside the bend, the hose bit and threaded bit looks to long, but nothing that a hacksaw cannot fix if required, the hose will then just get jamed on the threaded bit up to the retaining nut Fingers crossed and the unsightly amount of hose clamps will be reduced down to 4 once all the parts arrive 
    • Oil change does not trigger code 21. Code 21 is for coilpacks primary side connection. You can try to clear the code with a battery disconnect, hold down the brake pedal to drain capacitors through the brake lights with the ignition on for 10-15 seconds before you reconnect the battery. I have seen R35 coil conversion permanently cause this code with no ill effects so it might be the resistance it wants to see isn't quite right on one or more coilpacks. Could be inside the ECU, could be the harness, could be a coil. You can test it all if you want or just ignore until the car actually starts misfiring.
    • I forgot you have a Nistune ECU. Use Nistune to do all the tests I mentioned instead of faffing with 30+ year old electrical connectors. You can read MAF volts off that too, there are reference values in the service manual to tell you roughly what it should be in different conditions.
×
×
  • Create New...