Jump to content
SAU Community

Recommended Posts

hey everyone just about finished my build and am stuck on some wiring, was just wondering if some out there can help it would be much appreciated

so i've got the 26/30 sitting in the car everything else is done just stuck on the aac valve wiring, now i got the r32 gtr engine loom and put it in and there is a 8 pin plug just before u get to the injector plugs that i have traced the aac valve wining to from the ecu, now from there i am guessing that there is supposed to be something that plugs into it and goes down to the aac valve and all the knock sensors and shit, i dont have that part.

how am i ment to wire up the aac valve???

can someone please post up some info they have and pics would be much appreciated.

thanks blocka

here's me engine bay

post-45830-1283260907_thumb.jpg

Link to comment
https://www.sau.com.au/forums/topic/335056-r32-gtr-loom-into-r32-gtst/
Share on other sites

you are missing a section of the loom, unfortunately. you can either bodgey something up (hard without the plugs) or try and find one

For the record my r32 gtr idles happily at 1000rpm without even the vacum box etc. just the plenum (all holes blocked obviously) with standard ecu

thanks for the input JEFFWORLD2 but i would like to have it wired up,

yeah STATUS it would be the knock sensor loom \

if anyone has any pics of both sides of that 8 pin plug or any wiring diagrams that would be ace

cos i know that the aac valve has a signal from the ecu but dont know weather the other side is a 5v or an earth

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Hi. Sry iam not a mechanic and iam not at the car atm so i dont know 100% but they told they measure those and even try to change those. AFM they have two. Coils are new a they have my old one too. Plugs too. ECU...we have 25 NEO stock and Nistune 25 NEO.   But i dont know if any one those could be the problem and why/if/what can cause this, Only thing they did not check is fuel...but that walbro 255 is new(like 1,5 years)... That fuel pressure gauge idk...but i let them know Any suggestions?   EDIT: how can they know if it is like you say he ECU pull power when it reaches a specific boost level that is too high? Tha car has boost controler
    • Can you clarify what you mean by boost cut, do you mean it misfires both when under load (driving) and when stationary and out of gear? Or does the ECU pull power when it reaches a specific boost level that is too high (boost control issue)? Does it occur at idle with no throttle? When you say "the ECU is OK", what ECU is it and why do you think it is OK? Have you used the NEO ECU, and if so do you have a MAP sensor attached? Same for the AFM, why do you think it is OK? Do you have any way to put a fuel pressure gauge on it (even just a mechanical one between the fuel filter and fuel rail)?
    • Hi.. Just another problem. So maybe you can help. I(my mechanic) done swap from my RB20DE NEO to RB25DET NEO. Everything is OK but we have a boost cut. Coils/Plugs are ok...AFM is ok. ECU is ok. I have Walbro 255 but it "changed" sound few months ago(you can hear it ouside) you did not hear that when it was new(maybe faulty?) Sooo...what now? What can cause this boost cut? It is even when you standing still...
×
×
  • Create New...