Jump to content
SAU Community

Recommended Posts

yeah man it sucks but the police are no involved so hopefully they get the f**ker. So looks like I wont be doing the 42r setup on the car as the manifold and gate where the last things in needed. Looking at putting standard twins on the car now to get it going :/

  • Replies 75
  • Created
  • Last Reply

Top Posters In This Topic

natett: just means more money that I now have to find to fork out. Ill see what happens im in no rush atm as I was looking at getting the car up and running by chrissy. I was looking at buy a 6boost mani and gate off another forum member but after what ive just been through I dont think I could waste that much money again :laugh:

The Quick spool valve goes between the turbo and manifold.

A valve closes on side of the manifold so the turbo spools up quicker, once boost gets into positive pressure the valve opens allowing full potential of the turbo.

Basically you can make 800rwhp and have it on full boost by 4000rpm :(

a lot of the supra guys in the US have used them. and the mega dollar supra build on here has 2.

they seem to show some impressive gains through the mid range however there isnt much info on them being used daily etc

when i go 3.4 ill be using one but thats another 12 months away haha

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Working through possible solutions of converting my mechanical speedo.    Anyone know what type of speedo sensor the factory r34 gtr getrag has ? what the output is ? I assume its not a VSS and more a voltage like earlier speedo sensors ? Can an ECU read it ?  
    • roof rail delete used to be a thing, they were made locally for a while too
    • I can get more photos of it here soon and I plan to make a thread detailing the process. I received the car this way and it sorely needs refinishing. That is probably the most appealing photo of it. Up close it is fading, cracked, and needs to be re-glued. Depending on their condition I'm on the fence between refinishing or making a new set.  Another angle hiding the pimples and razor pumps  
    • According to this thread the RS4V with build plate RC40 comes with the R200 diff @ 4.083 ratio as well (mine has said RC40 denotation). We may need to check if the axle stubs are the same pattern as well. The auto subframes have longer axles. However I think yours being a later Series 2 as well, we should have the same bolt pattern for the diff stubs. Unless your upgraded rear also has upgraded axles. Either way, I would not be opposed to pulling the covers to check so I can inspect that  fancy rear core  Also I don't have HICAS. I don't believe that should change things but I hope the people here with heaps more experience than me can correct me if I'm wrong   Let me know if you want to attempt to make this work and I can get some pictures of mine from under the car. 
    • It's not that straightforward. For example I have had this code because my ignitor/power transistor wires were unplugged. It knows something is wrong but has no idea what it means. If you want to actually diagnose this I recommend following the service manual flowchart for code 21. Ohm out the harness, coilpacks, inspect the ECU, etc. And again, it's entirely possible for there to be no problem at all but if you're running a different coilpack it'll trigger the code because it doesn't like what it sees.
×
×
  • Create New...