Jump to content
SAU Community

Anyone got a 0-100 time on na 33?

Jolinator

By Jolinator,
in Engines & Forced Induction

 Share

Recommended Posts

skyla Community Regular

skyla

Posted
Posted

I've just brought a G-Tech, a week ago haven't played too much yet the 0-100 times haven't been too good though been getting mid 8's. But mines a heavy 4dr and thats with tool boxes, spare tyre, and the sub box still in the boot.

For the 1/4 mine has done 16 flat at the strip, on the G-Tech it's done 16.1.

pstanbis Enthusiast

pstanbis

Posted
Posted

Just got an Apexi RSM (not as acurate as a G-tech, but not bad) and i managed 8.6 to the 100, with full tank, subs+box and all the rest of the stuff most daily drivers are full of. haven't tried a 0-400 yet, but i don't think it wil be all that flash...

NA_R33 Grand Master

NA_R33

Posted
Posted

definately not as fun with out the gas in the car cause the timing is retarded, although my timing is at stock rather then retarded cause i normally run it at 19 degreese where as stock is 15 and u notice the difference in power, though if ur car doesnt have the timing advanced it wont make ne difference. If thats what u were asking. Other option is rb 30 with ur head, im putting my 25de head on a rb30 very soon, before i start ill strip back the rb30 replace bearings balance the crank and shot peen the rods and wack some new rings in. then ill hopefully be in the 14's without gas and definately below with gas so like mid to high 13's very soon.

Jolinator Proficient

Jolinator

Posted
  • Author
Posted

ya tis first car, no one will touch me on a 32 turbs, im thinking ill get a 33 na, hide a nos kit in the partition between the boot, maybe a 5lb bottle, not sure

yo is 100hp shot safe :)?

also how many quater mile runs are you getting with the 75hp shot ?

have you checked out that zex pod filter with the n20 jet in the end, looks very interesting!

NA_R33 Grand Master

NA_R33

Posted
Posted

no 100hp definately no safe on a NA, 75 is probably pushing it but i got 14.08 at the test n tune tonight with a shit start and shit 60ft so im thinking i can break into 13's just if i get everything perfect.

NA_R33 Grand Master

NA_R33

Posted
Posted

Gearbox is the only thing im unsure about ill just see how it goes, seems to be holding up with the nos alright. Clutch is fine cause its a really tuff item i got put in a while ago. im hopefully getting an rb30 for free, ill have to pay for the rods to be shotpeened, crank balanced, new bearings and new rings and some extractors, all up like 600 dollars as i will do all the change over including porting and polishing my head myself with some help from my boss.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • Dose Pipe Sutututu
      Dose's Sometimes DIY and Pay Someone Home & Boat Improvement Thread

      By Dose Pipe Sutututu · Posted

      Wife wanted basket things in the wardrobe in our temporary house. Thought about ripping our the wardrobe and fitting the entire IKEA set, but it's a temporary house and we want to move in a few years. So IKEA advertises this as a 50cm unit, however the actually basket and rails measure 46cm wide. Only issue was depth, IKEA stuff is quite deep, where as the builder special junk is super shallow at less than 40cm. Send it, chopped the rails, then offset the mounting holes, job done, happy wife, less shit scattered all over the bedroom. Did the same to the other side too. Also drove the Skyline shit box today, dropped off oil at Supercheap Auto. I didn't realise they only now take max 2x bottles per visit. I visited 2x Supercheap Autos.  
    • Kinkstaah
      Strange issue RB25DET wont start

      By Kinkstaah · Posted

      I've seen similar actually in my situation. You never know what tables are attempted to be used when the car thinks it's -99C or +200C. The fail state is not usually that extreme but you know what I mean - it was in my case though! This is where being able to read all the sensors is useful cause you see this stuff really quickly.
    • Kinkstaah
      First time Skyline owner

      By Kinkstaah · Posted

      The above is very important. However as long as you keep timing relatively low, it's plausible to make your own knock ears and plausible to learn to tune with a modern ECU that can do wideband O2 correction like a boost controller. I mean if you only have one viable road to even drive the car on, learning to tinker to this level may be worth doing given you can't do much else with the car...?
    • Kinkstaah
      Chris' Toyota Mark ii JZX110

      By Kinkstaah · Posted

      I find the fact that the rear plate has to be bent inwards at the rear not so bad: but the front is just awful: It's like come on. (these are my very old, now retired/turned in plates) TBH it is a lot of money to fix a minor issue, the fact I said "I'll never really spend the money on doing this" is why people ended up buying them as a gift for a 'car guy' who can be hard to shop for.. for car guy things.
    • GTSBoy
      Chris' Toyota Mark ii JZX110

      By GTSBoy · Posted

      I just bent the ends of my premo plates. It even went through Regency like that after the engine conversion and the inspector (a great bloke!) just squinted his eyes and said "I didn't see that". Plates, and how they look, are just something that have zero importance to me.
×
×
  • Create New...