Jump to content
SAU Community

Anyone got a 0-100 time on na 33?

Jolinator

By Jolinator,
in Engines & Forced Induction

 Share

Recommended Posts

skyla Community Regular

skyla

Posted
Posted

I've just brought a G-Tech, a week ago haven't played too much yet the 0-100 times haven't been too good though been getting mid 8's. But mines a heavy 4dr and thats with tool boxes, spare tyre, and the sub box still in the boot.

For the 1/4 mine has done 16 flat at the strip, on the G-Tech it's done 16.1.

pstanbis Enthusiast

pstanbis

Posted
Posted

Just got an Apexi RSM (not as acurate as a G-tech, but not bad) and i managed 8.6 to the 100, with full tank, subs+box and all the rest of the stuff most daily drivers are full of. haven't tried a 0-400 yet, but i don't think it wil be all that flash...

NA_R33 Grand Master

NA_R33

Posted
Posted

definately not as fun with out the gas in the car cause the timing is retarded, although my timing is at stock rather then retarded cause i normally run it at 19 degreese where as stock is 15 and u notice the difference in power, though if ur car doesnt have the timing advanced it wont make ne difference. If thats what u were asking. Other option is rb 30 with ur head, im putting my 25de head on a rb30 very soon, before i start ill strip back the rb30 replace bearings balance the crank and shot peen the rods and wack some new rings in. then ill hopefully be in the 14's without gas and definately below with gas so like mid to high 13's very soon.

Jolinator Proficient

Jolinator

Posted
  • Author
Posted

ya tis first car, no one will touch me on a 32 turbs, im thinking ill get a 33 na, hide a nos kit in the partition between the boot, maybe a 5lb bottle, not sure

yo is 100hp shot safe :)?

also how many quater mile runs are you getting with the 75hp shot ?

have you checked out that zex pod filter with the n20 jet in the end, looks very interesting!

NA_R33 Grand Master

NA_R33

Posted
Posted

no 100hp definately no safe on a NA, 75 is probably pushing it but i got 14.08 at the test n tune tonight with a shit start and shit 60ft so im thinking i can break into 13's just if i get everything perfect.

NA_R33 Grand Master

NA_R33

Posted
Posted

Gearbox is the only thing im unsure about ill just see how it goes, seems to be holding up with the nos alright. Clutch is fine cause its a really tuff item i got put in a while ago. im hopefully getting an rb30 for free, ill have to pay for the rods to be shotpeened, crank balanced, new bearings and new rings and some extractors, all up like 600 dollars as i will do all the change over including porting and polishing my head myself with some help from my boss.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • RP1421
      S15 Spec R

      By RP1421 · Posted

      As discussed in the previous post, the bushes in the 110 needed replacing. I took this opportunity to replace the castor bushes, the front lower control arm, lower the car and get the alignment dialled in with new tyres. I took it down to Alignment Motorsports on the GC to get this work done and also get more out of the Shockworks as I felt like I wasn't getting the full use out of them.  To cut a very long story short, it ended up being the case the passenger side castor arm wouldn't accept the brand new bush as the sleeve had worn badly enough to the point you could push the new bush in by hand and completely through. Trying a pair of TRD bushes didn't fix the issue either (I had originally gone with Hardrace bushes). We needed to urgently source another castor arm, and thankfully this was sourced and the guys at the shop worked on my car until 7pm on a Saturday to get everything done. The car rides a lot nicer now with the suspension dialled in properly. Lowered the car a little as well to suit the lower profile front tyres, and just bring the car down generally. Eternally thankful for the guys down at the shop to get the car sorted, we both pulled big favours from our contacts to get it done on the Saturday.  Also plugged in the new Stedi foglights into the S15, and even from a quick test in the garage I'm keen to see how they look out on the road. I had some concerns about the length of the LED body and whether it'd fit in the foglight housing but it's fine.  I've got a small window coming up next month where I'll likely get a little paint work done on the 110 to remove the rear wing, add a boot wing and roof wing, get the side skirt fixed up and colour match the little panel on the tail lights so that I can install some badges that I've kept in storage. I'm also tempted to put in a new pair of headlights on the 110.  Until then, here's some more pictures from Easter this year. 
    • joshuaho96
      R32 GTS (RB20DE) Injectors Replacement

      By joshuaho96 · Posted

      I would put a fuel pressure gauge between the filter and the fuel rail, see if it's maintaining good fuel pressure at idle going up to the point when it stalls. Do you see any strange behavior in commanded fuel leading up to the point when it stalls? You might have to start going through the service manual and doing a long list of sensor tests if it's not the fuel system for whatever reason.
    • perry_r33
      R34 GTR Vspec Garage Sale - All must go!

      By perry_r33 · Posted

      Pm sent 
    • Robot
      Skyline v36 350GT sedan hunting on idle

      By Robot · Posted

      Hi,  Just joined the forum so I could share my "fix" of this problem. Might be of use to someone. Had the same hunting at idle issue on my V36 with VQ35HR engine after swapping the engine because the original one got overheated.  While changing the engine I made the mistake of cleaning the throttle bodies and tried all the tricks i could find to do a throttle relearn with no luck. Gave in and took it to a shop and they couldn't sort it. Then took it to my local Nissan dealership and they couldn't get it to idle properly. They said I'd need to replace the throttle bodies and the ecu probably costing more than the car is worth. So I had the idea of replacing the carbon I cleaned out with a thin layer of super glue and it's back to normal idle now. Bit rough but saved the car from the wreckers 🤣
    • GabsReDeal
      R32 GTS (RB20DE) Injectors Replacement

      By GabsReDeal · Posted

      After my last update, I went ahead with cleaning and restoring the entire fuel system. This included removing the tank and cleaning it with the Beyond Balistics solution, power washing it multiple times, drying it thoroughly, rinsing with IPA, drying again with heat gun and compressed air. Also, cleaning out the lines, fuel rail, and replacing the fuel pump with an OEM-style one. During the cleaning process, I replaced several hoses - including the breather hose on the fuel tank, which turned out to be the cause of the earlier fuel leak. This is what the old fuel filter looked like: Fuel tank before cleaning: Dirty Fuel Tank.mp4   Fuel tank after cleaning (some staining remains): Clean Fuel Tank.mp4 Both the OEM 270cc and new DeatschWerks 550cc injectors were cleaned professionally by a shop. Before reassembling everything, I tested the fuel flow by running the pump output into a container at the fuel filter location - flow looked good. I then fitted the new fuel filter and reassembled the rest of the system. Fuel Flow Test.mp4 Test 1 - 550cc injectors Ran the new fuel pump with its supplied diagonal strainer (different from OEM’s flat strainer) and my 550cc injectors using the same resized-injector map I had successfully used before. At first, it idled roughly and stalled when I applied throttle. Checked the spark plugs and found that they were fouled with carbon (likely from the earlier overly rich running when the injectors were clogged). After cleaning the plugs, the car started fine. However, it would only idle for 30–60 seconds before stalling, and while driving it would feel like a “fuel cut” after a few seconds - though it wouldn’t fully stall. Test 2 – Strainer swap Suspecting the diagonal strainer might not be reaching the tank bottom, I swapped it for the original flat strainer and filled the tank with ~45L of fuel. The issue persisted exactly the same. Test 3 – OEM injectors To eliminate tuning variables, I reinstalled the OEM 270cc injectors and reverted to the original map. Cleaned the spark plugs again just in-case. The stalling and “fuel cut” still remained.   At this stage, I suspect an intermittent power or connection fault at the fuel pump hanger, caused during the cleaning process. This has led me to look into getting Frenchy’s fuel hanger and replacing the unit entirely. TL;DR: Cleaned and restored the fuel system (tank, lines, rail, pump). Tested 550cc injectors with the same resized-injector map as before, but the car stalls at idle and experiences what feels like “fuel cut” after a few seconds of driving. Swapped back to OEM injectors with original map to rule out tuning, but the issue persists. Now suspecting an intermittent power or connection fault at the fuel pump hanger, possibly cause by the cleaning process.  
×
×
  • Create New...