Jump to content
SAU Community

Recommended Posts

  • Replies 92
  • Created
  • Last Reply

Top Posters In This Topic

I'm open to suggestions for other cars so bring 'em on. Been considering an R32 GTR as well. Any massive don'ts on a $15,000 GTR?

um yeah. don't buy a $15,000 GTR and expect it to be a 'cheap' car. I'd go as far to say don't buy a $15K GTR full stop. unless you really know GTRs or plan to build a race car etc.

and it won't be any torquier under 2,000rpm than your S14. in fact standard GTR is quite laggy. even stock the fun is not on till 4,500rpm or so.

stock for stock you wont notice the difference between vvti and non. many mons ago i raced a vvti with my non vvti and it was pretty much a dead heat (as it should be). remember even the non vvti starts boosting at 1.5k.

personally i think your better of with a clean optioned up 95 with a non vvti engine but all the late model perks (bigger brakes, recaros etc).

if you ever plan on going single then scrap the vvti completely as there is very little aftermarket knowledge and most end up turning it off. remember supras were designed for the US market and they have modified them for every concivable thing from road racing to 185mph texas mile 1200hp straight line fear. also the US didnt get the vvti model only JDM hence there is very little way of keeping vvti when modifying. it can be done but make sure you have very deep pockets.

either way you wont be dissapointed and when you have over 400rwkws without building the motor while remaining reliable enough for daily driving...you wont stop :D

kristian. you. me. kitchen. talk. now.

hahah

and yes it's true.. only knobs drive soarers.

in all honesty - you probably shouldn't have said you're "open to suggestion" to cars in a thread that i'm reading. because i'll talk the leg off a chair.

i'll keep my opinions simple for you.. and TRY not to bore you

i got my car yesterday by the way.. soarers were a popular import from the mid 1990's up through to about maybe 2005 then dropped off the radar really - mainly because as their value dwindled.. as did their target market.. the biggest problem with soarers is they are now usually seen blowing bright blue smoke out of their exhausts being driven by a somalian with a hat to the side playing 10 year old DMX music.

but - there ARE gems out there. what you're craving would be fixed by a VVT soarer (so i beleive)

first of all, read this paragraph:

The high-performance turbocharged version uses a 2.5 litre straight six (coded 1JZ-GTE). Early models are fitted with parallel twin turbochargers which give 206kW at 6200 rpm and 363Nm at 4800 rpm. Unfortunately, the TT engine is quite doughy at the bottom end of the rev range - the transmission’s torque converter needs to flare to get the engine revving (a trait that becomes tiresome, especially when a loud aftermarket exhaust is fitted). A 5-speed manual gearbox was fitted to a small number of examples.

that was penned by autospeed about 5 years ago.. then: read this article

http://autospeed.com/cms/title_The-Highest...57/article.html

to summarize - after mid 1996 the soarer went to a single turbo VVTi motor, torque was doubled.. and found at 2400RPM instead of 5000RPM

power was increased. fuel consumption was pretty much halved.

to summarize, the VVTi 1JZ has a HUGE difference.. the VVTi 2JZ not so much..

in addition to this the whole range got a facelift and certain "quivles" were fixed and revised.

priced for these vary like mental. i don't want to even tell you difference between the soarer i just bought my parents vs the soarer i just bought me.. but put it bluntly.. both my soarers were imported WELL under your budget.

and to summarize..

soarer - you get pretty much every luxury feature imaginable

here's what is sitting in my driveway now..

I think if 'coq' factor is a problem for you most imports aren't so great... I could live with a Soarer if it were great to drive. Still gonna aim for a Supra but if I can't muster any more funds soon it sounds like a good alternative.

Has anyone here driven a twin turbo Mitsubishi GTO? Might just be thinking out loud but I've seen late 90s models around the $15k mark before. I'd imagine they'd use a ton of fuel though being so heavy. And so complicated they might be hard to keep going.

Edit:

Not planning on modifying too heavily. It'll be a daily so will do a better but not too loud exhaust and maybe some minor stuff around the engine but not huge. I'd like to do some Tein EDFC in the future when finances permit.

Edited by Nissinja

Just want to add left field choice...

Mitsubishi GTO, Mates got one and it very decently equipped and goes well.

because your limited budget the mitsu might be worth it, but you can get 1997 - 1998 Mitsubishi GTO "updated headlights version" for around 18K in Australia. Also there are shops that will do work on them for reasonable dosh...

on another matter, you Got to be very patient when importing. my car is getting landed in Australia on the 19th Nov, then its waiting still for complance, though this is my second import, so i will

get used to the waiting by now ..oh... how wrong i was

^^^samesies.

i rage quitted after i joined their "cruise" and had a go at them all for dropping skids in front of kids on bikes. and one dipshit in a Z20 decided to try drift around a roundabout n ran into a gutter.

i said to them be careful on cruises last thing we need is attention from police.

that was like throwing a rock at a beehive.

soarer drivers are knuckle dragging mouth breathers. just sayin.

Aside from the atypical owner, Soarers are very good value for what you get. Very capable all rounders (performance-luxury-looks-reliability-cost) and one of the few Jap cars where you won't be cursing the Japanese tradition of designing a car's backseat for kids that never grow up.

^^^ +1

but the conclusion that i've come to notice is - there is a massive soarer revival trend occuring.. but it's quiet and small..

even my broker said yesterday on the phone that when he had the car in his shop, people's jaws would drop and they couldn't beleive that it was a soarer of all things

infact yesterday i was out front and this guy in a van stopped outside my house with his family and started telling me how much he absolutely LOVES our soarers and how he's always been into imports ever since we've had "the orange" 180 parked outside ten years ago..

he said he just bought an aristo a few months back from Jspec but said that if he had've known soarers could be like that then he would've got one - true story.

but anyway.. conclusion i've come to is - if people like soarers, great.. if they think they are boats and dirty old ho-hum imports then that's their opinion.. i'll just wind up my electric seats tilt my electric sunroof and drive away smiling while they sit there and curse their broken silvia :D

only a late model V8. :D

actually there's this one for sale - UZZ32 active with 106xxx genuine km.. only mods are - brand new headlights and tail lights from toyota... and a 97 body conversion

for those of you unfamiliar with soarers, the UZZ32 is the rarest of the build codes, only a run of about 700 odd i beleive. toyota were losing money on each one sold apparently.. active suspesnion, 4 wheel steering, reverse cameras.. these guys had it all!!!

IMGP3191.JPG

IMGP3197.JPG

IMGP3199.JPG

IMGP3205.JPG

IMGP3211.JPG

Edited by Mr Eps

few moar pix in case you don't beleive it's condition:

IMGP3226.JPG

IMGP3227.JPG

IMGP3228.JPG

IMGP3232.JPG

IMGP3235.JPG

IMGP3237.JPG

sorry to go off topic from supras - i'm just mkaing the point that soarer are definitely the underdog - not all soarers are driven by some 17 year old somalian kid wearing RuffRyder clothing.

^I prefer a LS400/Celsior over a soarer. More usability.

BTW V8 as a daily isn't as stupid as you think... Get a LS400 - built like tanks, srsly. Dad had someone rear end him between 80-100kmh and he was stationary, and he didnt even get whiplash... (206 GTI hit him)=, they wrote it off from a financial point of view cause the car is worth so little and the panels were pushed a few mm at each back door)

So impressed, bought another one. Last tank, did 11.2L/100km around town. <Paid $7800 for a 1998 LS400 from the UK (minimal rust, mostly on exhaust mufflers) - 131k miles, engine is so quiet, just the other day at the fuel station, he turned it on, put seatbelt on, then tried to turn it on again....

Edited by Ten Four
lol let me guess. dark green 1992 V8 that's got three oem wheels and one wheel that has an inexplicable hubcap?

lol nah, its a silver V8 uzz30 with EMV and speedy mesh wheels lol 91 or 92 model.

does look nice i'll admit but typical soarer owner lol.

There are plenty of those around Canberra though, Dark green or dark blue UZZ30s with bald tyres, broken exhaust hangers cracked front bars.

Oh PS how much for that UZZ32?

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • That was the first session so not a lot to take from the day. It was low 20s ambient and the coolant had got to 110 (and obviously had some pressure!) so that still needs to be addressed. I haven't downloaded the data yet but will. I had refilled the auto trans with Redline DT6 because it claimed the best viscosity I could find at 100o. It wasn't really long enough to get a good feel for that; while the trans got to 100o in the session it still wasn't shifting crisply as I hoped. I think I'll try a few more sessions before judging. No steering motor overheat but I'd hope not in only 1 session! But finally the suspension; it was night and day over the standard stuff and the car was a couple of seconds quicker on the same crappy tyres, which is a huge difference. I'll stick with that and get some sway bars and a mechanical diff sorted too and see how that all goes together
    • I guess it’s partially a compromise of how my car is used, wanting to be able to switch from drift to grip with track side on-car adjustment. Also partially with the way the knuckles are set there is more static camber but less dynamic camber gain. 
    • OK, so update from the track day on Friday It was a classic "an unfortunate series of events'. There were a few cars around and when i checked my mirror coming out of the fish hook I notice some smoke from the rear of mine. Looked again and it was getting much worse, I figured I'd blown a turbo or something to got off it and pulled off the racing line. However.... since it is a left hairpin into a right kink, I was on the inside of the next corner. There was a car passing me on the left and a big drop off over the ripple strip on the right......and someone had knocked the witch's hat that was on the apex about 1m onto the track. So, between those 3, I decided to mow down the cone and not damage my car/the other car. Right choice, but surprising result.  The car decided the cone was a small pedestrian so it blew the rear bonnet hinges up to protect their head in the upcoming person to car impact....I didn't see that coming and like an airbag deployment it happened super fast. Straight into the pits from there, everything was driving fine but it became clear it was a coolant leak not smoke, it was billowing up onto the windscreen. Onto the trailer and home. I'll do a separate thread about the repair (once I work out what it is ), but the immediate problem was the bonnet wouldn't open because the front was pinched onto the front bar and would not release. Ultimately we unbolted the hinge from the bonnet, pulled it back a little and it released from the front OK. "There's your problem", the top radiator hose had popped off at the radiator.
    • Yeah that looks like great caster, but I'd suggest trying less front camber some time and seeing if it helps with braking without reducing mid corner speed too much
    • I ended up setting the rear 5mm higher than normal to give some clearance.  My plan is to run the least camber I can in the rear which I think with the extra width is going to need to be -1.75 to -2.00° just to get clearance.  Guards have been rolled and pulled as much as they can/I would be wanting to.  front has the Acostal knuckle with the KPI change and the drop etc. So should be okay with the existing settings I have run with AR1s etc Front: Toe total -2mm(1mm out each side) Caster +7.5° Camber -3.8° Ackerman +15°
×
×
  • Create New...