Jump to content
SAU Community

Recommended Posts

Hey guys,

Recently my 33 gts-t has developed the following problem in which I will attempt to describe. After driving slightly intense (4500rpm+) the following symptoms develop:

- In idle , revs start to drop to and fluctuate between 100 - 1500rpm, causing the feel of stalling.

- At the same time, the boost gauge fluctuates and shows a reading of 0 to -10psi (normally it sits at -20psi in idle).

- After about 1 - 2 mins, it seems to fix itself and idles normally. Occasionally the car will stall.

I have also tried driving while this is happening and discovered that the car boosts fine in 1st gear. However in 2nd and 3rd, the car would feel very sluggish and boost would rise very very slowly from 3psi or so. At times the car experiences extreme jerkiness, feels almost like boost has suddenly kicked in the out again.

The mods on my car include: 3.5inch Cat-back exhaust; Turbosmart boost tee (not secured to anything, only thing holding it are the vacuum tubes.. not very smart).

After searching the SAU forums, I am guessing either the (1) AFM is knackered; (2) Boost Tee is stuffed/leaking; (3) Air leak between throttle body and AFM; (4) Leak somewhere between intake and turbo.

I'd really appreciate some help - What do you guys reckon is most likely causing the problem? I'd like to self diagnose/fix before taking it to a mechie.

Link to comment
https://www.sau.com.au/forums/topic/342257-afmvacuum-leakbleed-valve-issues/
Share on other sites

Clean your AAC valve

Or are you using at vent-to-atmosphere blow off valve?

^+1

Otherwise maybe something to do with the cam timing as you said it occurs once you take the car above 4500 rpm?

Cheers for the replies.. went for another drive today. Car runs normal most of the time, but the problem did occur again - this time as soon as I started the engine back from lunch after driving for about 30 mins. Seems to happen when car is warm..

No, I have the stock plumb back bov. I was also thinking could be aac valve.. although this happened suddenly last week and not gradually over a few months as you would expect from carbon buildup?

I was hope this has nothing to do with the engine but cam timing is possible, in which case it will be a bitch to fix.

The problem occurs only sometimes and not all the time, so if it was a constant boost leak then it would make sense for this to happen all the time?

And Thomas fyi you can test vacuum leak with a air compressor - connecting it to the turbo outlet and blocking off the pipes leading to the throttle body. saw it on mightycarmods a while back.

Anyone else think its a fuel rather than an air problem (or vice versa)? If it's a fuel issue then why does the boost gague going nuts? (sorry not trying to be an arsehole here, just trying to understand the issues.)

Any thoughts appreciated, cheers.

LOL seem be happining to every one these days mate im in the same boat pritty much

iv tried fuel filter, fuel regulator, coil packs, ignitor, plugs, AFM been cleaned

my fuel pump is in good nick so i dont think its that

tomorrow im gone try leak down test, comp test, o2 sensers and coil pack loom

then monday injectors cleaned prob

so if i get a mirical ill let u know bud

Check the intake pipe going from the AFM to the side of the turbo. They can wriggle off abit being a little loose and can suck air in making the car unable to idle properly and rev correctly.

While wriggling the pipe to check, you may need a torch to see if it has come off from the turbo. Its just a thought to check out.

Yeh alex, its such a shit feeling when your car is sick, but can't figure out where the problem is.

Took it for another drive, realised when I rev it hard is when the problem starts, which got me thinking fuel pump. But then again you have the same issue and your fuel system is working fine =S ..Am going to mates place and taking apart the front end to check the piping thoroughly and see how I go. I'll post up my findings later tonight haha.

Also keep us posted if some miracle does happen :D

Update:

- checked all the intake piping - poured water onto each joint and listening for drops in idle.. nothing. All hoses seems to be intact. So unlikely problem is vaccum leak.

- did some research on fuel pumps - apparently there's no such thing as a fuel pump that's about to die. They either work or they dont. So fuel pump is also unlikely to be the problem.

- took out the AFM and gave it a good clean with carby cleaner. After the clean car runs alot smoother, but the initial problem still exists.

Will give the Aac valve a good clean next wkend and post my findings.

Update:

- checked all the intake piping - poured water onto each joint and listening for drops in idle.. nothing. All hoses seems to be intact. So unlikely problem is vaccum leak.

- did some research on fuel pumps - apparently there's no such thing as a fuel pump that's about to die. They either work or they dont. So fuel pump is also unlikely to be the problem.

- took out the AFM and gave it a good clean with carby cleaner. After the clean car runs alot smoother, but the initial problem still exists.

Will give the Aac valve a good clean next wkend and post my findings.

Fuel pumps can start dying giving up all kinds of funny symptoms. Had a VS commo with a fuel sock so clogged with crap, that the car would idle and run OK, generally drive well, but too much throttle and it'd miss and fart and carry on, and occasionally stall, fuel pressure gauge showed the pressure being a maximum of half it's usual, and revving the engine didn't give a nice peaky response, the fuel pressure would slowly drop off and rise.

yeah fuel pumps can slowly die. they either get the sock a bit blocked or are worn inside and don't have the same maximum flow as they should. i've seen cars on the dyno where the fuel pump has been dying and the AFRs are fine until about 2/3 of the way through the rev range where they start to lean out and the further up the rev range you go the leaner it gets. put a new fuel pump in and it's all good again.

  • 8 months later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • You just need to remove the compressor housing, not the entire turbo. I would not be drilling and tapping anything with the housing still on anyways. 
    • So, I put my boat on a boat. First of all, I'm going to come out and say it. Why is Tasmania not considered a holy goal, an apex that all road-legal modified cars go to, to experience? This place is an absolute wonderland of titanic proportions. If people are already getting club runs for once in a lifetime 30 person cruises to Tassy then I've never seemed to see it. It is like someone replaced the entire place with an idyllic wonderland for cars, and all of the people living there with paid actors who are kind, humble, and friendly. Dear god. After doing a lap of almost all of the place I've found that it's a great way to find out all of the little things that the car isn't doing quite right and a great way to figure it all out. All in all, I drove for 4 hours a day for a week and nothing broke. I didn't even need to open the engine bay. This is by all means a great success, but it has left me with a list of things to potentially address. I also now have a 3D printed wheel fitment tool which annoyingly hasn't got any threads in it to actually assemble it. I might be able to tape it together to check the sizing I actually want to use, but it'll likely involving pulling the shocks out to properly measure travel at least at the front, and probably raise the car while I'm at it, at least in the rear. I scraped on quite a few things and I'm not sure how else to go about it. I was taking anything with a bump at what felt like 89 degree angles. And address those 10 other tasks. And wash the car. God damn it is dirty. And somehow, the weather was perfect the entire time - And because I was on the top of Mt Wellington it turns out it was very much about to freeze up there. I did something I typically never do and took some photos up there in what must have been -10 and the foggy felt like suspended ice, rather than mere fog. If you own a car in Australia, you owe it to yourself to do it.
    • Damn that was hilarious, and a bit embarrassing for skylines in general 😂 vintage car life ey. That R33 really stomped. Pretty entertaining stuff
    • Hi, I have a r32 gtr transmission. Does any of you guys have an idea how much power it will hold with the billet center plate and stock gearset? At what power level and use did yours brake with or without billet plate? Thanks, Oystein Lovik
    • Saw this replica police car based on a Mitsubishi Starion XX parked next to a 'police box' (it's literally a box) in Hirohata, Himeji City in Hyogo prefecture the other day. It's owned by Morii-san who is a local Mitsubishi Starion enthusiast. According to a local radio station blog post, he always wanted to make a police car himself based on ones he saw in his favourite Manga comics.  As it's illegal to modify a car to look like a police car and drive on the road, Morii-san tried many times to get permission from Aboshi police station headquarters nearby. They refused initially by after they got tired of that they granted him permission. However, the car can only be displayed on private property and obviously can't be registered as long as the police livery is present. The car was completed at a cost of 1.5 million yen (US$ 10,000) in addition to the car cost. A location was chosen outside Hirohata Police box where the car can easily been seen from the street. Morii-san has two other Starion road cars, both widebody GSR-VRs.
×
×
  • Create New...