Jump to content
SAU Community

Recommended Posts

  • Replies 62.7k
  • Created
  • Last Reply

Top Posters In This Topic

  • chaos

    7164

  • Ska

    5791

  • BelGarion

    3645

  • Nexus9

    3590

Top Posters In This Topic

hello anyway....hows your day?

check out one of the foto's i took at the spit on sunday just before i saw you..its in the comp art forum under whadya reckon......got a fine for undue noise when i left there too :(

not a skid....just when i cruised nice and slow past those silvias at the other end i slipped it into neutral gave it a small brap brap type tap on the throttle and slipped it back into gear....no wheel spin no nothing just a rev and continued on my way just sayin hey look ive got a v8 in this skyline...

the dumb ass copper said to me "is this car modified?" and when i said yes he asked to look under the bonnet...when i opened it up he looked at it blankly for a minute or so before saying,"what has been modified?" stupid bugger....then he asked after he looked under the back,"is this a SSS?" FOOL!

cost me 240 bucks, too ....but no points

the dumb ass copper said to me "is this car modified?" and when i said yes he asked to look under the bonnet...when i opened it up he looked at it blankly for a minute or so before saying,"what has been modified?" stupid bugger....then he asked after he looked under the back,"is this a SSS?" FOOL!

:(

There sooo dumb it's not funny...

Does it have Holden rocker covers? Cause that would be even funnier ;)

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • Yeh I think i'll message an old contact i had for ages that manages his own tyre shop now.. n tell him what i want n work with him before ordering..  Got this 17x9 +30 Driftteks on 245/45/17 PSR Drag Radials on the rear.. They fit well - for your reference in future - Rear guards  have been lipped in & minimal to non flaring of the rear Gaurds.    
    • If only it were that easy! I also needed to remove seats, shocks, brake calipers, send my car through a fence, and use measuring and ended up guessing because I didn't remove seats, shocks and brake calipers. It can be hard sometimes Can be a little more complex than 'just measure' if you want to truly measure the entire wheel through all of it's suspension travel. But if you aren't going for every last mm then yeah, you can check the space you currently have and guesstimate.
    • If you own a car, and it has wheels on it, and you know the offset of those wheels, and you have a measuring device, you have everything you need to work out if other wheels will fit.
    • Will this fit? but they are staggered set - RAYS 57DR SEMI GLOSS BLACK 18x8.5 +37 | 18x9.5 +38 5-114.3 STAGGERED SET   or If no go could just get a set 4's wheels of 18x8.5 +37 5-114.3 - would i run 8.5's 235s up front n 245's at the back if I do?   Thanks.        
    • Put a clamp on your return line. I have a feeling it's sucking air, and introducing bubbles to your fuel. With a lot of fuel, less problematic. I'd honestly be redoing all the lines in the tank and clamps on everything.   Also, you've given two different answers to the same question: Asked if being followed by the police you could get down to use the whole tank, you said yes you could, so long as you keep off boost. However, you then followed this up that free revving, it would also cause the issues. I'm doubting free revving is enough to make any noticeable boost on what is likely a decent sized turbo.   So now I have to ask, can you actually drive it lightly and use all the fuel, or does it break up even free revving? Also, have you put a fuel pressure gauge on it? Can you hear the pump change noise at all when you're having this issue?
×
×
  • Create New...