Jump to content
SAU Community

Recommended Posts

  • Replies 62.7k
  • Created
  • Last Reply

Top Posters In This Topic

  • chaos

    7164

  • Ska

    5791

  • BelGarion

    3645

  • Nexus9

    3590

Top Posters In This Topic

I met up with Cyrus and Jaqule and travelled as far as BP Yatala with them.

I think I managed to make a speed camera go off, but I was right next to a 4WD at the time so it will be too close for them and Cyrus was only a car length behind me in the other lane, so not too worried

other than that Ska's car is very slow :(

lol I wil sell it to you for $1090.... thats a $5 saving over buying one yourself :(

You still keen?

WTF I am doing this as a favour for you

I don't want your cheap imitation Carbon Fibre bonnet, I just don't want to see get in trouble Matt

I would expect at least a $10 discount :D

i wasnt serious about the contact :(

theres a place in brissy that does awesome looking fake carbon fibre but its not cheap $$$$

heres a pic http://www.modicoat.com/id46.htm

You cant tell its fake, the fibres look different to that...

I was studying mine the other day... It looks different fron different angles...

YAY CARBON FIBRE!!

as I have stated a number of times on this forum........derrrrrr....I'm not too bright....

I was just informed that MSCII starts at ~7PM....not 7AM......In which case......I CAN COME.... :headbang: Yessssss!!!

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • Totally equivalent. Stock often goes from the comp cover because that's where the actuator is also installed and the factory needs 2" of hose to make the connection - and it comes as a pre-assembled unit. They totally have a boost reference from somewhere between the turbo and the throttle(s). Oh, jeez. Just do it in M12 then. We don't actually care that much. I would expect any such AN converter fitting to rely on an o-ring or some other seal onto a flat surface under the flange of the hex**, because bolt threads are no intended to provide a pressure seal. unlike..... pipe threads. **which also requires a suitably flat and smooth surface on the turbo's boss to provide the seal.
    • I also used NP   That’s were it’s seems to be the best place to fit it? All schematic shows also that it’s should be referenced from the turbo housing. But idk, I do see high hp cars without any connection or anything to their turbos, so I really don’t know how they connect their things
    • I do have loctite 243 and 246 and a few more models. I could drill it now in place and make new threads for m12 and order an4 - m12 coupling and fit that to the turbo. Run a braided hose to the EBC which I could get a an4 to 1/8npt 
    • So M12 and sealant should be fine?    NPT ” because that’s what I had and what I could get atm. 
    • Wouldn’t touch par if they gave it to me. You need to ask how much power you’re looking to make and then add about 50% to it because that’s what you’ll end up making  The factory box says no more at about 350kw or so, the upgraded synchro boxes won’t handle much over 500kw for long and at that point you’re looking at an auto or dog engagement manual,  once you’ve gone dog engagement you may as well go sequential, they cost a little bit more but it’s worth it  also while you’re at it you should upgrade the transfer case with 10 friction plates 
×
×
  • Create New...