Jump to content
SAU Community

Recommended Posts

  • Replies 62.7k
  • Created
  • Last Reply

Top Posters In This Topic

  • chaos

    7164

  • Ska

    5791

  • BelGarion

    3645

  • Nexus9

    3590

Top Posters In This Topic

Hey Erin,

I am a little dissapointed with Mr G Woods at the moment. Spent 4 hrs today re-routing the oil line to my oil cooler, putting the Type R BOV on properly, modifying one of the brackets and refitting the inner guard only to find it has been butchered and I am going to have to source another. Not too happy. $550 in labour and I have to go and fix it all up and source replacement bits. And he had the car 2 days longer than what was originaily agreed to.

Jason, I'd suggest you ring him and make him aware of these faults.

He's not going to know (or the boys) unless people ring him to make him aware of it. He doesn't normally sit here and read the wasteland so saying something in here isn't going to make him aware of the situation.

Yet another unhappy customer. This aint good Gav.

I honestly think he is just taking on too much work, everything sounded too hard and too much trouble. When I booked the car in I just said whenever you are free next no rush, and yet they were complaining about being soo busy. He will end up losing alot of custom by trying to do too much, better off turning people away if you don't have the resources.

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • Yep, the closest base tune available was for the GTT, I went with that and made all the logical changes I could find to convert it to Naturally Aspirated. It will rev fine in Neutral to redline but it will be cutting nearly 50% fuel the whole way.  If I let it tune the fuel map to start with that much less fuel it wont run right and has a hard time applying corrections.  These 50% cuts are with a fuel map already about half of what the GTT tune had.  I was having a whole lot of bogging when applying any throttle but seem to have fixed that for no load situations with very aggressive transient throttle settings. I made the corrections to my injectors with data I found for them online, FBCJC100 flowing 306cc.  I'll have to look to see if I can find the Cam section. I have the Bosch 4.9 from Haltech. My manifold pressure when watching it live is always in -5.9 psi/inHg
    • Hi My Tokico BM50 Brake master cylinder has a leak from the hole between the two outlets (M10x1) for brake pipes, I have attached a photo. Can anyone tell me what that hole is and what has failed to allow brake fluid to escape from it, I have looked on line and asked questions on UK forums but can not find the answer, if anyone can enlighten me I would be most grateful.
    • It will be a software setting. I don't believe many on here ever used AEM. And they're now a discontinued product,that's really hard to find any easy answers on. If it were Link or Haltech, someone would be able to just send you a ECU file though.
    • Yes sir am asking is there possible way from aem tuner from wiring pins 
    • Have you checked cam to crank timing and confirmed balancer marks are correct?
×
×
  • Create New...