Jump to content
SAU Community

Recommended Posts

post-62518-0-35459300-1295664579_thumb.jpg

expressions of interest at the moment.

have my daily drive 92 r32 gtst 2dr that i am thinking of parting with, either whole, swaps or parts. dont know yet. lol

5sp rb20det with original hicas and is abs optioned, though atm its disabled.

approx. 175k on the clock (120k engine put in at 151k) and gearbox replaced bout 5-10k ago

had gates timing belt and rear main seals done before replacement engine installed.

stock clutch pressure plate reworked to heavy duty

r33 gtst rims with goodyear f1's on but both front ones need replacing due to too much camber, RHR rim has flatspot. changing on some 2nd hand tyres on tuesday

bonnet needs sanding and respraying

has front mount intercooler

stock suspension, think one rear one is leaking, front and rear strut bars.

gtr steering wheel thats worn around the outside

interior trims fair condition. door trimming need to be glued back on, speaker covers wont stay on, rear quarter glass trimming coming off.

hood lining good

rear seats in good condition

drivers seat worn through on outside edge, passanger side good

the car is registered atm and can be driven no problems.

am interested in trades, swaps, offers, whatever. just send me a pm with what u got and i'll get back to u

a clean r31 manual would be nice. let me know

additional pics are available and will be sent if interested

as i said before EOI at the moment but if the offer is good it can be yours

Located at morayfield, qld. bout 40 mins north of brisbane city.

Link to comment
https://www.sau.com.au/forums/topic/351316-eoi-r32-gtst/
Share on other sites

anyone interested?

interested in swaps for - r31 skyline

- motorbike / motocross

- anything interesting (let me know what u got)

Edited by R31 To R32
Link to comment
https://www.sau.com.au/forums/topic/351316-eoi-r32-gtst/#findComment-5647488
Share on other sites



  • Similar Content

  • Latest Posts

    • Bah! I can't see the point in custom number plates at all. I went to the rego office, fished through a box of "premium" plates (the ones that had the "not as tall" option for the front plate) and picked the one that had a 32 in it. That's the limit of the effort and cost I will put into number plates. The only plate that I'd consider paying for would be 2332, but that's not possible here because it already exists from probably 90 years ago, and it would cost a fortune to obtain it, if it were available.
    • After chasing my tail with LS results..... and cheaper than a turbo swap... How confident are you that the dyno is accurate relative to other results? How fast is the car - What MPH does it actually run? Is this similar to what people running this power would expect?
    • Hi mate I am having an identical issue with my 98 R34 GTT. The engie suddenly cuts out under load at about 3-4k, black smoke out exhaust. Almost feels like traction control kicking in. No CEL but still going to check codes later today. Car was sitting in the shed for about 5 months before hand and only idled a few times, took her out with about 1/4 tank, filled up and thats when the issues started happening.  Threw on a spare set of coils/harness and checked plugs which was no help. Recently had fuel pump/filter changed so surely thats not the issue unless condensation in fuel, I just havent had the time to drain it It's running a hi flow turbo, bosch 1000cc injectors, walbro 450L, Z32, Nistune etc... All about 2000km old.
    • I always wonder where the obsession with legal/illegal spacing on number plates in the UK comes from. Because it comes up in comments in every UK-based video I see on youtube. From my point of view all of your plates look a bit odd. Just because there are no markings whatsoever. In Australia we have the state that has to be on it. In Europe you get stamps and state logos. Yours look a bit like a throwaway draft that people then stuck with. And attached with blu tack so that it falls off at the slightest disturbance. Not trying to hate, but it's interesting how things are done in different countries. Do you have to follow a lettering convention when choosing a custom plate?
    • Hybrid sounds like a supercharger... It's half a turbo, with a belt to drive it! Oh wait, they're just called super chargers...
×
×
  • Create New...