Jump to content
SAU Community

Recommended Posts

Hey guys,

I recently picked up a 5 spd manual 240K Sedan with the intention of having as my weekender car and fixing up here and there.

Unfortunately my V35 Sedan's radio died and now it needs replacing, (Approx. $1300).

So with financial constraints I'm forced to put the dream on hold for a little while and put the 240K up for sale.

The car set me back $2000 and if it means going to someone that'll look after it and restore it I'd be happy selling it for what it cost me.

Good clean, mechanically sound car.

Registered

Low kms (153k genuine kms)

Log book, original purchase reciept, nissan workshop manual

Interior has been covered from birth with wool seat covers (Can be supplied if you really want:)

Dash and doors been regularly coated with protectant

Here's some pics... More to follow.

post-7699-0-69181800-1302175264_thumb.jpg

post-7699-0-08703600-1302175275_thumb.jpg

post-7699-0-94695900-1302175281_thumb.jpg

Car is in Adelaide.

041 393 1027 - Marcus.

Link to comment
https://www.sau.com.au/forums/topic/360170-fs-240k-77-sedan/
Share on other sites

PM this guy , Chris Rogers He does lots of custom work on V series Skylines thinks like aftermarket cruise control that uses the factory buttons and that kind of thing, he can probably sort yours out.

cheers

Jason

PM this guy , Chris Rogers He does lots of custom work on V series Skylines thinks like aftermarket cruise control that uses the factory buttons and that kind of thing, he can probably sort yours out.

cheers

Jason

Yeah, he's got the stereo at the moment.

That is who quoted $1300 :) CD Changer stripped a gear .. or ten.

So it's either replacement unit or iPod in.

I'd rather the full replacement for resale value.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Yeah well per the video it took 15s for the stock unit to start up....even if I give it a few seconds discount for starting that is at least 12 sec before you get a reverse camera if you are trying to leave a park.  The android unit is way faster, but 2016 for the stock unit is a long time ago in consumer electronics
    • Yea that’s why I said ima test them with multimeter and see the reads.
    • Only at idle. Isn’t a problem when rev it seems.
    • @Haggerty This seems silly to ask, but are you confident in your ability to tune the Haltech?  
    • Next on the to-do list was an oil and filter change. Nothing exciting to add here except the oil filter is in a really stupid place (facing the engine mount/subframe/steering rack). GReddy do a relocation kit which puts it towards the gearbox, I would have preferred towards the front but there's obviously a lot more stuff there. Something I'll have to look at for the next service perhaps. First time using Valvoline oil, although I can't see it being any different to most other brands Nice... The oil filter location... At least the subframe wont rust any time soon I picked up a genuine fuel filter, this is part of the fuel pump assembly inside the fuel tank. Access can be found underneath the rear seat, you'll see this triangular cover Remove the 3x plastic 10mm nuts and lift the cover up, pushing the rubber grommet through The yellow fuel line clips push out in opposite directions, remove these completely. The two moulded fuel lines can now pull upwards to disconnect, along with the wire electrical plug. There's 8x 8mm bolts that secure the black retaining ring. The fuel pump assembly is now ready to lift out. Be mindful of the fuel hose on the side, the hose clamp on mine was catching the hose preventing it from lifting up The fuel pump/filter has an upper and lower section held on by 4 pressure clips. These did take a little bit of force, it sounded like the plastic tabs were going to break but they didn't (don't worry!) The lower section helps mount the fuel pump, there's a circular rubber gasket/grommet/seal thing on the bottom where the sock is. Undo the hose clip on the short fuel hose on the side to disconnect it from the 3 way distribution pipe to be able to lift the upper half away. Don't forget to unplug the fuel pump too! There's a few rubber O rings that will need transferring to the new filter housing, I show these in the video at the bottom of this write up. Reassembly is the reverse Here's a photo of the new filter installed, you'll be able to see where the tabs are more clearing against the yellow OEM plastic Once the assembly is re-installed, I turned the engine over a few times to help build up fuel pressure. I did panic when the car stopped turning over but I could hear the fuel pump making a noise. It eventually started and has been fine since. Found my 'lucky' coin underneath the rear seat too The Youtube video can be seen here: https://www.youtube.com/watch?v=uLJ65pmQt44&t=6s
×
×
  • Create New...